Answered: A transmission line strung 10 m above… | bartleby

Related questions

Question

A transmission line strung 10 m above the ground carries a current of 600 A. What is the magnetic field on the ground directly below the wire?

HintMagnetic field due to the transmission line is _______ mT.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A proton enters a uniform magnetic field of strength 1.2 T at a right angle to the field. What will be the frequency, in Hz, of the proton's resultant circular motion? The charge of a proton is 1.602 x 10-19 C, and the mass of a proton is 1.67 x 10-27 kg. a. 14 MHz b. 26 MHz c. 10 MHz d. 18 MHz e. 22 MHz
8. magnetic inclination is the angle made with the horizontal by the Earth’s magnetic field lines. In Oxford MS, theangle of magnetic inclination is approximately 63◦.9. Use this inclination to calculate the magnitude of the total magnetic fieldof the Earth in the lab. Bt =10. Compare your measured Bt from this experiment to a sample value of 43 µT, the magnitude of the magnetic fieldin Tucson, Arizona. 11. Tucson is approximately two degrees (latitude) south of this lab. Would the inclination of Earth’s magnetic fieldbe greater or lesser than it is here? How do you know?
Given: I = 6.2 A Points 1, 2, and 3 are all on a circle with a radius of 12.8 cm Questions: Find the magnetic field's direction generated by the wire at point 1 in degrees counterclockwise from the positive x-axis if: current's directed out of the page. current's directed into the page. Find the magnetic field's direction generated by the wire at point 2 in degrees counterclockwise from the positive x-axis if: current's directed out of the page. current's directed into the page. Find the magnetic field's direction generated by the wire at point 3 in degrees counterclockwise from the positive x-axis if: current's directed out of the page. current's directed into the page.
The moving rod in the figure is 13.5 cm long and is pulled at a speed of 16.0 cm/s. Force on electron a) If the magnetic field is 0.790 T, calculate the emf developed. Express your answer to three significant figures and include appropriate units. b) Calculate the magnitude of the electric field felt by the electron rod. Express your answer to three significant figures and include appropriate units. c) Determine the direction of the electric field felt by electrons in the rod. Express your answer as either: up, right, down, or left.
A current I = 30 A is directed along the positive x-axis and perpendicular to a magnetic field. A magnetic force per unit length of 0.18 N/m acts on the conductor in the negative y-direction. Calculate the magnitude and direction of the magnetic field in the region through which the current passes. magnitude ________T direction a. +x direction b. -x direction c. +y direction d. -y direction e. +z direction f. -z direction
A current I = 30 A is directed along the positive x-axis and perpendicular to a magnetic field. A magnetic force per unit length of 0.18 N/m acts on the conductor in the negative y-direction. Calculate the magnitude and direction of the magnetic field in the region through which the current passes. magnitude _____T direction A. +x direction B. -x direction C. +y direction D. -y direction E. +z direction F. -z direction
A solenoid has 505 turns over a length of 0.54 m. What current will produce a magnetic field of 0.017 T within the solenoid? A
2. A power line is suspended 10.0m above the ground and carries a current of 200 A. a. What is the strength of the associated magnetic field at ground level? b. How does this compare to the average ground level strength of Earth's magnetic field Bearth ≈ 3x10-5T? 3. Two power lines are separated by a distance of 3.00m. Each power line carries a current of 500A. The currents point in the same direction. What is the magnetic force between 10.0m segments of the two wires?
A circular loop rotates at constant speed about an axle through the centerof the loop. Shown is an edge view and defines the angle Φ, which increases from 0° to 360° as the loop rotates.a. At what angle or angles is the magnetic flux a maximum?b. At what angle or angles is the magnetic flux a minimum?c. At what angle or angles is the magnetic flux changing most rapidly?
Consider the velocity selector diagrammed below. If the charged particle ejected by the heated filament passes through the capacitor plates undeflected with a speed of 2.0 x 105 m/s,what is the magnetic field strength if the electric field strength is 800 volts/m? a. 2.0 mT b. 0.00 mT c. 6.0 mT d. 8.0 mT e. 4.0 mT
1) A straight, stiff, horizontal wire of length 48 cm and mass 28 g is connected to a source of emf by light, flexible leads. A magnetic field of 1.33 T is horizontal and perpendicular to the wire. Find the current necessary to float the wire, that is, find the current for which the magnetic force balances the weight of the wire. A Submit You currently have 0 submissions for this question. Only 10 submission are allowed. You can make 10 more submissions for this question.
6. A wire is formed so as to make a circular loop connecting two long, straight sections as shown in Figure 6. If the radius of the loop is R = 20 cm and the wire carries a current I = 2.4 A, what are the magnitude and direction of the magnetic field at the center of the loop? I If needed, you can use the magnetic field due to a straight wire, and and the magnetic field at the center of a loop derived from Ampere's law. (Hint: The two long sections form one long straight current- carrying wire.)

SEE MORE QUESTIONS