3)toy spring gun is used to shoot a 30 g marble vertically upward. The uncompressed lengthof the spring is 200 mm. Before the gun is shot, the spring is compressed to a length of 60mm. The spring constant is 175 N/m.a) Calculate the velocity of the marble when it leaves the gun in m/s.b) Calculate the maximum height the marble will reach in m relative to its starting positioninside the gun.4) While Prof. K. was stuck in airport over break, she saw someone riding a Modobag (theworld's first motorized carry-on luggage) and immediately ordered one off Amazon. Once itgot delivered. she took it for a test ride up the hill between the Student Union and the football9:06 PM* 53°F Mostly cloudy3/2/2022P Type here to searchPrtScnPgUpPgDnHomeEndF6200 mmww 09

Answered: Image /qna-images/answer/f3d38be9-1e34-48c3-9994-82ca3a603220.jpg

A toy spring gun is used to shoot a 30 g marble vertically upward. The uncompressed length of the spring is 200 mm. Before the gun is shot, the spring is compressed to a length of 60 mm. The spring constant is 175 N/m. a) Calculate the velocity of the marble when it leaves the gun in m/s. b) Calculate the maximum height the marble will reach in m relative to its starting position inside the gun.

A toy spring gun is used to shoot a 30 g marble vertically upward. The uncompressed length of the spring is 200 mm. Before the gun is shot, the spring is compressed to a length of 60 mm. The spring constant is 175 N/m. a) Calculate the velocity of the marble when it leaves the gun in m/s. b) Calculate the maximum height the marble will reach in m relative to its starting position inside the gun.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3- Two mass m and 2m are connected by a massless string which passes over a light frictionless pulley as shown in Fig. The mass are initially held with equal lengths of string on either side of the pulley and at a height of 13.08 m above the ground. Find the velocity of the masses at the instand the lighter mass moves up a distance of 6.45 m. The string is suddenly cut at the instand, calculate the time taken by each mass to reach the ground. m +6.54 m 2m a 2mg 2m 13.08 m mg
2. A car starts from rest and travels 8 sec with an acceleration of a = 4-0.3t, then runs for 33 sec at constant velocity and finally comes to rest by decelerating at 3.125 m/s². a) Determine the velocity of the car after 10 sec. b) Determine the distance traveled by the car during the period of 10 sec. c) Determine the total distance traveled by the car until it stops. Kindly draw the fbd drawing. Thank you.
While winching a Jeep straight out of the mud, a winch uses 4800Watts of electrical power to pull the 1500-kg Jeep 12meters as it accelerates at 0.15. This takes a the winch 20 seconds to accomplish. Calculate... a.) the force of tension in the cable for the winch to pull the jeep. b.) the work done by the winch to pull the jeep. c.) the power done by the winch to pull the jeep. d.) the efficiency of the winch in this scenario.
In a skating jump, a skater rotates around their vertical central axis. Duringthe jump, the skater's rotation rate is increased by bringing their arms intotheir side. a) When bringing their arms into their side, do es the rotational kinetic energyof the skater go up, go down or stay the same? If it changes, where do es theenergy for this change come from or go to? b) Show that the change in rotational kinetic energy of the skater ∆KR canb e found by (see image) here KRi is the initial rotational kinetic energy of the skater, ωf is the nalangular sp eed and ωi is the initial angular speed. c) During the jump, when the skater draws their outstretched arms inwards,what total torque is acting on the skater if their final rate of rotation is tworotations p er second? d) After landing again, the skater is able to stop rotating and come to acomplete standstill in 0.7s. What is the average ratio of the torque on theskater to the skater's total moment of inertia during the time they come to…
A ring of mass m is attached to the spring and slides over the rod. Unextended length of the spring l0 and the spring coefficient is k. When the collar is at point C, it is released and between the collar and bar Since the coefficient of friction is μk; a) Find the velocity of the ring at points A and B using the Work-Energy method. b) Find the normal forces acting on the collar at points A and B.
5. A simple pendulum at the UCR department of physics and astronomy has a length of 20 m, and the acceleration due to gravity at this location is measured to be 9.803 m/s². Calculate the period of the pendulum.
3- Two cars moving towards cach other, separated by 150 km, If the first car has a speed of 60 m/s and the second has a speed of 40, find the necessary time for them to meet together.
A 2.0 kg object is moving to the right with a speed of 1.0 m/s when it experiences the force shown in the graph at right. What are the object’s speed and direction after the force ends? Paste the completed Bar Chart below. 1. identify the system 2. draw a quick sketch of the initial state of the object(s) 3. do a momentum bar chart
QUESTIONS 1. 500 kg roller starts from a point A as shown in the diagram below. If throughout its travel the average retarding force due to air friction on the wheel is 200 N. What is its speed at points B and C given that |AB| = 100 m and |BC| = 50 m. How far will it travel at the elevation of C before coming to rest? A to 20 m 5 m 2. Under a constant force, a 10 kg ball increases its speed from 2.0 ms- to 7 ms after covering 50 m. Calculate the force on the ball. 3. A stone is thrown vertically upwards fiom the top of a building 50 m tall with velocity of 20.0 ms. If the stone just misses the edge of the roof on its return, determine (a) The time taken by the stone to get to its maximum height. (b) The maximum height reached by the stone (c) The time at which the stone retum to the point where it was thrown (d) The velocity of the stone at this instance (e) The velocity and position of the stone at t= 5 s. initial 4. (a) What is the difference between inertia and momentum? (b) A…
Find the ground clearance of an object dropped from a height of 200 m at an initial speed of 2 m / s after 2 seconds.