A transit with a stadia interval factor of 100.8 was set at C on the line between points A and B, and the following stadia readings were observed. Position of Rod Vertical Angle Hair Readings in meter Upper Middle Lower Rod at A +15°35' 1.330 1.175 1.020 Rod at B -8°08' 1.972 1.854 1.736 If the stadia constant is 0.381 m, determine the following: a. Length of line AB b. Difference in elevation between points A and B c. Find the horizontal distance from the transit to the rod held at B.

Q: The following observations were taken in reciprocal levelling. Staff reading at Instrument at A B A…

A:

Q: The vertical angle to the top of the New CSU Library Building ("point B") is observed by a BSGE…

A: Solution given in next step

Q: Problem no. 1: The difference in elevation between observed points A and B is 47 m and the…

A: Solution: Given Data: Difference in elevation between observed points A and B is 47 m. Horizontal…

Q: The following data were obtained by stadia observations: vertical angle = +7°55’, upper stadia hair…

A:

Q: Situation 1] From an instrument set up at point A, the angle of elevation of point B is +16°XY while…

A:

Q: A transit with stadia interval factor of 100.8 was set up at point C on the line between points A…

A:

Q: Given the data below, solve for the required unknowns. 1. Solve for the elevation at BM2 Station BS…

A:

Q: 1. Use the simulation to create the pattern of equipotential lines shown below. 30 V 40 V 50 V 50 V…

A: There are two charges. Thus the polarities are positive with a total of two positive charges: The…

Q: A survey party conducted a stadia surveying operation with the use of the same transit in Problem…

A: To Find :- Horizontal and vertical distance

Q: REE - Apr. 2001 18. Determine the divergence of the vector: V= i(x) + j(-xy) + k(xyz) at the point…

A: Given data: Vector: V=iX2+j-XY+kXYZ at (3, 2, 1)

Q: In determining the stadia interval factor (K) of a transit, a stadia rod was held vertically at…

A:

Q: Situation G. A stadia rod at a distant point B is sighted by an instrument set up at A. The upper…

A:

Q: 50KN 31 2m B 1.51 A 2m 31 25kN/m 2m ////////// 6m

A:

Q: SITUATION: From the given figure. TABLE GH 003 can be useful. Determine the settlement of the clay…

A: Answer Over burden pressure σo= 100 kpa Liquid limit LL = 60% Height of clay layer H=6 m distance…

Q: A transit with stadia interval factor of 100.8 was set up at point C on the line between points A…

A:

Q: A transit with a stadia interval factor of 100.80 was set at C on the line between point A and B,…

A: Given data

Q: -670 m hi= 1.54 m 34.34 m r= 1.87 m. A

A: It is required to find the elevation of A given the elevation of B is 86.53 m Distance between A and…

Q: From an instrument station a backsight was made on a turning point and the following data were…

A:

Q: The transit is set up at A and a stadia was places at a distance of 184. 20m from A. The stadia…

A:

Q: Problem no. 2: The width of a river being observed is 75 m. Assuming the transit being used has an…

A: This problem is related to Surveying Engineering. In this problem Tacheometry surveying , Horizontal…

Q: istance by Tachymetry 1. A stadia rod held at a distant point B is sighted by an instrument set up…

A:

Q: Sample Problem 2: Find the deflection value and change in slope at point B using double integration…

A: A beam is a load-carrying component of the building which is used to resist seismic condition and…

Q: Distance by Tachymetry 1. A stadia rod held at a distant point E is sighted by an instrument…

A:

Q: Given the following data in a sample D = 5°, Sta PC = 1+234.56. Azimuth of the back and forward…

A:

Q: stadia

A: This question is from Surveying.

Q: 5. A transit with a stadia interval factor of 100.8 was set at C on the line between points A and B,…

A:

Q: A level line from P to Q is carried out to and fro direct leveling, and the height difference of the…

A: Height difference of forward Measurement =12.380 m Height difference of the back measurement =…

Q: A line of levels is run from BM1 to BM2 that is 8 km long. Elevation of BM1 and BM2 was found out to…

A:

Q: B: Find the elevation of point (B) from the figure (2) that showing below : Fig. (2) 1.48 m IR Elev.…

A: Draw the given figure:-

Q: The upper, middle and lower hair reading is 2.45 m, 1.86m, and 1.27 m respectively. Determine the…

A: Determine the horizontal distance from the instrument to the the observed point.

Q: A vector, F , has components Fx=-228.2 N andFy = 155.4 N. What is the angle made with the…

A: We knowtanα=FyFxα=tan-1FyFxwhere α=angle made with x-axis horizontal

Q: Problem 2. The following tacheometric observations were made on two points P and Q from station A.…

A:

Q: 2. A transit with a stadia interval factor solve in # 1 was set at C on the line between points A…

A: The given data is shown below: Stadia constant=0.831m

Q: Find the angle o shown in below fig. with standard deviation if a = 64° 26 B=39°1 3' y= 27° 12"

A:

Q: With the line of sight horizontal, solve for the stadia constant given the following: Stadia…

A: Answer To Calculate the stadia constants for the line of Sight horizontal we have D = Ks+C D =…

Q: Using Virtual Work Method, determine the slope and defection at B and C.

A:

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.