Pls do this question at any cost A tensile stress of 25.0 MPa is applied on asingle crystal of nickel oriented such that thetensile stress is parallel to the [1 2 3]direction.1) If slip occurs on the (111) plane, calculateall resolved shear stresses on this plane.2) if the yield point on the plane (111) is 148MPa, then what is the critical resolved shearstress of nickel?

Answered: Image /qna-images/answer/a70c7ddb-0217-4447-b102-f91e05efaf42.jpg

Answered: A tensile stress of 25.0 MPa is applied…

A tensile stress of 25.0 MPa is applied on a single crystal of nickel oriented such that the tensile stress is parallel to the [1 2 3] diroction

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

what The answer 15 for this: 23,500 (1 + 0.031) 30 4.3/ number • answer must be report to the proper of significant digits A a showe all work Bea
Use Ha Pe Zoidal Rule with 1, 2.3 and 4 Selment 0.8 when So e x² dx Is oye
Question 6 a) The bore of each cylinder in a six-cylinder car engine is 45 mm and the stroke for each piston is 125 mm. calculate the cubic capacity of the engine in cubic centimetres (cm³); and calculate the clearance volume per cylinder for a compression ratio, r, of 8.75. b) The bore of each cylinder in a four-cylinder four-stroke internal combustion engine is 38 mm and the stroke of each piston is 165 mm. During testing, the engine runs at 180 revolutions per minute (rpm) with a pressure-volume indicator diagram showing a mean net area of 3.4 cm² and a diagram length of 1.2 cm. The pressure scale on the indictor diagram is set to 150 kN/m² per cm. Calculate the mean effective pressure (m.e.p) and the indicated power developed by this four-cylinder four-stroke engine. c) Figure Q6c shows a pulley system with a suspended load w of 2000 N. Calculate the following: (i) (ii) (iii) (iv) The effort force (FEffort) necessary to lift and hold a load of 2000 N. The ideal mechanical advantage…
Can I have the formula for the percent difference?
Please answer immediately thank youuuu
need asap please
Fluid Force. A swimming pool is filled with fresh water to a depth of 7 feet measured at the deep end. There is not enough water in the pool to reach the shallow end. Assume that the pool is constucted using right angles, except where the bottom of the pool meets the end walls. Use Ah for the height of a typical strip across the face of the wall. 6. The weight density of water is 62.4 lb/ Your anwers should have units: pounds. 4 ft 18 ft 24 ft Declare your variable(s) here. Show your reasoning below: a) find the force on the typical horizontal strip (red) ? b) write an integral for the total force on the (left) wall of the pool
Solidworks
Fast plzz
I need answer within 20 minutes please please with my best wishes
3) Graphically trace the area which contributes to the load for each joint of the middle parallel chord truss shown on the plan from a distributed area load. Also complete the free body diagram for the section shown for the truss on the bottom figure (with loads) with the appropriate directions (senses). 0.5P (3) 3 P
Answer all parts otherwise skip... Need typed solution plz......