A stream of acetone vapor at its normal boiling point and 1.00 atm flowing at a rate of 175 kg/minis to be condensed at constant pressure. The product stream from the condenser is liquid acetoneat 30.0 ̊C. Calculate the rate (kW) at which heat must be transferred from the condenser.

Q: A 2,000 lb/h solution containing 10% NaOH at 80°F is to be concentrated to 40% NaOH using a single…

A: The challenge is to use a single-effect evaporator to increase the concentration of a sodium…

Q: It is desired to produce 250 kg / h of steam methanol at 150ºC and 1 atm from liquid methanol at…

A: The schematic process flow chart for the given process is prepared as:

Q: Example 1.8 Nitrogen from a tank flows at a rate of 6 lb/mm at -350°F then enters a heater where it…

A: Given: Nitrogen gas leaves the tank at T = 150 oF = 609.67 oR and P = 600 psia The universal gas…

Q: Calculate the net work output of the overall system if 1.2 x 107 joules of heat is released per kg…

A: The thermodynamic system follows the law of conservation of energy. The change in heat transfer is…

Q: Calculate the final temperature if 450 Kw of heat was added to a stream of air at 25 °C and 20 kg/hr…

A: Given: Heat added Q = 450 Kw = 450×103 W or (J/sec) Initial temperature T1 = 25 oC = 298 K Final…

Q: A family uses 300 L of hot water per day. The water is heated from a line temperature of 12° C to…

A: Natural gas is a naturally occurring hydrocarbon gas mixture consisting primarily of methane, When…

Q: It is desired to cool 100 ton./h (tons/hour) of a mixture of hydrocarbons from 90 ºC to 60 ºC in a…

A:

Q: A single-effect evaporator is being used to concentrate 10,000 kg/h of tomato juice from 5% total…

A:

Q: A sample of gold weighing 227 grams is cooled then placed in a calorimeter containing 31 grams of…

A: Write the expression for heat of reaction as follows:Q = mCpTf-Ti      ......(1)

Q: Homework/l at a constant temperature, a gas gained an amount of heat (30 J). The gas expands and…

A: heat absorbed by the gas = 30 J word done on the ocean = 130 J for calculating the internal energy…

Q: A single effect evaporator is used to concentrate 10 000 kg / hr of tomato juice from 5% total…

A: Mass flow rate of feed, mF = 10000 kg/h Initial solid concentration of the feed juice, xS(F) = 0.05…

Q: Calculate the required mass flow rate of the fuel, in lbm/s, to provide a heat rate of 1800 Btu/s.

A:

Q: Determine the amount of steam required to heat the product

A: The mass flow rate of the product (m) = 1700 kg/hr Inlet temperature T1 = 20oC  Outlet temperature…

Q: Air in an ideal Diesel cycle is compressed from 35L to 0.35 L, and then it expands at constant…

A: The ideal Diesel cycle contains four steps. The first step is isentropic compression. The second…

Q: D. Argon (ideal gas) is contained in a piston-cylinder arrangement at a temperature of 120 °C and a…

A:

Q: A nickel steel rod 8 cm OD originally at temperature of 300° C is suddenly immersed in a liquid at…

A:

Q: (a) Air flow rate (kg/s) (b) the rate of heat transfer produced (J/s)

A:

Q: In a chemical production facility, a mixture containing 80% acetone and 20% water by mol will be…

A: Detailed explanation:Hope you will get your solution!Do rate me if it helps you!

Q: It is desired to produce 250 kg/h of steam methanol at 150 ° C and 1 atm from liquid methanol at 25…

A: • This problem is solved by taking one assumption that there is no heat loss to the surrounding.  •…

Q: Q1. The cooling water from the condenser of a power plant enters a wet cooling tower at (35° C) at a…

A: part you are looking for, so we are answering the first three subparts, please repost your question…

Q: A heat exchanger uses medium pressure steam at 10 bar and 350 C to heat cyclohexane vapor from 100 C…

A: Given, the mass flow rate of steam, m3 = 32 kg/h The pressure of steam, P3 = 10 bar The temperature…

Q: A tank containing a gas mixture of 70% C2H4 and 30% CO2 is cooled from 1000 K to 300 K. Calculate…

A:

Q: (a) Assume that there is a negligible thermal gradient in the wall of the container (dT/dr is…

A: Consider a spherical conatiner is used to store reacting chemicals, whichresults in a uniform heat…

Q: 4. There is a plan to use a hot flue gases from a methane fired furnace to preheat 1000 Sm3/hr of…

A:

Q: A combustor uses H2 gas and oxygen gas (02) as reactants. The equivalence ration is 0.3. Both…

A: In a combustion study, the ratio between the actual fuel/air ratio to the stoichiometric fuel/air…

Q: Q2): It is required to heat 10000 bbl/ day of crude oil (as given in case study of Lecture3) in a…

A: Mass rate of crude oil=10000 lb/day temperature change T1=220 °F to T2=622 °F  NHV of refining…

Q: Calculate the final temperature if 450 Kw of heat was added to a stream of air at 25 °C and 20 kg/hr…

A: Heat gained or lost by the system is based on the Law of conservation of energy. The heat lost by…

Q: Liquid carbon dioxide (100 ft³/s) with 600 Btu/lbm enthalpy feeds through a 4.5-inch diameter…

A: The liquid carbon dioxide with specific enthalpy is fed through the series of turbine and heater.…

Q: A 20-cm diameter copper ball is to be heated from 110°C to an average temperature of 170°C in 90…

A: Given that, Diameter of the sphere D = 20 cm = 0.2 m Initial temperature T1 = 110oC Final…

Q: 50kg of water at 120 C and 500 kPa is contained in a piston-cylinder. The heat is transferred to…

A: Work done can be defined as the force required to cause displacement in the body. Thermodynamically,…

Q: On a stove, a rigid high-pressure cooker has a volume of 0.003 m³ contains saturated liquid- vapor…

A: Given data: Volume of mixture = 0.003 m3 Initial temperature = 95 0C Initial quality = 2 %…

Q: Saturated steam at 260 °f is to be used to concentrate 10,000 Lb/hr sodium hydroxide solution…

A: Given Feed rate , mf = 10000  lb/h Feed temperature= Tf=100o F ( 37.8o C) To find a. steam…

Q: a) Calculate the convective coefficient h for water inside the pipe. b) Calculate the overall…

A:

Q: A thermocouple lead consists of a small sphere of constantan (a Cu-Ni alloy) having a diameter of 1…

A: Given:  Using Lumped heat capacity modal  Density (ρ) of 8920 kg/m3 , Thermal conductivity (k) of 24…

Q: 1.00 mole of an ideal monatomic gas is in a rigid container maintaining a constant volume of 2.00 L.…

A:

Q: Q 2. Air at 400°C and 1.7 bar flows through a horizontal 8.2-cm ID pipe at a velocity of 50.0 m/s.…

A: Thermodynamics is the study of effects of heat, work and energy on a system. In thermodynamics a…

Q: FT 1.0 Oil flowing at the rate of 6.0 kg/s (Cpm-2.1 kJ/kg ·K) is cooled in a 1-2 heat exchanger from…

A: So This completes your solution.I HOPE THIS HELPS YOU 🙏.PLEASE GIVE STUDENT RATING---->IF YOU…

Q: A fuel is burning at a rate of 0.6 kg/s. The heat of combustion is 82.6 kJ/g, and 40 % of the heat…

A: Write the expression for incident radiative heat flux as follows: Q = qxr4πR2Q = m∆H xr4πL+D22…