A three-phase step down transformer is connected to 6600 volt mains and takes a current of 24 атperes. a. Calculate the secondary line voltage, line current and output for the following connections: (i) Delta-delta (ii) Star-star (iii) Delta-star (iv) Star-delta. The ratio of turns of per phase is 12

Q: The zero-sequence 3-6 transformer impedance of a is shown below. The connection of its winding are:…

A: Given a single line diagram:

Q: A 25 KVA single phase transformer has turns ratio of 100/29. If low voltage side is connected to 250…

A: Solution: Given data; KVA =25 KVA, single phase transformer ; turns ratio=N1N2…

Q: A 12 kVA, 58HZ, single-phase transformer has a turns ratio of 10:1 and is supplied from a 2.8 kV…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: Transformer Action & Equiv... A three phase star/delta transformer is used to step down voltage. If…

A: Given- A three-phase star/delta transformer to step down voltage- Primary voltage =11 kV, Secondary…

Q: Two single phase transformers connected in open delta deliver power to motor and an equipment. Motor…

A:

Q: Zero sequence currents can flow from a line into to a transformer bank if the windings are delta /…

A: Zero sequence current will flow into a star winding only when it's natural is grounded.  Zero…

Q: Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz . The resistance /phase and leakage…

A: (i) The per-phase secondary voltage in the star-connected secondary winding can be calculated as,

Q: In a single phase transformer, if the RMS value of emf is 240 V, then the average value is.

A:

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: A single phase transformer has, The no load secondary voltage, V2nl=235 V. The full load…

Q: Three single phase transformers are connected in a Delta-Wye configuration.  Each transformer is…

A:

Q: Two single-phase transformers in an open delta bank served a three- phase balanced load of 100 kVA.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: VSno-load=235 V and VSfull-load=223 V. Required: Percentage regulation of the transformer.

Q: Question 1. The primary of a 1000 kVA, 11 / 3.3 kV three-phase transformer is connected in star and…

A: The transformer is a static electrical device which transfers power from one circuit to another…

Q: Transformer 1 is in parallel with transformer 2. Determine the maximum kVA load the bank can carry…

A: Given: Transformer rating T-1150kVA, 1-ϕ6600/240VZ1=.02425∠62.9°       T-2300kVA,…

Q: In a 1-phase transformer, if the no load secondary terminal voltage is 222 V and the full load…

A: Given that Vnl=222VVfl=209V

Q: A single-phase transformer rated 55 KVA is connected to 400/230 V,49.5HZ supply, has an efficiency…

A: The solution can be achieved as follows.

Q: In short circuit of single phase transformer input power is equal to

A: Short circuit test usually conducted on H.V side and L.V side is short circuited.

Q: QI-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz .The resistance /phase and leakage…

A:

Q: A 3-phase step down transformer is connected to 6600 V on the primary side. The ratio of turns per…

A:

Q: A 13,200/460 V three phase transformer deliver a 750 KVA 0.8 power factor load. Under ideal…

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 9. Three single phase transformers are used to transform 3 phase power. The primary winding of each…

A: Given information is written below.Three single phase transformers are used to transform 3 phase…

Q: Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz .The resistance /phase and leakage…

A:

Q: If the no load secondary voltage of a 1- phase transformer is 235 V and full load secondary voltage…

A:

Q: B- what are the disadvantages of the auto transformers? C-An auto transformer is used to step-down…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz .The resistance /phase and leakage…

A:

Q: A 3-phase transformer is assembled by connecting three 720 -VA, 360/120 V single phase transformers…

A: A 3-phase, Y−Δ connected transformer is assembled by connecting three 720 VA, 360/120 V single-phase…

Q: In a 1-phase transformer, if the no load secondary terminal voltage is 227 V and the full load…

A: Although formula for voltage regulation is given by  %VR=Vno load-Vfull loadVno load×100% Given…

Q: Three phase, single phase visible on the side of high voltage (primary) windings of 50 Hz…

A:

Q: A 12 kVA, 58HZ, single-phase transformer has a turns ratio of 18:1 and is supplied from a 2.7 kV…

A: Given N1:N2=18:1V1=2.7kVf=58Hz

Q: In transformer , which is always working with its secondary short circuited.

A: In this question , we have to find out transformer in which secondary short circuited...

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: In this question,  We need to choose the correct option We know, voltage regulation= (VNL -VFL )/VFL…

Q: In load test on single phase transformer, the secondary voltage decreases with increase in load.…

A: In the load test of the single phase transformer.  This is based on the true false.  Secondary…

Q: 2. An ideal 1-phase transformer has turns ratio 5:1, with 120Vac primary.  A resistive load of 12…

A: an ideal transformer is different from a practical transformer. We made some assumptions in…

Q: Two transformers in an open delta bank which are single-phase served a three-phase balanced load of…

A:

Q: Two transformers are to be operated in parallel such that they share load in proportion to their KVA…

A: Given- 2 Transformers in parallel, Share load in proportion to kVA ratings, For 1st transformer- 500…

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.