A submarine moves forwards and has its axis 15 m below the surface of water. A pitot tube properly placed just in front of submarine and along its axis is connected to U-tube manometer. The difference in mercury levels of manometer is 170 mm. Determine the speed of the submarine. Take specific gravity of sea water = 1.026

Q: Problem 4 Two tanks are connected using a manometer. Air is trapped in the right tank above the…

A: To find out the difference in Piezometric head of water between left and right tank.  Where,  H =…

Q: A discharge of 150 liters per second is to be measured by a V-notch of vertex angle 60°. What would…

A: Given- Discharge Q=150 l/s=0.15 m3/sVertex angle θ=60odH=1 mmCd=0.62Head over the vertex and error…

Q: A centrifugal water pump is tested under its design flow rate Q=250 m/hr. The static pressure at the…

A: Given Discharge   Q=250 m3/hr=0.0694  m3/secpressure  P1=1.2 bar=120 KPaand at outlet end   P2=8.5…

Q: A body moving through still water at 6 m/sec produces a water velocity of 4 m/sec at a point 1m…

A:

Q: 8. Both ends of a U-tube manometer are exposed to the atmosphere. There exists a possibility that…

A: True

Q: HYDROSTATIC FORCE ON PLANE SURFACES I need help analyzing my experiment. For a Fully Submerged…

A: Data given

Q: Calculate the pressure in small 10 micrometer diameter bubbles that are formed by spray machines.…

A:

Q: The minimum pressure on an object moving horizontally in water (Ttemperatu at10 degree centrigrade)…

A: Solution Velocity, V1 = (x+5) mm/s                    = (71+5) mm/s = 76 mm/s…

Q: A very small drop of fluid 1 immersed in fluid 2 is sitting on a solid surface. Based on the image…

A: A contact angle less than 90 indicates wetting liquid or hydrophilic liquid and lower density as…

Q: 1. In Figure below, sensor A reads 3.5 kPa (gage). All fluids are at 15°CC. Determine the elevations…

A: Pressure at A = 3.5kPa

Q: a cylindrical tank has a diameter of 1.4m. and a total weight of 1.8 m. it contains water to a depth…

A:

Q: To damp oscillations, the pointer of a galvanometer is fixed to a circular disk which turns in a…

A: Given data,  ω= 0.30 rad/s  Viscosity of oil = 8x10^-3 Pa-s Disc diameter = 75 mm Oil gap = 0.5mm…

Q: r per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to…

A: We know the formulaQ=A1A2A12-A222ghh=x(SmSw-1)h=1.2(1.61-1)=0.72m

Q: 2) From the figure shown below determine how many minutes would it take for the water surface in…

A:

Q: Q4. True or False (circle correct answer): The Head Loss in a Hydrodynamic system is a measure of…

A: Hydrodynamic systems use fluid motion to transmit power. Power is transmitted by the kinetic energy…

Q: Kerosine at 20°C flows through the pump in the figure at 0.08 m³/s. Head losses between 1 and 2 are…

A: SG of kerosine at 20°C is 0.804Head of the pump…

Q: A pitot-static tube is used to measure air speeds. With water in the differential manometer and a…

A: It is required to determine the actual air speed. v=Cv2ghmρwρa-1 Here Cv is the coefficient of pitot…

Q: ion probe at station 2 and a static pressure tap on 1. The velocity at station 2 is 2 times that at…

A: Given:- Air with density=1.2kg/m3 deflection=5cm To find:- velocity at station 2

Q: There are two (2) mercury barometers at the mountain. At the top reads 500 mm and at the base reads…

A:

Q: Find the difference in level of water surface in two limbs of a U-tube when it is rotated about an…

A: Angular velocity w=25 rad/s Distance r1=15 cm=0.15 m, Distance r2 =18 cm=0.18 m,   It is needed to…

Q: shaft = 44 kW and mechanical efficiency = 94%. Q53. The following data were obtained from a test on…

A:

Q: A discharge of 150 litres per second is to be measured by a V-notch of vertex angle 60°. What would…

A: Given data  Coefficient of discharge Cd = 0.62 Vertex angle = 60° Disharge Q = 150 Ltr/s ,= 0.15m³/s…

Q: Determine the viscosity in poise of a liquid having kinematic viscosity of 6-stokes and specific…

A: Given  Kinematic viscosity  ν= 6 stokes  since 1 stoke= 10-4 m2/s  so Kinematics viscosity ν= 6 ×…

Q: Neglecting determine head loss, the manometer 25 mm Ø reading shown when the velocity of water…

A:

Q: 1. A liquid metal alloy (SG 6,44) Barometer at the base of the mountain reads 620mm. at the same…

A:

Q: A discharge of 100 L/s to be measured by triangular notch of vertex angle 60°. What would be the…

A:

Q: in Fig. (4) has a 4- piug Will pop dlut if the hydrostatic force df it reaches 25 N. For °20C…

A: F=25N diameter of plug=4cm

Q: Q2) The flow-metering device shown consists of a stagnation probe at station 2 and a static pressure…

A: This question can be solved by applying Bernoulli's equation at 1 and 2. The detailed stepwise…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?