A solenoid used to produce magnetic fields for research purposes is 2.2 m long, with an inner radius of 28 cm and 1500 turns of wire. When Part A running, the solenoid produced a field of 1.2 T in the center. Given this, how large a current does it carry? Express your answer using two significant figures. ? I = kA Submit Request Answer

A solenoid used to produce magnetic fields for research purposes is 2.2 m long, with an inner radius of 28 cm and 1500 turns of wire. When Part A running, the solenoid produced a field of 1.2 T in the center. Given this, how large a current does it carry? Express your answer using two significant figures. ? I = kA Submit Request Answer

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The earth's magnetic field, with a magnetic dipole moment of 8.0 x 1022 A m², is generated by currents within the molten iron of the earth's outer core. Suppose we model the core current as a 3000-km-diameter current loop made from a 1000-km-diameter "wire." The loop diameter is measured from the centers of this very fat wire. ▼ Part B What is the current density J in the current loop? Express your answer to two significant figures and include the appropriate units. J = Submit Part C Лоор Jwire μA Value Submit Request Answer To decide whether this is a large or a small current density, find the ratio of the current density J in the current loop to the current density of a 3.0 A current in a 1.0-mm-diameter wire. Express your answer using two significant figures. 17 ΑΣΦ VO Units Request Answer ? ?
It's urgent please do quickly.
a.) A wire 4 m long has a mass of 224 g. The wire is connected to an emf. What is the minimum current in the wire that would allow it to levitate above the ground in a magnetic field of magnitude0.4 T? Round your answer to 2 decimal places b.) Per previous question, what direction must the current flow?
a L I b L Two long, thin, parallel wires are suspended via 7 cm strings as shown in the Figure above. Each wire has a linear mass density of 55 g/cm. The wires carry identical currents in opposite directions, as shown. a. Use (make a copy) panel b of the Figure above to draw a Free Body Diagram showing the forces acting on one of the wires. b. Find the current in the wires if the system is in equilibrium when the suspending strings make a 6.5 degree angle with respect to the vertical.
Please solve the question correctly and also be sure to give the correct units. Thank you!
I need help understanding this problem. These are the correct answers I just need a break down of how to get them.
Two long, parallel wires separated by 2.95 cm carry currents in opposite directions. The current in one wire is 1.45 A, and the current in the other is 3.20 A. (a) Find the magnitude of the force per unit length that one wire exerts on the other. 1.572e-5 Your response differs from the correct answer by more than 10%. Double check your calculations. N/m
A compass needle points 19° E of N outdoors. However, when it is placed 12.0 cm to the east of a vertical wire inside a building, it points 35 ° E of N. The Earth's field is the same at both positions of the compass, it is 0.50×10-4 T and is horizontal. What is the magnitude of the current in the wire? Express your answer using two significant figures and include the appropriate units. I = Submit Part B Value east west up μÀ What is the direction of the current in the wire? down Request Answer Units ?
Three long, parallel conductors carry currents of I = 1.89A. The figure below is an end view of the conductors, with each current coming out of the page. If a = 1.34cm, determine the magnitude of the magnetic field at point A. 3.76x10-5 T D Determine the magnitude of the magnetic field at point B. O Determine the magnitude of the magnetic field at point C.
B INSTRUCTION Solve the following problems. ANSWER ONLY TWO OUT OF THREE QUESTIONS. Show your complete solutions. NOT FOLLOWING OF INSTRUCTIONS will be a deduction of 10 POINTS from the total score. 1.A proton enters a magnetic tield of flux density 1.5 Wb/m² with a vetocity of 2.0 x 107 m/s at an angle of 30° with the field. Compute the force on the proton. 2.A steady current of 2 A in a coil of 400 turns causes a flux of 104 wb to link (pass through) the loops of the coil. Compute the average back emf induced in the coit it the current is stopped in 0.08 seconds. 3. A coil of 50 loops is pulled in 0.020 seconds from between the poles of a magnet, where its area intercepts a flux of 3.1 x 10-4 Wb, to a place where the intercepted flux is 0.10 x 10-4 Wb. Determine the average emf induced.
A student set up an experiment to determine the magnetic field strength of a magnet as shown in the diagram. The student makes the reading on the balance as zero and places the magnet on the balance. The balance reads 132 g . He switches on the current from a supply and notices that the reading on the balance increases to 162 g while the current shown by the ammeter is 27 mA. Find the magnetic field strength in tesla of the magnet if the length of the wire inside the field is 12 cm.
The figure below shows a cross-sectional view of three parallel wires each carrying a current of 20.0 A. The currents in wires B and C are out of the page while that in wire A is into the page. If the distance R is equal to 4.50 mm, calculate the magnitude of the force (in mN) on wire A (which has a length of 5.60 m) due to the other two wires. Round your answer to 1 decimal place.