A system asshown in the figure is used to measure accurately the pressure changes when pressure is increased by AP inside the water pipe. When the height difference reaches Ah = 70 mm, what is the change in pipe pressure? Water Pipe Glycerin, SG = 1.26 D= 30 mm Ah d=3 mm

Q: the equivalent length of the exchanger as a complete unit (in terms of 20 mm diameter tube).

A: Consider a heat exchanger of length 12m, 10 close return bends and 15 x 90° elbows connected in…

Q: Density and viscosity oleic acid at 20 degree celcius and 1 atm

A: Oleic acid is an mono-unsaturated long chain fatty acid which is generally found in liquid state at…

Q: Use water as a drilling mud to drill a well to a depth of 3000 feet , calculate the pressure…

A: This question is based on pressure gradient. The data given are: Depth = 3000 feet

Q: Choose the correct option: These are factors that affect permeability, except: a) Soil void ratio b)…

A: Asked; Choose which factors does not affect permeability ?

Q: ind modulus of elasticity of a brass rod of length 200 mm which is subjected to a tensile stress of…

A:

Q: 5. Two immiscible fluids of equal density are flowing down a surface inclined at a 30° angle. The…

A: Two immiscible fluids 1-Lower layer 2-Upper layer ρ1=ρ2 θ=30° h1=h2=2.5mm 2ν1=ν2 ν1=2×10-4 m2/s…

Q: A square polymer sample of edge length 80 mm is subjected to a force of 6400 N. The resulting stress…

A: Given data: Length of edge of a square = 80 mm Force = 6400 N

Q: Apply diffusive Fick's first law on one dimension

A: Mass transfer is the net movement of mass from one location to another. Mass transfer occurs in many…

Q: A single crystal of a metal is oriented for a tensile test such that its slip plane normal makes an…

A: Given,

Q: A B Rate of deformation, duldy Shear stress, 7

A: There are several properties defined for fluid such as density, specific gravity, viscosity, etc. In…

Q: The coefficient of friction is 0.37, what should be the diameter (in mm) of rolls, if pair of rolls…

A:

Q: How we can calculate friction losses due to changes in velocity and direction in side a conduit

A: Friction losses due to changes in velocity and direction in side a conduit can be calculated as

Q: A box is sitting on an inclined plane. One end of the inclined plane is slowly raised, increasing…

A:

Q: A solid cylinder of weight 9 kg slides in a vertical lubricated pipe. The clearance between the…

A:

Q: Fraction of water

A: To Answer whether the fraction of water in the underflow stream of thickener is zero

Q: drag force

A:

Q: Why do positive displacement pumps cause pose more overpressure hazard compared with centrifugal…

A: In a positive displacement (PD) pump, a fixed volume of liquid is trapped inside an enclosed chamber…

Q: Cone has top and bottom diameters of 10 and 20 cm and a height of 10 cm. Calculate the shape factor…

A:

Q: If the shear stress profile of a fluid flows within laminar boundary layer is given by (1-) 21 U T =…

A:

Q: Rate of movement of fluid passing one another. * O surface tension Shear O Rate of shear O Viscosity

A:

Q: A fluid whose apparent viscosity increases with shear rate is termed as the fluid. Viscous…

A: Viscosity is a fluid [property. This property studies liquid motion behavior. The measure of the…

Q: Why does the fluid drop in the fluid level measurement experiment when the pump is turned off?

A: In a typical fluid level measurement experiment, the pump is used to recirculate the fluid in a…

Q: What does the concept behind the graph wherein the two points of the line meets at the two end.…

A: Temperature, composition of a binary mixture is given.

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms=…

Q: What is Outlet Gas Velocity in a cyclone seperator?

A: In mechanical operation, Cyclone separators are separation devices that use the principle of inertia…

Q: Liquid Properties a. Define (note: your definition must be based on the closed conduits/pipe flow):…

A: The definitions of all the terms are written below:

Q: If the entering velocity is 6 m/s, calculate the length of tube and determine whether the process is…

A:

Q: I. Liquid Properties a. Define (note: your definition must be based on the closed conduits/pipe…

A: We need to define the following based on the closed conduits /pipe flow .The terms given are : 1.…

Q: Determine the hydrostatic force acting on the radial gate if the gate is 40 ft. long (normal to the…

A:

Q: Consider a colloid particle whose dimensions are 50x30x10 µm. Calculate the surface to volume…

A: Given data: Dimension of colloid particle = 50 × 30 × 10 μm

Q: A tensile stress is to be applied along the long axis of a cylindrical steel rod that has a diameter…

A: Given data: Diameter of rod = 0.015 m Change in diameter = 1.5×10–3 mm Value of Young’s modulus for…

Q: Using a flow chart, show how a lubricant oil with high viscosity index can be manufactured from…

A: In petroleum industries, Crude oil is a type of fossil fuel that is a naturally occurring petroleum…

Q: Given a single particle with shape and dimensions as in the image below, compute for the (a) Volume…

A: Given, The radius of the base of the cone, r = 5 cm The height of the cone, h = 12 cm the slant…

Q: 1. Determine the maximum allowable vacuum that can be applied to a low-carbon-steel cylindrical…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 5. Absolute pressure is measured relative to atmosphere. Tor F

A: Absolute pressure is measured relative to a full vacuum Whereas the pressure that is measured…

Q: How is pump impeller size calculated

A: The two industrially used pumps are: Positive displacement (PD) pump and Centrifugal pumps. In a…

Q: What

A: The hydrosphere is combined mass of water on ,above and below surface of earth.