A steel cylinder containing 25 kg of CCl2 F2 in the form ofliquid and vapor is set outdoors on a warm day (25 °C).What is the approximate pressure of the vapor in thecylinder?Pressure =atm The figure below is a plot of vapor pressure versusdichlorodifluoromethane, CCl2 F2. The heattemperature forof vaporization of the liquid is 165 J/g, and the specific heatof the liquid is about 1.0 J/g. K.Vapor pressure (atm)87654321-40 -30 -20 -10 0 0 10 20 30Temperature (°C)

Answer: Variation of vapor pressure with temperature for CCl2F2 is given and we have to find out the…

Answered: A steel cylinder containing 25 kg of…

A steel cylinder containing 25 kg of CCl2 F2 in the form of liquid and vapor is set outdoors on a warm day (25 °C). What is the approximate pressure of the vapor in the cylinder? Pressure = atm

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: A gaseous hydrocarbon collected over water at a temperature of 19.2°C and barometric pressure of…

Q: The average or typical air pressure at sea level is 760 torr. This pressure may vary by ±15 torr…

A: The pressure at sea level is 760 torr. As we go up pressure decreases with altitude. So boiling…

Q: The relative humidity in a greenhouse at 50 °C is 82.0%. Calculate the vapor pressure of water vapor…

Q: In terms of their bulk properties, how do liquids and solids differ? How are they similar?

A: Solids and liquids are among the three state of matter they are different in terms of, the solids…

Q: The atmospheric pressure was measured at 741.1 torr. If Lynn measured the volume of the syringe that…

A: The vapor pressure of the liquid is calculated using Boyle's law. It states that pressure is…

Q: Describe the changes (if any) in potential energy and in kinetic energy among the molecules when…

A: The changes in potential energy and in kinetic energy among the molecules when gaseous PCl3…

Q: Which compound would you expect to have greater surface tension: acetone [(CH3)2CO] or water (H2O)?…

A: Water molecules possess hydrogen bonding and they are more polar in nature due to which, these…

Q: Hex-1-ene has a vapor pressure of 196.764 mmHg at 26.36 ∘C and 609.619 mmHg at 56.74 ∘C. What is…

A: If the vapor pressure of a liquid at a particular temperature is known then with the assistance of…

Q: Define the term hydraulic fracturing?

A: The term hydraulic fracturing has to be given,

Q: according to the phase diagram, estimate the minimum pressure (atm) that change the compound to…

A: Given Phase Diagram:To Determine:The minimum pressure that change the compound to liquid at 25oC

Q: Give reasons for the following: (a) Water boils at different temperatures depending on the atm…

A: Given that : We have to give reason for the following phenomenon : (a) Water boils at different…

Q: Two students were discussing about the Linde's process, when one of them suggested that Liquefaction…

A: The two factors on which liquification of gases depends are: Temperature Pressure Temperature: At…

Q: Why must boiling points be corrected for barometric pressure? Explain.

Q: Which has the greatest surface tension: bromoethane, chloroethane, ethane, or ethanol.?

A: The objective of the question is to determine which among bromoethane, chloroethane, ethane, or…

Q: what is the pressure of butane if 92.7 mL of butane was collected over water at 19.2 C and the…

A: Given: barometric pressure is 755.34 mm Hg vapor pressure of water is 15.15 mm Hg

Q: Rank the 4 types of solids (Ionic, molecular, covalent and metallic) in order of decreasing…

A: 1. Solid are classified into ionic solid, molecular solid, mettalic solid, covalent solid on the…

Q: The strongest noncovalent interactions are van der Waals forces. dipole-dipole interactions.…

A: Given Find out the strongest noncovalent interaction Concepts of noncovalent and covalent…

Q: 1) Consider the following reaction: Mg(s) + 2 HC1(aq) MgCl2(aq) + H2(9) The total pressure of gas…

A: The balanced reaction taking place is given as, => Mg (s) + 2 HCl (aq) --------> MgCl2 (aq) +…

Q: You have a bottle of a colorless liquid with no label. When you vaporize a sample of a liquid in a…

Q: Which compound would you expect to have greater surface tension: acetone [(CH3)2CO] or water (H2O)?…

A: Surface tension is the property of a surface to resist external force per unit area. It allows the…

Q: Which of the following will have the highest boiling point: methanol, carbon dioxide or sulfur…

A: Methanol has the highest boiling point because of intermolecular Hydrogen bonds between the…

Q: Name the type(s) of intermolecular forces that exists between molecules (or basic units) in each of…

A: Intermolecular forces are the forces of interaction which exist between neighboring atoms. It is…

Q: A 0.765-gram sample of impure potassium chlorate KClO3was decomposed by thermal decomposition into…

A: Given: Total pressure of gases = 777 mm Hg. Volume of gas = 222.50 mL = 0.22250 L…

Q: Predict whether beryllium or carbon would be a betterconductor of electricity in the solid state.…

A: Given elements, Beryllium and Carbon in the solid state

Q: Hydrogen bonds and van der Waals interactions are much weaker than covalent bonds, yet they are…

A: Given, Forces are : Hydrogen bonds, van der Waals interactions and covalent bonds Why hydrogen…

Q: of KClO3 that decomposed.

A: Volume of oxygen = 52.4 mL = 52.4/1000 = 0.0524.L Pressure of Oxygen = 765.2-22.6 = 742.6 mm Hg…

Q: Which of the following forms a molecular solid? gold CaO C, graphite C9H8O4

A: Given that : We have to identify which of the following forms a molecular solid : Gold CaO C,…

Q: A 5.30 g sample of solid MgSO, 7H,0 was heated such that the water turned to steam and was driven…

A: Given: The pressure, (P) = 1 atm. The temperature (T) = 100 0C = (73.15+100) = 373.15 K. The mass of…

Q: For liquids, which of the factors affect vapor pressure? humidity volume intermolecular surface…

A: Vapor pressure is the pressure caused by the evaporation of liquids. The three common factors that…

Q: The hydrogen and oxygen bonds of water are easily broken by iconic solids. Justify your answer.

A: The interaction of water is very different with polar particles than with nonpolar substances.…

Q: If a person took a dive into liquid nitrogen, what would most likely cause this person to lose their…

A: Aside from being exceedingly cold, liquid nitrogen is also inert, colourless, odourless,…

Q: 3. What is the phase change called when a non-boiling liquid turns into a gas?

A: Phase change is defined as the change in the state of a substance.

Q: Place the intermolecular attractions in order of their increasing strength and explain why. :…

A: Intermolecular force are the attractive force within a molecule. There are three types of…

Q: A steel cylinder containing 25 kg of CCl2 F2 in the form of liquid and vapor is set outdoors on a…

A: Answer: This question is based on the observational skill and understanding of the curve between…

Q: Give 5 types and properties of solid

A: A solid is a form of matter which possesses high rigidity and hence acquires a definite shape and…

Q: Which of the following compounds has the highest boiling point? ||| OIV OH OH OH HO OH IV

A: Boiling point affected by hydrogen bonding it increases with hydrogen bonding And also with…

Q: Describe the general relationship between evaporation rate (ΔT) and the relative strength of…

A: Evaporation is a process of conversion of a liquid into vapor. A liquid starts to boil when the…

Q: A metal reacts with aqueous hydrochloric acid to producehydrogen. The hydrogen (H2) is collected…

Q: A 355 cm^3 sample of air saturated with water vapor at 27 degrees celsius generates a total pressure…

A: The number of moles for a given chemical species refers to the ratio of mass to the molar mass. The…

Q: A 6.30 g sample of solid Na3PO4⋅7H2O was heated such that the water turned to steam and was driven…

A: Given, the pressure of steam =1.00 atmamount of solid Na3PO4.7H2O =6.30 grammolar mass of…

Q: A 0.765-gram sample of impure potassium chlorate KClO3was decomposed by thermal decomposition into…

A: Given: Total pressure of gases = 777 mm Hg. Volume of gas = 222.50 mL = 0.22250 L…

Q: How to calculate the boiling point of methylene chloride at 670mm Hg? (need some hint)

A: Given:Pressure = 670mm HgStandard boiling point of Methylene chloride (is being considered from…

Q: Can water stay liquid below zero degrees Celsius?

A: Freezing point of water is 0°C at 1 atm pressure and on increasing the external pressure freezing…

Q: Describe an experiment to show how pressure in liquid varies

Question

A steel cylinder containing 25 kg of CCl2 F2 in the form of
liquid and vapor is set outdoors on a warm day (25 °C).
What is the approximate pressure of the vapor in the
cylinder?
Pressure =
atm

The figure below is a plot of vapor pressure versus
dichlorodifluoromethane, CCl2 F2. The heat
temperature for
of vaporization of the liquid is 165 J/g, and the specific heat
of the liquid is about 1.0 J/g. K.
Vapor pressure (atm)
8
7
6
5
4
3
2
1
-40 -30 -20 -10 0 0 10 20 30
Temperature (°C)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

At standard temperature and pressure the molar volumes of CO2CO2 and NH3NH3 gases are 22.31 and 22.40 LL, respectively. The density of crystalline CO2CO2 at 160 KK is 1.56 g/cm3g/cm3. Calculate the molar volumes.
a sample of KClO3 (Mw = 122.55 g/mol) allowed to decompose in presence of MnO2. The resulting oxygen gas that is produced displaces 68.9 mL of water. The temperature of the water is 22.7oC and the barometric pressure is 745.9 mmHg. The vapor pressure of water at 22.7oC is 22.6 mmHg. Calculate the mass of KClO3 that decomposed. 2 KClO3(s) => 2 KCl(s) + 3 O2(g)
What would be a better solvent for sulfur dichloride, water or carbon tetrachloride?
Identify and describe the triple point of a gas from its phase diagram.
The amount of CaCO3 (s) in a rock sample shall be determined using gas volume geometry. The sample is added with excess hydrochloric acid and the gas which is then collected is collected over water. Explain how you can determine the amount of CaCO3 (s) in the sample by measuring the volume of gas generated. Suppose the experiment is performed at 25.0 ° C and a pressure of 1.00 atm. The measured volume of gas is 50.0 mL. How many grams of CaCO3 (s) is there in the sample? The water vapor pressure at 25 ° C is 23.76 mmHg. How much systematic error in the number of grams of CaCO3 (s) will we get if we do not take the water vapor pressure into account?
How many of the following forms a molecular solid? Ag • CO2 • RbI • Al203 • H20 Gold С10Н22 I2 3 5 4
At what temperature will water boil at the lowest point on earth, which is at the bottom of the Mariana Trench, some 11,034 meters below sea level. (Hint: find the pressure at the bottom of the Trench by converting 11,034 meters to mmHg using densities.
which of the following is true for liquid water that is boling? as it boils liquid attractive forces between liquid water molecules are broken allowing gasesous water molecules to excape as it boils liquid water breaks down into hydrogen gas and oxygen gas as it boils liquid water molecules realease two hydrogen ions as oxygen gas escapes. as it boils air trapped between water moleculs forms bubbles that rise to the surface and excape
Calculate the pressure inside a gas bubble of 0.040 cm radius in the water at a temperature of 20 °C. Assume that the pressure outside the bubble is 760 mmHg. The surface tension of the water is 72.25 x 10^-3 N / m.
Which of the following statement is incorrect for attractive intermolecular forces? O a. Important at intermediate separation. O b. Interaction scale measured in molecular diameters. O c. Ineffective when molecules are far apart. O d. It takes place at moderate pressure. Calculate the volume of oxygen produced when 0.5 moles of KCIO3 is heated at 101.325 kPa and 25 °C. 2 KCIO ; (s) → 2 KC(s) + 3 0,(g) O a. 2.180 m3 O b. 0.018 m3 O c. 1.183 m3 O d. 18.34 m3
Explain why cooling a full glass water bottle to −10 °C causes the bottle to crack.
3.6 g of methane is collected over water at STP for a total of 4.27 L at 25 degrees Celsius. What is the vapor pressure of water at this temperature?