A steam pipe 20 cm in diameto 1. protected with a covering 6 cm is thick for which K = o.4 S.m. c Find the heat loss through a meter of the pipe it the sur face length of the pipe is 200 č and that of the outer Surface of 30 c. fo vering is

Q: Air cools the top and bottom of an electronic chip that uniformly generates heat. At steady-state,…

A: It is given that air cools the top and bottom of the electronic chip. The chip is subjected to…

Q: 3.2-4. Convection, Conduction, and Overall U. A gas at 450 K is flowing inside a 2-in. steel pipe,…

A:

Q: A steam pipe 20 cm in diametor is protected with covering thick for which K= 0.1 6 cm a S.M. C Find…

A: The rate of heat loss per unit meter length of the pipe is to be determined.

Q: 4) We solved the problem of heat conduction with a viscous heat source during the lecture with the…

A: Heat conduction with a viscous heat source

Q: A duct has a cross sectional area as shown below is used to carry heated water, the external surface…

A: The rate of heat loss by convection and radiation is to be calculated.

Q: rates of radiation heat transfer

A: In thermal radiation heat transfers from higher temperature  to lower temperature  without the…

Q: 6. In a long rectangle fin, its material has thermal conductivity of 200 w/ m.K and is subjected to…

A:

Q: Heat Transfer in a Solid Using Equation of Energy Change. A solid of thickness L is at a uniform…

A:

Q: Consider a 1.2-m-high and 2-m-wide glass window whose thickness is 6 mm and thermal conductivity is…

A:

Q: An uninsulated pipe passes through a room in which the air and walls are at 30°C. The outside…

A:

Q: An aluminum bar has a diameter of 11 cm and is initially uniform in temperatureat 300◦C. If it is…

A: Lumped system analysis assumes a uniform temperature distribution throughout the body, which implies…

Q: A steam pipe of i.d. 7.62cm and o.d. 10.2cm passes 1360 kg/hr of superheated steam at 260°c. The…

A: Given, The inner diameter of the pipe, di = 7.62 cm The outer diameter of the pipe, do = 10.2 cm The…

Q: Water is to be heated from 20°C to 70°C as it flows through a 40 mm internal Hiameter and 600 mm…

A: Given that T1 = 20 CT2 =70 Cd =40 mm =0.04 m l =600 mm =0.6 m m =0.2475 kgs

Q: 3. An array of 10 silicon chips, each of length L = 10 mm on a side, is insulated on one surface and…

A: If the temperature of each chip may not exceed 80 degree C, the maximum allowable power per chip is…

Q: Q2) Vapor at 225°C passes inside a stainless steel tube with length of (L-1m) and thermal…

A: Given data, Inside temperature of vapor, T1=225°C Length of the tube, L=1 m Inner diameter of the…

Q: 1-128 A thin metal plate is insulated on the back and ex- posed to solar radiation on the front…

A: Given  Solar radiation incident on plate = 700 w/m2 Absorptivity of plate = 0.7 Temperature of…

Q: An opaque horizontal plate is well insulated on the edges and the lower surface. The irradiation on…

A:

Q: A petrochemical storage tank is cylindrical in shape with a diameter of 6 m and a height of 10 m.…

A: Calculate the characteristic length of the cylinder as shown below:

Q: Problem 5: The energy lost from a 10 cm thick slab of steel is 50 W. Assuming the temperature…

A: Thick Ness of slab t = 10 cm                                  = 0.1 mThermal conductivity k = 45 W/…

Q: A harizantal tube carrying hat water has a surface temperature of 355.4 K and an outside diameter of…

A: Given data: Surface temperature of pipe = 355.4 K Outside diameter of pipe = 25.4 mm Room…

Q: A loaf of bread having a surface temperature of 373 K is being baked in an oven whose walls and the…

A: given Temperature of body Tb=373 K Temperature of the surrounding Ts=477.4 K Emissivity e=0.85…

Q: The material to be heated is in a long, cylindrical tube, and is viscous enough that any flow inside…

A: (1) To find the point at which the temperature is 99% of the maximum possible temperature increase,…

Q: Flue gas at 15 psia and 600 F is flowing across a single tube of an economizer with a velocity of 25…

A: Given data: Pressure of flue gas = 15 psia Temperature = 600 0F Diameter of tube = 4.5 in Velocity…

Q: A certain matenial 2.5 em thick, with a cross-sectional area of 0.1 m, has one side maintained at…

A: Given, T3=95oC,T2=62oC,T1=35oC,∆x=0.025 m Assume Linear variation of thermal conductivity,…

Q: Problem 1 A concrete wall (plane wall) of 20-cm-thick, is subjected to convection on both sides. In…

A:

Q: For the plane wall shown, solve the conduction equation, deriving an algebraic expression for the…

A: Conduction is a simple heat transfer process in which heat transfers from one end to another end of…

Q: Consider a surface with a surface area Aç = 10 cm²2. The right side of the surface is in contact…

A: Note: We are supposed to solve only one problem as per our guideline. Kindly send other questions as…

Q: - Hot water at 60 °C is routed from one 3. External flow (cylinder in cross flow with tube walls,.…

A: Given information:   The initial temperature of the hot water, TH = 60°C Fluid transfer occurs…

Q: = 1-D heat transfer.

A:

Q: An opaque horizontal plate is well insulated on the edges and the lower surface. The irradiation on…

A:

Q: the total heat loss per metre length of the reactor,

A:

Q: How much combined convection and radiation heat is taken by the cold air in contact with the sphere…

A:

Q: Calculate the heat loss from a double-pane glass window consisting of two pieces af glass, each…

A: Given: The window is made up of a glass of thickness i.e. L1 = L2 = 10 mm or 0.01 m each and in the…

Q: In a 1 m long double-pipe heat exchanger made of stainless steel, a temperature of 80 °C flowing…

A: a) The cold-water outlet temperature can be calculated by applying the energy balance as follows:…

Q: The circular base, 4 mm thick, of a pan with a diameter of 150 mm can be made of materials with…

A: The thickness of the base of the circular pan=4mm=0.004m Diameter of the base=150mm=0.15m The amount…

Q: A circumferential copper fins (1.5 cm long and 3mm thick) of rectangular profile are mounted on a…

A:

Q: coefficient (h). Dreive the critical insulation thickness and explaine the effect of re on the rate…

A:

Q: Steam is being transported in a pipe Outer diameter of the pipe is 8 cm, and the surrounding air…

A: (a) The rate of heat transfer from the pipe to the surroundings is to be determined.

Q: . A glass window of width W = 1 m and height H = 2 m is 5 mm thick and has a thermal conductivity of…

A: Given,the width of the glass window is, The height of the glass window is, The thickness of the…

Q: 5. A laboratory water bath has an immersed horizontal (cylindrical) water element, 2.54 cm. in…

A: Surface temperature of a water element immersed in water is to be calculated.

Q: On a hot summer day, a cylindrical beverage can of 7 cm in diameter and 15 cm in length was taken…

A: Given, d= 7cm= 0.07m, r= 0.07/2= 0.035m; h= 15cm= 0.15m. So total surface area =…

Q: A block iron Plate (k=25 ₁) at 300c is exPasodl to the surrounding air. at 30c. It con vects onel…

A: Given,