A turbine designed for an output of 100 MW receives superheated steam with the following conditions; h1 = 3550 kJ/kg, v1 = 40 m/s, h2 = 1356 kJ/kg, v2= 125 m/s. Assume no heat loss, determine the desired mass flow rate of the steam (kg/s).

Q: Steam enters a well-insulated turbine at 4.0 MPa and T1°C with a velocity of 100 m/s. At the exit,…

A:

Q: Q3:In a gas turbine unit, the gases flow through the turbine and the power developed by the turbine…

A:

Q: The adiabatic compressor shown in the figure operates steadily using Hydrogen with the following…

A: Write the given information.

Q: Q5: A-Steam enters a turbine with a velocity of 50m/s and specific enthalpy 2690 kJ/kg . the steam…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: (Q2) Consider a two-stages steam turbine, as shown in the figure, with an inlet state 12.5 MPa and…

A:

Q: Q1: Steam at 10 MPa and 530 °C, 70 m/s, at inlet a turbine and leaves at 12 kPa with a quality of…

A:

Q: A centrifugal compressor pumps 45.3 kg / m * i * n of air at 101.32kPa and .6 degrees * C to 345 kPa…

A: given data; ⇒mass of air (m)=45.3kg/min                       =0.755kg/s⇒inlet…

Q: A 0.20 kg/š óf áir are compressed isothermally from P,= 100 kPa and V,= 0.15 m3/s to P,= 700 kPa.…

A:

Q: ir flows steadily through an engine at constant temperature 400 K.Find the work per kilogram if the…

A: Air flows steadily through an engine at constant temperature 400 K.Find the work per kilogram if…

Q: A piston/cylinder system compresses saturated water vapor at 500 kPa to 2500 kPa, V₂=v₁/3 The system…

A: The initial pressure is The final pressure is The initial state is saturated vaporThe final volume…

Q: Steam turbine P: Steam enters a well-insulated turbine at 2.0 MPa and Tg °C with a velocity of 60…

A:

Q: Q2: 26 tons of ice from and at 0°C is produced per day in an ammonia refrigerator. The temperature…

A:

Q: A new adiabatic gas turbine is said to do the following: If the air enters the turbine at 1100 C and…

A:

Q: Ten lbm per min of fluid is handled in a reversible steady flow manner by a thermodynamic system…

A:

Q: A perfect gas nas and pressure 0.8 bar and volume

A: Change in entropy: Entropy is the ratio of heat transfer (Q) to temperature (T). According to second…

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg. the steam…

A:

Q: Refrigerant-134a enters the compressor of a residential heat pump at 140 kPa at a rate of 216 kg/h…

A:

Q: Ten lbm per min of fluid is handled in a reversible steady flow manner by a thermodynamic system…

A: The given values are -m=10 lbm, ∆h=175 ft , g=32 fts2The potential energy change is given as…

Q: Q1: Steam at 10 MPa and 530 °C, 70 m/s, at inlet a turbine and leaves at 12 kPa with a quality of 16…

A: Given Data State 1:10 MPa,730°C,70 m/s State 2:12 kPa,16% quality,40 m/s q=-1.6 kJ/kg P=5 MW

Q: A turbine designed for an output of 100 MW receives superheated steam with the following conditions;…

A:

Q: An electric resistance heater submerged in 4-kg water (T, = 20 °C, C, = 4.18 kJ/kg.K) is turned on…

A: The correct answer is 1.526 kJ/K

Q: Final temperature of gas. 2. Power required

A:

Q: A single stage air compressor handles of atmospheric pressure air and delivers it to a receiver at…

A: Given, Initial pressure = P1 = Atmoshpheric pressure = 101.325 kPa Final pressure = P2 = 652.75 kPa…

Q: Air enters a continuous flow compressor at a temperature of 23°C and a pressure of 100 kPa and is…

A:

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: a tank of volume 1m3 initially contains steam at 60 bar 320 degrees celsius . stream is stream…

A: Now here the given data as below: Tank volume v = 1 m3 Initial Pressure P1 = 60 bar Initial…

Q: In a steady flow apparatus, a fluid enters with a specific volume of 0.30 m3/kg, a pressure of 540…

A: Given data: v1=0.3 m3/kgP1=540 kPac1=25 m/sz1=40 mv2=0.82 m3/kgP2=100 kPac2=280 m/sW=140 kJ/kgQ=−12…

Q: If you had an uninsulated air compressor which required W(in)= 400 kW to take air from a state at 80…

A: Given data as per the question W(in)= 400 kW Initial pressure =80 kpa Initial temperature =200 c…

Q: steam is supplied to a fully loaded 100-hp turbine at 200 psia with u1 = 1163.3 btu/lb, v1 = 2.65…

A: The given information in the problem is represented in the following attached image:

Q: A boiler takes in feed water at 70 °C and generates steam at a pressure of 10 bar and dryness…

A:

Q: the compressor and expander have to be assumed to have an actual efficiency that is less than ideal.…

A: Given data: ηC=78%ηE=82% Need to determine the efficiency of the system.

Q: Q1/A Steam turbine run with steam inters (30 bar 400°C to 4 bar) and then expanded isentropically.…

A: Given Data State 1: 30 bar,400°C Isentropic Expansion State 2: 4 bar

Q: Water vapor enters a turbine with a mass flow of 2kg / h, 6 MPa pressure, 500 ° C temperature and 40…

A:

Q: Steam at 3.5 MPa and 400°C enters an adiabatic turbine with a volume flow rate of 5 m /s. An…

A: Given: P1=3.5MPa & T1=400°C Q=5m3/s P2=500KPa & T2=250°C P3=100kPa

Q: H.W2: Helium is to be compressed from 120 kPa and 310 K to 700 kPa and 430 K. A heat loss of 20…

A:

Q: Steam at 20 MPa and 620°C enters a steam turbine and expands to a condenser pressure of 100 kPa. An…

A:

Q: Find the magnitude of the work for the process

A: Given data; An ideal gas undrgoes a reversible process in whic h the pressure varies linearly with…

Q: A turbo-Compressor takes 9691b/ min mass of refrigerant gas for Air-conditioning unit at atmospheric…

A:

Q: water at 100 kPa, 30 °C, enters a pump with a flow rate (m) of 18 kg/s with a velocity of 2 m/s. At…

A:

Q: Air with a volumetric flow rate of 0.3364 m3/s is compressed from 100 kPa pressure and 20 °C to 800…

A:

Q: 200Kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits at…

A: