A student set up a simple circuit with an ohmic lightbulb, battery and switch. battery switch light bulb When the switch is closed, the student measures 639MA being drawn from the 2.2V battery by the lightbulb. They decide to leave the switch closed for a few hours. When they measure the current again, they find it is now 298mA, and correctly guesses that the battery has dropped voltage. What would they measure the new voltage across the battery to be? (Units: V)

A student set up a simple circuit with an ohmic lightbulb, battery and switch. battery switch light bulb When the switch is closed, the student measures 639MA being drawn from the 2.2V battery by the lightbulb. They decide to leave the switch closed for a few hours. When they measure the current again, they find it is now 298mA, and correctly guesses that the battery has dropped voltage. What would they measure the new voltage across the battery to be? (Units: V)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The data shows the voltage reading during charging across the 10-µF capacitor in a circuit with 6-MΩ resistor, and voltage supply of 5 V. What is the experimental value of the time constant? A. 45s B. 50s C. 55s D. 60s E. 65s
A 5 µF capacitor in parallel with a 10 µF capacitor. Connected in series is another 5 µF capacitor. The voltage of 120 V is applied to the whole combination. Solve for: a. the total capacitance of the circuit b. charge stored in each capacitor C. energy stored in each capacitor d. voltage across each capacitor
Question 1 Jonathan connected a bulb of unknown resistance to a 3.7 V battery and measured a current of 1.23 A flowing through the bulb. First Electric Circuit I = 1.23 A Then, he changed the power source to a 5 V battery and connected it to the same bulb. Second Electric Circuit I = ? What current flowing through the bulb can Jonathan claim for his second electric circuit? A 0.60 amps B 1.66 amps C 15.00 amps D 15.15 amps
QUESTION 22 Given two resistors of 70 ohms and 40 ohms connected in series to a DC battery. If the 70-ohm resistor has a current of 3.00 Amperes through it then which of these is the current through the 40-ohm resistor in SI units? a. four sevenths of 3.00 b. one-third c. 3.00
What happens to the two identical bulbs A and B con- nected to two 12V batteries, as shown, when the switch is closed? A. B. C. D. A glows, B changes A glows, B stays same A stays same, B changes A stays same, B stays same What happens when the switch is closed if I change the battery on the right to 6V? A. B. C. D. A glows, B changes A glows, B stays same A stays same, B changes A stays same, B stays same 12V 12V fmm A (mm) A B B switch switch ww 12V 6V
The circuit shown has two resistors, with R1 > R2 .Which resistor dissipates the larger amount of power? Explain.
A student calculates the total potential difference of a circuit given the total current and total resistance for the circuit. The student works a new version of the question where the power has been changed by a factor of 0.693. Determine the factor by which the answer would change. 0.693 It does not change or it does not make sense to calculate given this information. 0.480 1.443
Q55. The following circuit is given, and you are asked to determine the current flowing through each resistor and its direction. 12.0 V 12.0 V 6.000 4.000 6.000
A circuit contains three resistors connected in series across 100 volts; the circuit current is 2 Amperes. Two resistors (R1 and R2) have known values of 5 and 10 ohms,respectively. Determine:a. The resistance of the entire circuit.b. The resistance of the third resistor R3.c. The voltage drop across each resistor
2#
B. Measure Voltage across R1, R2, R3 and Current throughout the circuit: R1 5kQ V1 R2 1ka = 24V R3 2000 Attach simulation sereenshot with measured parameters (with your nam
Considering the following circuit. What is the minimum number of equations to determine the Vx?. A )1 B) 2 C) 3 D)4 E)5 F)6