A space to be air-conditioned has a sensible heat load of 34.9 hp and a latent heat load of 6.97 hp. The space is to maintained at 24°C DB and 17°C WB. Outside air is at 32°C DB and 24°C WB temperatures. With a re-heater to satisfy the space conditions, the conditioned air will enter the space at 18°C. If 40% of the supply air, is fresh air and the rest is re-circulated, find the specific humidity of outside air in kgv/kgda. The mass flow rate of supply air, ms is 312 kg/min. Take the mass flow rate of supply air, (ms = the sum of air mass flow rate to dissipate the sensible heat, msh, and the air mass flow rate to dissipate the latent heat, mlh). Take cp of dry air = unity.

A space to be air-conditioned has a sensible heat load of 34.9 hp and a latent heat load of 6.97 hp. The space is to maintained at 24°C DB and 17°C WB. Outside air is at 32°C DB and 24°C WB temperatures. With a re-heater to satisfy the space conditions, the conditioned air will enter the space at 18°C. If 40% of the supply air, is fresh air and the rest is re-circulated, find the specific humidity of outside air in kgv/kgda. The mass flow rate of supply air, ms is 312 kg/min. Take the mass flow rate of supply air, (ms = the sum of air mass flow rate to dissipate the sensible heat, msh, and the air mass flow rate to dissipate the latent heat, mlh). Take cp of dry air = unity.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A homeowner is trying to decide whether to heat with a furnace rated at 95% efficiency or by an electrically powered heat pump. She lives in a town where electricity is produced by a coal-fired power plant that claims to operate with 1st law efficiency that is 55% of the Carnot limit. The heat pump's CoP is advertised to be 40% of the Carnot limit. For what range of outside temperatures To would the 2nd law efficiency of the furnace be greater than that of the heat pump? Assume T+ = 400°C, T- = T= 40°C. %3D
A cold storage is to be maintained at – 5°C while the surroundings are at 35°C. The heat leakagefrom the surroundings into the cold storage is estimated to be 40 kW. The actual C.O.P. of therefrigeration plant used is one third that of an ideal plant working between the same temperatures.Find the power required to drive the plant.
A heat pump operates with Refrigerant 134a as the working fluid. You are required to analyze its performance, and compare it with Camot heat pump. The data of the heat pump is as under: 23 - Thermodynamies-II Page 1 of 3 The heat pump is presently providing heating at a rate of 12 kW to maintain the interior of a building at 20°C. Outside temperature is 5°C. The refrigerant enters the compressor at 2.4 bar and increases the pressure to 8.0 bar. Efficiency of the compressor is 80%. a Temperatures at the principal states of the cycle, each °C b. Power input to the compressor, in kW c. Coefficient of performance Relate its performance with the specifications provided by the vendor i.e. COP = 8.5 and identify the possible reasons of differences. Draw Ts diagram
b. A refrigerating system using Freon-12 has an evaporator saturation temperature of - 25°C and a condenser saturation temperature of 35°C. The vapor is dry saturated at entry to the compressor and has a temperature of 65°C after compression to the condenser pressure. There is no undercooling of the liquid in the condenser. i. Calculate the input power required by the compressor per kW of refrigeration. ii. Calculate the COPRef of the refrigerating system. ii. Show the operating cycle of the refrigerating system on a T-s diagram.
Can you also show the T-s and P-h diagrams? A Single Stage Vapor Compression (SSVC) refrigeration system has a cooling capacity of 6 tons. The discharge of the evaporator is at -20°C & 0.1 MPa and the discharge of the condenser is at 30°C & 1.0 MPa. Determine the following: (a) the COP of the system, (b) the Energy Efficiency Ratio in kJ/hr/W, (c) the HP/ton of the system, (d) the Refrigerating Efficiency of the system.
An ammonia refrigerating system has a load of 250 kW and operates at a condensing pressure of 1400 kPa and an evaporating temperature of -20°C. The refrigerant exits at the evaporator with a 5- degree superheat. The vapor enters the compressor suction at 10-degree superheat. The compressed vapor is discharged from the compressor at the condensing pressure and 150°C. The refrigerant exits the condenser as saturated liquid. a. State the enthalpies at each point: Point enthalpy kJ/kg h kJ/kg kJ/kg h2 kJ/kg h3 kJ/kg h4 Answer: kg/sec b. Calculate the mass flow of refrigerant Answer: kW C. Determine the size of the motor drive if the mechanical efficiency of the motor- compressor is 77%. Answer: kW Calculate the total heat rejected in the condenser. d. Determine the refrigerating efficiency of the system. Answer: е.
1.) An actual 35 TR refrigerating system operates using R22 refrigerant. Refrigerant enters the evaporator at 264.29 kPa and leaves saturated vapour at 244.83 kPa. Refrigerant enters the compressor at – 10°C. Refrigerant leaves the compressor at condensing pressure of 1400 kPa and 70°C and leaves the condenser at 30°C. Compression process is polytropic with n = 1.23. Draw the p-h diagram of the cycle (labeling the pressures and temperatures in each condition). (b) Define and determine the necessary enthalpies and determine the following: (c) IHP and (d) heat rejected during compression, kW
In an ammonia refrigeration system, the pressure in the evaporator is 251 kPaa, and the ammonia at the evaporator entry is 0.1511 dry while at exit is 0.95 dryIf the rate of ammonia circulation is 4.56 kg / m * i * n , determine the refrigerating capacity of the system. Use the properties of ammonia from refrigerantstable
A refrigeration system using refrigerant 12 is to have a refrigerating capacity of 80 kW. The cycle is a standard vapor-compression cycle in which the evaporating temperature is -15°C and the condensing temperature 30°C. At the entrance to the evaporator, what is the fraction of vapor in the mixture expressed on a mass basis? 0.97 0.29 0.92 0.27
7. A refrigerator using Freon-12 operates between saturation temperatures of – 10°C and 60°C, at which temperatures the latent heats are 156.32 kJ/kg and 113.52 kJ/kg respectively. The refrigerant is dry saturated at entry to the compressor and the liquid is not undercooled in the condenser. The specific heat of liquid freon is 0.970 kJ/kg K and that of the superheated freon vapour is 0.865 kJ/kg K. The vapour is compressed isentropically in the compressor. Using no other information than that given, calculate the temperature at the compressor delivery, and the refrigerating effect per kg of Freon. [Ans. 69.6°C ; 88.42 kJ/kg]