An acetal polymer block is fixed to the rigid plates at its top and bottom surfaces. If the top plate displaces 5 mm horizontally when it is subjected to a horizontal force P 2 kN, determine the shear modulus of the polymer. The width of the block is 100 mm. Assume that the polymer is linearly elastic and use small angle analysis.

Q: Density and viscosity oleic acid at 20 degree celcius and 1 atm

A: Oleic acid is an mono-unsaturated long chain fatty acid which is generally found in liquid state at…

Q: Choose the correct option: These are factors that affect permeability, except: a) Soil void ratio b)…

A: Asked; Choose which factors does not affect permeability ?

Q: A B Rate of deformation, duldy Shear stress, 7

A: There are several properties defined for fluid such as density, specific gravity, viscosity, etc. In…

Q: (2020 psi), compute the critical resolved shear stress.

A:

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has…

A:

Q: A fluid whose apparent viscosity increases with shear rate is termed as the fluid. Viscous…

A: Viscosity is a fluid [property. This property studies liquid motion behavior. The measure of the…

Q: 8. What type(s) of corrosion occur when metal is subjected to a high- velocity fluid flow with…

A: A) this option is not correct because it is the most general type of corrosion and is caused…

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms=…

Q: 3.) A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension…

A: Given: Length of steel bar=100 mm=100×10-3mCross section of the steel bar=20 mm=20×10-3mForce=89000…

Q: A single crystal is oriented such that the normal to the slip plane and the slip direction are at…

A: Angle between normal to slip  = 60 0 Angle of slip direction = 350 Critical resolved shear stress =…

Q: 1. Determine the maximum allowable vacuum that can be applied to a low-carbon-steel cylindrical…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: For a parallel plate arrangement, it is found that when the distance between the plates is 2 mm, a…

A:

Q: mm diameter glass tube is inserted into an open glass of water (contact angle between the tube and…

A:

Q: For a parallel plate arrangement, it is found that when the distance between the plates is 5 4 mm, a…

A: