A traffic surveying conducted on a road yield an average daily traffic count of 5000 vehicle. The axle load distribution on the same road is given in the following table. Axle load (tones) Frequency of traffic (f) 18 10 14 20 10 35 8 15 6 20 The design period of the road is 15 years. The yearly Traffic growth rate is 7.5% the load safety factor (LSF) is 1.3. If the vehicle damage factor (VDF) is calculated from the above data, the design traffic (In million standard axle load MSA) is

A traffic surveying conducted on a road yield an average daily traffic count of 5000 vehicle. The axle load distribution on the same road is given in the following table. Axle load (tones) Frequency of traffic (f) 18 10 14 20 10 35 8 15 6 20 The design period of the road is 15 years. The yearly Traffic growth rate is 7.5% the load safety factor (LSF) is 1.3. If the vehicle damage factor (VDF) is calculated from the above data, the design traffic (In million standard axle load MSA) is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. Answer the following questions: a) Among speed, flow, and density, which value helps to define the flow condition better? Why? k b) The relation between speed and density is given as u = uf 1 expression for capacity in terms of free slow speed and jam density. . Derive an
For a growth factor of 7.5% per annum and design life of 10 years, determinethe cumulative number of standard axle load repetitions (in million) for the following data: Type of commercial vehicle Number of vehicles per day per lane (A) Vehicle Damage Factor (F) Two axle trucks 2000 5 Tandem axle trucks 200 6
The predicted traffic mix of a proposed four-lane urban non-interstate freeway is as follows. Passenger cars = 78% Single-unit trucks: 2-axle, 5,000 lb/axle = 12% 2-axle, 9,000 lb/axle = 4% 3-axle or more, 23,000 lb/axle = 3% Tractor semitrailers and combinations: 3-axle, 20,000 lb/axle = 3% The projected AADT during the first year of operation is 3,900 (both directions). If the traffic growth rate is estimated at 3 percent and the CBR of the subgrade is 7.5, determine the depth of a full-asphalt pavement (in inches) using the AASHTO method and n = 20 years. The resilient modulus of the asphalt (EAC) is 320,000 lb/in². Assume m, for the subgrade is 1 and the percent of traffic on the design lane is 42 percent, pt = 2.5, and SN = 4. Use a reliability level of 90 percent, a standard deviation of 0.45, and a design serviceability loss of 2.0. Assume the design lane factor f is 0.42. (Use single-axle load equivalency factors for 2-axle vehicles and tandem-axle load equivalency factors for…
The proposed roadway has the following specifications: 1) rural road 2) design speed = 50 kph 3) radius of curvature = 192m; 4) 3-lane two-way direction 5) use maximum superelevation, emax= 8% Calculate the superelevation rate and coefficient of friction to be implemented in the road design.
Exact answer with full solution
Determine the LOS on a regular weekday on a 1.5-mile segment of an 8-lane freeway (four lanes in each direction) in rolling terrain. Use the following data.
An existing rural 4-lane highway is to be replaced by a 6-lane divided expressway (3 lanes in each direction). Traffic volume data on the highway indicate that the AADT (both directions) during the first year of operation is 24,000 with the following vehicle mix and axle loads. Passenger cars = 50 percent 2-axle single-unit trucks (12,000 lb/axle) = 40 percent 3-axle single-unit trucks (16,000 lb/axle) = 10 percent The vehicle mix is expected to remain the same throughout the design life of 20 years, although traffic is expected to grow at a rate of 3.5 percent annually. Using the AASHTO design procedure, determine the minimum depth of concrete pavement required for the design period of 20 years.
A section of a two-lane rural highway is to be realigned and replaced by a four-lane highway with a full-depth asphalt pavement. The AADT (both ways) on the existing section can be represented by 750 ESAL. It is expected that construction will be completed 5 years from now. If the traffic growth rate is 2 percent and the effective CBR of the subgrade on the new alignment is 9.0, determine a suitable depth of the asphalt pavement (in inches) using the AASHTO method. Take the design life of the pavement as 20 years. The resilient modulus of the asphalt (EAC) is 450,000 lb/in. ². Assume m; for the subgrade is 1 and the percent of traffic on the design lane is 45 percent. Use a reliability level of 90 percent, a standard deviation of 0.45, and a design serviceability loss of 2.0. 8.25 inches
A. Given 20 years Design years for 2 direction of road Number of lanes = 2 lanes ADT = 3500 %3D Calculate the ESAL for one direction of road Wheel Load (kN) Equivalent Load Factors % in total traffic volume 45 0.03 25 20 0.044 16 150 15 8 80 2.5 25 165 25 21 285 42
Please solve fast