A tank contains 200L of a dye solution with a concentration of 1gram per liter. To prepare for the next experiment, the tank is to be rinsed with fresh water flowing in a rate 2 liters per minute; the well stirred solution flowing out with the same rate. Find the time that will elapse before the concentration of dye in the tank reaches 1% of its original value.

A tank contains 200L of a dye solution with a concentration of 1gram per liter. To prepare for the next experiment, the tank is to be rinsed with fresh water flowing in a rate 2 liters per minute; the well stirred solution flowing out with the same rate. Find the time that will elapse before the concentration of dye in the tank reaches 1% of its original value.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

3. Standard white vinegar you can buy in the grocery store is 5% concentration. That means 5% of the liquid vinegar is acetic acid and 95% of the solution is water. In a hardware store, you can buy industria strength vinegar, which is 30% concentration. This means that 30% of the vinegar is acetic acid, and the remaining 70% is water. Samuel does another experiment, this time with 5% vinegar and 30% vinegar. He sets up two science fair volcanoes (in no particular order), each with the same temperature, mass of baking soda and volume o vinegar. But one volcano uses 5% vinegar and the other volcano uses 30% vinegar. He measures the volume of gas production for the'first minute of each reaction, and he records the data below. Volcano # 1 Volume of gas produced (mL.) vs. Time (s) for Volcano #1 Time Volume of gas (s) produced (ml) 60 E 50 10 20 30 25 8 40 38 46 30 20 Volume of gas produced (ml) 40 50 50 60 52 of 10 53 20 40 60 80 Time (s) Volcano # 2 Volume of gas Volume of gas produced…
José performs an experiment to determine how much sugar can be dissolved in 250 milliliters (mL) of water at 25°C. He adds 50 grams (g) of sugar at a time to the water while stirring and observes the solution After adding sugar the eleventh tene (550 g), he notes that undissolved sugar has settled to the bottom of the container. He stops adding sugar and ends his experiment. In his lab write-up he concludes that the solubility of sugar in water at 25°C is 500 g per 250 ml. is his conclusion defensible, and why or why not? O No, because he did not add sugar enough times. Yes, because when he added more than 500 g it did not all dissolve. O No, because he does not know if any of the final portion of sugar dissolved. O Yes, because when he added the tenth portion (500 g) all of it dissolved.
12 of 19 <. I Review | Constants | Periodic Table Part B Before investigating the scene, the technician must dilute the luminol solution to a concentration of 4.00×10-2 M. The diluted solution is then placed in a spray bottle for application on the desired surfaces. How many moles of luminol are present in 2.00 L of the diluted spray? Express your answer with the appropriate units. » View Available Hint(s) moles of luminol = Value Units %3D
Solution 1 Solution 2 Solution 3 Solution 4 Solution 5 Concentration iron(III) nitrate 0.00200 0.00200 0.00200 0.00200 0.00200 [Fe(NO3)3] (M) Concentration potassium thiocyanate 0.00200 0.00200 0.00200 0.00200 0.00200 [KSCN] (M) Volume Fe(NO3)3 (mL) 5.00 5.00 5.00 5.00 5.00 Volume KSCN (mL) 5.00 4.00 3.00 2.00 1.00 Volume DI water (mL) 0.00 1.00 2.00 3.00 4.00 Initial concentration [Fe3+] (M) 0.00100 0.00100 0.00100 0.00100 0.00100 Initial concentration [SCN‍] (M) 0.00100 0.000800 0.000600 0.000400 0.000200 Absorbance 0.269 0.192 0.154 0.104 0.052 Equilibrium [FeSCN2+] (M) 0.000198 0.000141 0.000113 0.0000765 0.000038 Equilibrium constant Kc Average Kc
00 mL of a diprotic acid primary standard solution was accurately prepared to a concentration of 0.1431 M. Three samples of this primary standard solution were used as samples in a titration to standardize an aqueous solution of sodium hydroxide, NaOH, which would be used as a titrant. Using the following table of data for the titration of the primary standard acid with NaOH, calculate the average concentration of NaOH. Trial # Volume of primary standard Initial titrant volume Final titrant volume 1 10.00 mL 8.21 mL 27.22 mL 2 10.00 mL 27.22 mL 46.23 mL 3 10.00 mL 30.28 mL 49.29 mL 0.1506 M 0.0753 M 0.0376 M 0.1431 M 0.0526 M
There's 1 drink (and you are asked to determine the glucose concentration in the drink in the units of g/100mL. (Why these units? Well, once you have the concentrations in g/100mL you will be able to compare your values with the nutritional values given on the drink bottles’ labels). The sample of the drink was diluted 1/100 (i.e. by a factor of 100). This was an essential step in the method because, without it, the machine used to analyse the glucose concentration (spectrophotometer) would have given an error as the concentration would have been too high for accurate detection. What this means for you is that the dilution factor will need to be taken into consideration in your calculations (remember the aim is to calculate the concentration in the original drink and not in the diluted drink). You measured the concentration of their diluted drink using the spectrophotometer and their results were provided to them in the units mM (millimolar). Glucose Concentration in mM of drink =…
Effect of Particle Size on the Rate of Dissolving Time required for all NaCl to dissolve Sample Results after 2 minutes shaking Do you think the size of the crystal makes a difference in how fast the salt dissolves? Explain why the differences you observed and why they happened. Effect of Temperature on the Rate of Dissolving Time required for all NaCl to dissolve Sample Observations Do you think the temperature of the water makes a difference in the rate at which the NaCl dissolves? Explain why the differences you observed and why they happened. Page 3 of 6
Below is a simple set of weights obtained while immersing potato slices in various sugar solutions over 30 minutes. I need help calculating all of this for a 30 min period a. For each solution, calculate the rate of weight change over this 30-minute period. Show your work in the space below. Once you calculate these rates - fill in the blanks below and then add these answers to your Canvas exam. Write your answer in standard notation and use 3 digits past the decimal point - e.g. 0.005, 0.030. (Note that the last zero in an answer is considered to be a digit). Show your work in the space below. 0.0 M sucrose = _______ _____________ g/min 0.4 M sucrose = _______ ____________ g/min 0.6 M sucrose = ________ ____________ g/min 0.8 M sucrose = ____________________ g/min 1.0 M sucrose = ________ __________ g/min Using the osmosis data in the question above, determine the percent weight change for each sucrose solution and fill in the blanks given below and then add these answers to…
Catra wanted to determine the concentration of copper(II) chloride at an unknown concentration .She began by trying to determine the value of epsilon (ε) using beers law for copper(II) chloride. Catra remembered in lab when they wanted to solve for epsilon they would test the absorbance for three different concentrations of a known solution and then graph it. Catra got frustrated and asked Shera what to do next to determine epsilon. What should Shera tell Catra?
Home Tools Lab Experiment #... x ... +) 玩, 1 | 2 97.4% Record your observations following each reaction including changes in color and state of matter. AGNO3 (Ag*) Pb(NO3)2 (Pb²*) Ca(NO3)2 (Ca²+) а e i NazCO3 Light orange solid white, cloudy solid white, cloudy, solid (СО2) b NaOH f dark brown solid stay clear, liquid white, cloudy solid (OH) g k NazSO4 stay clear, liquid white, cloudy, solid white, cloudy, solid (SO?) d NaCl 1 white, cloudy solid white, cloudy solid stay clear, liquid (CF) .... Remember to complete and submit this table to your instructor before the end of the class session.
In this station, you will find a sample of table salt; the chemical formula of table salt is NaCl. Using the balance, weigh out 6.00 g of NaCl and dissolve in 50 mL of deionized (d.i.) water. Once com-pletely dissolved, add additional d.i. water to make the final volume of solution 100.0 mL. What is the mass percent NaCl in the solution? What is the molarity of the solution
Explain why one would recrystallize a solid from a solvent pair instead of a single solvent. Explain how it works in terms of solubilities. please give detail, will only rate if sufficent detail is given. thank you!