A tank used to collect rainwater having diameter of 4m .the depth of the tank varies linearly from 3.5m at its center to 3m along the perimeter.the local atmospheric pressure is 1bar ,the acceleration of gravity is 9.8mS square and the density of the rainwater is 987.1kg/m3. When the tank is filled with water,determine a) the pressure in kPa at the bottom center of the tank b)the total force in kN,acting on the bottom of the tank

Q: Water is flowing into a frustum of a conical vessel 2 m high at 100liters per minute. The vessel has…

A: To determine the height of water when the water surface is rising at 25.72 mm/min.

Q: 1-The storage tank shown below is to be used to supply a community such that the pressure at Point B…

A: Q= ,  , D = 600mm=0.6m , L = 1000mTo Determine: Water Depth(h) in the tank that will meet the design…

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom, A 2.0 m…

A: Given Data  Closed tank contain  Depth of mercury (hm) = 0.5m  Depth of water (hw) = 2m  Depth of…

Q: 1. Oil is placed inside a closed container, but it is not filled to the top. The vacant area above…

A:

Q: Problem #1 dos bes-08 A pump is used to transport water to a higher reservoir. temperature is 20°C,…

A:

Q: Calculate the value of pressure ∆p onside the rain water droplet , if we know the radius R=0.2mm and…

A: GIVEN- r=0.2mm δ=0.074N/m=7.4×10-5N/mm2∆P=?

Q: A pipe discharges 150liters/sec of water into a reservoir at a point 1.80m below the water surface.…

A: Bernoulli's Equation P1γ+V122g+Z1=P2γ+V222g+Z2+hL Z1= 3.0 m    Z2=0 m  hL=0.65 m Q= 150 l/s= 0.15…

Q: A water pipe runs vertically through a tall building, with a flow rate of 0.2 m³/s. The diameter of…

A:

Q: 1. A Venturi tube, as shown in the figure, is used to measure the flow of kerosene runoff (d =…

A:

Q: Compute the pressure at point B

A:

Q: Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe…

A:

Q: Question: The rainwater discharge system in the figure with a width of b=1 m perpendicular to the…

A: Solution

Q: In fig. if water level = 2 m and the liquid * ?--- =S.G=0.85 , hl %3D Water Ah A' B' 2.35 m. 3.35 m…

A:

Q: Water at T = 25°C is drawn from an underground detention tank and discharged into a drain using a…

A: Temperature is,To determine:Part A): Available NPSHPart B): Required NPSH

Q: Q.5.Calculate the stability of the intake box structure for water treatment plant with dimensions…

A: Box structure water plant dimension: length=5m wide=5m height=10 m Flood chamber dimension: length=4…

Q: A glass tube 1.60 m long and having a diameter of 2.5 cm is inserted vertically into a tank of oil…

A:

Q: A horizontal, circular pipe connects two big reservoirs, 1 and 2. The length of the pipe is 100 m.…

A:

Q: Given the set-up shown in the illustration, find the following: a. Equivalent coefficient of…

A:

Q: Two tanks A and B have 80 m difforence in water levels, and are connected by a pipe 0.3 m diameter…

A: area    A=π4×d2=π4×0.32=0.07065 m2and friction loss for first half pipe length  hf1=8fQ12L2π2gD5and…

Q: 3m 9m W2 8m W1 6m

A:

Q: The centerline of the standard orifice is 3.2 meters above the ground and 3.5 meters below the…

A:

Q: A water pie gradually changes from 150mm ata point x to 450mm at point y. Point x is 5m below point…

A:

Q: A 0.1m-Φ x 0.094m solid cylinder weighs 4 Newton. It is submerged in a liquid (SG = 0.8328) which is…

A:

Q: The figure bellow shows the load distribution of a septic tank on the ground. The shaded area…

A: Given, qshaded = 200 kPa qunshaded = 800 kPa z = 8m

Q: 1.  For the flow net shown in the figure below, if the datum is selected at the downstream water…

A:

Q: uid mechan

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Given the set-up shown in the illustration, find the following: a. Equivalent coefficient of…

A:

Q: Q.5.Calculate the stability of the intake box structure for water treatment plant with dimensions…

A: Given,  Box structure water treatment plant dimension = 5*5*10 m Flooded chamber dimensions = 4*4*10…

Q: Determine the difference of pressure between points A and B in kPa. a 3.3m b 2.4m C 4.3m 2.3m 3.3m…

A:

Q: Water at 10°C has a kinematic viscosity of 1.30 X 10-6 m2/s flows at the rate of 896.61 L/min from…

A: Given data  Height of liquid  Discharge  Outer diameter  Pipe roughness Temperature  Kinematic…

Q: Compute the capillary rise in mm of pure water at 10 Celsius expected in an 0.8 mm diameter tube.

A:

Q: A large tank contains water to a depth of 95cm. The water discharges from a sharp edged orifice of…

A: Given that  A large tank contains water to a depth of 95cmThe water discharges from a sharp edged…

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom. A 2.0 m…

A:

Q: The diameter of a pipe gradually reduces from 1 m to 0.7 m. the pressure intensity at the centre…

A:

Q: For the same condition as the previous problem (After a solid block is put on a scale in the water…

A:

Q: Bernoulli. Water is siphoned from a large tank filled to a depth of 3m using a tube (Dr=0.6 cm) with…

A: Bernoulli's theorem : In fluid dynamics, Bernoulli's theorem describes the relationship between…

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom. A 2.0 m…

A:

Q: Water at 10°C has a kinematic viscosity of 1.30 X 10-6 m2/s flows at the rate of 895.55 L/min from…

A: Calculate the velocity of flow as follows. v=QA=895.55×10-360×6.793×10-3=2.2 m/s Calculate Reynold's…

Q: An open rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is…

A:

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom. A 2.0 m…

A:

Pressure and Stress