A steel connecting rodis subjected to a completely reversed axial load of 160 kN. Suggest the suitable diameter of the rod using a factor of safety 2. The ultimate tensile strength of the material is 1100 MPa, and yield strength 930 MPa. Neglect column action and the effect of stress concentration. [Ans. 30.4 mm]

Q: Using the sample set of readings provided for Experiment 1 and taking the Young's Modulus of steel…

A: i hope its helpfull.thank you.

Q: Suppose a ball bearing under a given load F1 has a life of L1 = 334 kcycles. Further suppose that…

A:

Q: mechanical design A steel cantilever is 200 mm long is made from AISI 4340 quenched and tempered at…

A: after using scientific calculator The diameter d of the cantilever is approximately 5.2 mm

Q: You are required to size member FI of the truss shown at right using Western lumber with the…

A: given loads act at point A, B, C and D is 2000lb in magnitude   Yield stress in compression: 2100…

Q: 1. Determine the diameter size of rods AB, BC and C if ay = 3600 MPa and the safety factor SF= 2.…

A: Determine the diameter size of rods AB, BC and CA, if Yield stress = Sy = 3600 MPa and the safety…

Q: 1. Construct a critical end-load intensity against slenderness ratio graph for a range of pinned…

A:

Q: A steel [E = 207 GPa] tension member is being designed for an automobile. It must withstand a load…

A: Given data: E=207 GPaF=3050 Nδ=0.12 mmL=600 mmσy=440 MPaFOS=6.7 Need to determine the minimum…

Q: Using the interaction equation method, determine the magnitude of the largest load P that may be…

A:

Q: A 220 kg box is hanging from a steel wire with a Young's modulus of 200 GPa. You have a design…

A:

Q: N/mm. Detern terr ME aode if

A:

Q: Parvinbhai

A: The objective of the question is to determine the critical location where stress will be a maximum,…

Q: a) A bar of normalized AISI 4130 is subjected to a steady torsional stress of 103 MPa, an…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.