7. A spring is attached to the floor. When a 125 g mass is placed on top of the spring it compresses by 0.26 m. What is the spring constant of this spring? Formulas:Fc = mgv, = v, + atXy = x; + v,t + at?F = ma%3D2W = FdPE. = mghKE = -mv²2%3Dsmall force x BIG DISTANCE = BIG FORCE x small distanceFs = -kxP = =mp = ="FB = PrtuidVgAkg= 1000m3mg = 9.8P(water)Patm = 101 kPaConstants:s2

Given Mass, m = 125 g Deflection = 0.26 m

Answered: A spring is attached to the floor. When…

A spring is attached to the floor. When a 125 g mass is placed on top of the spring it compresses by 0.26 m. What is the spring constant of this spring?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 4.2‑kg brown hare walks on a horizontal beam (the beam's mass m = 2.8 kg and length a = 2.4 m). The beam is suspended with two ropes attached to the ends of the beam. What should be the distance between the hare and the left end of the beam so that the tension in the left rope is three times as big as the tension in the right rope? 1. The distance from the left end, b = If the hare is at the distance found in the previous question, calculate the tension in each rope. 2. The tension in the left rope, T1 = 3. The tension in the right rope, T2 = ------------------------------------------------------------------ A bike wheel has a radius of R = 0.62 m and a mass of m = 2.6 kg spins at 270 rpm. What is the angular momentum of the wheel? Assume that the wheel has a shape of a ring. The angular momentum of the wheel, L ? A typical bowling ball might have a mass of 7 kg and a radius of 12 cm. How fast the ball should spin to have the same angular momentum as the wheel from the…
The device weighs 200 kg and four parallel steel springs are used as vibration dampers. The frequency of the vibration produced by the device (i.e. the frequency of the force) is 100 Hz. The displacement of the vibration (amplitude) must not exceed 0.01. What is the spring constant of one spring to be? Give the answer in kN / m to one decimal place. The spring constants of parallel springs add up.
Considering the mass (m) and inclined angle (e) in the Figure 3, the weight component (N) normal to the inclined surface can be calculated as: * m Figure 3: O N= mg sin 0 O N= mg tan e N= mg cos 0 O N= mg
The figure on the left, below, shows a non-uniform bent rod with a mass of 5 kg. Your job is to determine the location of the center of gravity of this rod. You design an experiment: you connect a pin and cable to the rod such that it safely stays in static equilibrium under a force P that you apply. Then, you apply forces between 0-100 N, and measure the tension force on the cable using a cable tension meter. The results of your experiment are shown in the figure, on the right. Using this experiment, calculate (approximately) the horizontal distance (x in the figure) between point A and the center of gravity G of the bent rod. B C O I 20 cm 20 cm 60° D 50 cm Tension measurement [N] 60 50 40 30 20 -10 0 10 real data estimated fit 20 30 40 ܐܐܝ 50 P[N] 60 70 80 90 100
A 0.1 m 0.3 m The pendulum shown consists of a slender rod with mass per unit length of 2.8 kg/m, and a thin plate with mass per unit area of 10.0 kg/m2. In the figure, L = 1.7 m.
A spring has a natural length 10 in and requires a force of 5 lb to stretch the spring an additional 2 in beyond its natural length. Find the work done in stretching the spring 8 in beyond its natural length.
Question 3) The position of the head and neck and the forces acting on the head are shown in the figure. the center of gravity of the head with a mass of m-9 kg is located at point C. Neck extensor muscles November 21, 2016 by making a y=55° angle with the vertical from point B to the skull, the neck muscle force with a intensity of FmNovember85N is affected. The center of the atlantooccipital joint is located at point B takes. For this flexion position of the head, F, which makes an angle a with the bed from point A, is influenced by the joint response force. (g take the gravitational acceleration as 9.81 m/s2.) According to this; a) Calculate the angle a where the Fjeklem reaction force is built with the horizontal. b) Calculate the Fjeklem reaction force. (Write your result in unit N.) W FM
A spring exerts a force of 17 lbf on a piston inside a piston cylinder device. The mass of the piston is 3.5 lbs and the cross sectional area of it is 0.00018 ft^2. Determine the pressure inside the piston cylinder device.
Question 8 Which of the following expresses the law of conservation of mass for an open system? Min mout O Min-M₂-M₁ O min-mout=m₁-m2 O min-mout=m₂-M₁ O Min-Mout=m₂
An unknown mass and a 12 kg mass are tied to a light string and hung over a frictionless pulley. If the tension in the string is 50 N, what is the unknown mass?
The pendulum in (Figure 1) consists of a 1.5-kg disk and slender rods AB and DC which have a mass per unit length of 2 kg/m. Assume d = 0.8 m. Figure 0.2 m- A d -0.5 m- B 1 of 1 D Part A Determine the length L of DC so that the center of mass is at the bearing O. Express your answer to three significant figures and include the appropriate units L = 7.39 HA Part B m Submit Previous Answers Request Answer Ⓡ X Incorrect; Try Again; 4 attempts remaining Io = 78.7 V=| ΑΣΦ. 11 | vec ? What is the moment of inertia of this assembly about an axis perpendicular to the page and passing through point O? Express your answer in kilograms multiplied by squared meter to three significant figures. Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining ? Review kg.m²
A gas is contained in a cylinder behind a frictionless piston of diameter 0.1 m and mass 25 kg. When an additional mass M is placed on the piston the gage pressure of the gas becomes 2.0 bar. The local barometric pressure is 775 mm of mercury. (a) Calculate (i) the mass of M and (ii) the absolute pressure of the gas in the cylinder. (b) The piston is held in this position with the aid of a lock on the outside while heat is supplied to the gas until its absolute pressure becomes 4 bar. Calculate the force on the lock in the final equilibrium state.