A new adiabatic gas turbine is said to do the following: If the air enters the turbine at 1100 C and 6.5 Mpa It would leave at atmospheric pressure ( P = 100 kPa) and T = 100 C. Producing a power of W = 1109 kJ/kg. Is this possible? Turbina = turbine

A new adiabatic gas turbine is said to do the following: If the air enters the turbine at 1100 C and 6.5 Mpa It would leave at atmospheric pressure ( P = 100 kPa) and T = 100 C. Producing a power of W = 1109 kJ/kg. Is this possible? Turbina = turbine

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A dry-steam well is characterized by a closed-in pressure of P1 2500 kPa and saturated vapor. The…

Q: The adiabatic compressor shown in the figure operates steadily using Hydrogen with the following…

A: Write the given information.

Q: The working substance for a Carnot cycle is 8 Ib of air. The volume at the beginning of isothermal…

A: Dear Student, As per the Bartleby answering guidelines we are supposed to answer first 3 subparts.…

Q: the power output (W out.) in (MW) is Adiabatic steam turbine has inlet of 6 kg/s at 5 MPa, 600 oC.…

A: Given that: P1 = 5 MPa, T1 = 600 oC Mass flow rate of steam is 6 kg/s P2 = 100 kPa, x = 100 % It is…

Q: A Carnot cycle operating on 2kg of methane, have the following properties given at the beginning of…

Q: Four pounds of air gain 0.491 BTU/ °R of entropy during a non-flow isothermal process. If p: = 120…

A: Using entropy expression of closed system to solve the problem

Q: Q2: 26 tons of ice from and at 0°C is produced per day in an ammonia refrigerator. The temperature…

Q: Air at a 800 kPa and 1300 K enters an adiabatic and reversible turbine with a mass ﬂow rate 6 kg/s.…

A: The problem states that air enters an adiabatic and reversible turbine. This means that there is no…

Q: 8.7 Diffuser A jet flies at an altitude of 10 km, where the pressure is 0.32 bar, and the…

A: To Find:The mass flows into the engine.The pressure increase across the diffuser.Given:The altitude…

Q: e steps of a reversible Stirling engine are as follows. For this problem, we will use 0. mol…

A: 0.0010 mol of monoatomic gasTemperature =133Cvolume=0.10m3 To-Find:- a. PV diagram b. Fill the…

Q: please help with following problems, i have attached my figure (a) Calculate the amount of heat…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Water enters the boiler of a steady-flow Carnot engine as a saturated liquid at 200 psia and leaves…

Q: Helium at 660 K expands in a turbine to 369 K during which 84 kJ/kg of heat was lost to the…

A: Given data :- T1 = 660 k T2= 369 k Q = 84Kj /Kg @ 27° C P2/ P1 = 6.0 Find :- Entropy Generation =…

Q: The Carnot cycle is composed of four reversible processes two isothermal and two adiabatic and it…

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

Q: If you had an uninsulated air compressor which required W(in)= 400 kW to take air from a state at 80…

A: Given data as per the question W(in)= 400 kW Initial pressure =80 kpa Initial temperature =200 c…

Q: A Carnot engine uses oxygen as its medium. The volumes at the beginning and end of the reversible…

Q: Q.) A piston-cylinder device contains air at initially 1000 kPa and 200°C. The air is first expanded…

Q: the compressor and expander have to be assumed to have an actual efficiency that is less than ideal.…

A: Given data: ηC=78%ηE=82% Need to determine the efficiency of the system.

Q: Adiabatic steam turbine has inlet of 6 kg/s at 5 MPa, 600 oC. The actual steam exit from turbine is…

Q: Question 31 Steam overheated at a flow of 3.5 kg/s enters a turbine at 500 °C and 900 kPa and exits…

Q: 4. If 0.03 kg of air undergoes the cycle a - b → c (shown in the figure) in a piston-cylinder…

Q: P₁ = 230 bar and initial temperature T₁ = 577 °C to ss flow rate am,h is 146 kg/s.

A: The power can be obtained by,where, themass flow rate.. is the inlet or initial enthalpy. is the…

Q: execution of a reversible nonflow process, the work is 216 kJ. If the initial pressure and volume…

Q: A compressor (300 W) increases air pressure from atmospheric to 2,000 kPa. As the compressor…

A: as given that the outer casing is heated so the process is not adiabatic.

Q: A.) Air is compressed from 200kPa and 7.00 degrees C to 700kPa and 67.0 degrees C. determine the…

A: This question is based on the concept of entropy.

Q: Problem 3: Air initially at t=20°C and pi=1 atm is compressed reversibly and adiabatically to a…

Q: 3. In a cycle, a 4kg ideal gas (MW=3g/mol and k=2.3) confined in a controlled mass system went…

Q: Adiabatic steam turbine has inlet of 6 kg/s at 5 MPa, 600 oC. The actual steam exit from turbine is…

Q: Q.) A piston-cylinder device contains air at initially 1000 kPa and 200°C. The air is first expanded…

Q: Question attached

A: Apply first law of thermodynamics for closed system dQ-dW=dU dQ=Tds dW=-pdv Cv=du/dt…

Q: WHAT IS THE TOTAL CHANGE IN ENTROPY OF THE UNIVERSE IN RUNNING THIS SYSTEM? (please only answer if…

Q: Show the Formula or equation and T-s Diagram Correctly ] An adiabatic turbine has an efficiency of…

Question

A new adiabatic gas turbine is said to do the following: If the air enters the turbine
at 1100 C and 6.5 Mpa It would leave at atmospheric pressure ( P = 100 kPa)
and T = 100 C. Producing a power of W = 1109 kJ/kg. Is this possible?

Turbina = turbine

1
Air
P1 = 6.5 MPa
T1 = 1100 C
Tubina
w/m = 1109 kJ/kg
2
T2
100 C
P2 = 100 kPa

Expert Solution

Step 1

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A reversible non-flow process occurs from which the work is 9.4 BTU. If the pressure 100 varies as P = -V² + , psi (where V is V in ft), and P, = 46 psi, determine P2 in psi.
2. A large slab of concrete, 5 × 8 × 0.3 m, is used as a thermal storage mass in a solar-heated house. If the slab cools overnight from 23 °C to 18 °C in an 18 ° C house, what is the net entropy change associated with this process? at jadi qmuq
Steam expands adiabatically in a turbine from 4 MPa, 400°C to 0.5 MPa, 250°C. Calculate the turbine isentropic efficiency.
How to Calculate the thermal efficiency of 400 MWth PBMR.PBMR, Helium using Brayton Cycle
7. If 10 kgm/min of air are compressed isothermally from p1 = 96 kPa and V₁ = 7.65 m³/min to p2 = 620 kPa, find the work, the change of entropy and the heat for (a) nonflow process and (b) a steady flow process with u₁ = 15 m/s and U₂ = 60 m/s. Ans. (a) -1370 kJ/min, -5.356 kJ/K.min; (b) -1386.9kJ/min
! Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Five kilograms of air at 427°C and 600 kPa are contained in a piston-cylinder device. The air expands adiabatically until the pressure is 100 kPa and produces 450 kJ of work output. Assume air has constant specific heats evaluated at 300 K. Determine the entropy change of the air in kJ/kg-K. Use the table containing the ideal gas specific heats of various common gases. (You must provide an answer before moving on to the next part.) The entropy change of the air is kJ/kg-K.
A reversible non-flow, constant volume process decreases the internal energy by 315 kJ for 2.5 kg of gas for which R = 430 J/kg-K and k = 1.35. For the process, determine: a) the work; b) the heat; c) the change in total entropy. The initial temperature the gas is 205 °C.
3. A mass of 0.25 kg of air at 400 °C and 0.9 bar absolute is compressed at constant temperature to 2 bar absolute. The pressure is then dropped at constant volume back to the initial pressure of 0.9 bar absolute. For the total mass of air, calculate the change in entropy, the heat supplied and the work output. Sketch the process on a Ts diagram. (20 marks)
I need answer within 20 minutes please please with my best wishes