A total station was setup on top of point A. The following observations have been recorded to point B in reflector-less mode: Occupied Point IH Target (m) Point Azimuth Vertical Angle 0 . W 0 SD (m) A 1.36 C 214 29 37 -4 19 56 208.527 If the coordinates of point A is (E-1659.637, N-1161.376, H-310.472). What is the Northing of point C? Round your answer to 3 decimal places. Do not add units to your answer (e.g. 100.351 NOT 100.351m) Your Answer:

Q: 4.14 A baseline of approximately 12 mi is to be observed with a GNSS eceiver. a. What method of GNSS…

A: The appropriate epoch rate and observation session duration for your survey should be determined…

Q: Direct and reverse directions observed with a total station instrument from A to points B, C, D and…

A:

Q: which of the instrument is more accurate in angle measurement theodolite or total station? Why?

A: Total station is more accurate in angle measurement in comparison to that of theodolite.

Q: To determine the elevation of a detail point, a total station was set up on a traverse station known…

A: orthometric height = 9.456 mreflector with rod = 1.45 mvertical angle = 94.1258 degreehorizontal…

Q: What is one of the project manager's primary responsibilities throughout the building phase?

A: Introduction: Project managers are accountable for the planning, procurement, and execution of any…

Q: A total station has a DIN 18723 specified accuracy of ±3″. What is the estimated precision of an…

A: Solution:  Given Data: specified accuracy=±3

Q: What instrumental errors are compensated by averaging an equal number of observations with the…

A: Compensation of Instrumental  The equal numbers of readings are averaged with direct and reversed…

Q: ▼ Part A Determine the axial forces in members BC, CD, and CE of the truss. (Figure 1) Enter your…

A:

Q: Which of the following co-ordinates are not the same for all observers? options: Right Ascention…

A: We need to choose which of the given co-ordinates are not the same for all observers.

Q: A total station was setup on top of point A. The following observations have been recorded to point…

A:

Control Survey and Geodetic reductions

Control surveys or survey controls are used to establish reference points as a basis for various construction activities. Vertical and horizontal control points are to be established in a control survey to increase accuracy. After establishing the control points, all other types of surveys such as topographic, right-of-way, aerial mapping, construction layout, boundary surveys, and utility mapping can be worked upon so that control networks can be formed. The place from which the observations are made is called a survey station.