A solenoid passes through the center of a wire loop, as shown in (Figure 1). The solenoid has 1200 turns, a diameter of 2.0 cm. and is 7.5 cm long. The resistance of the loop is 0.072 . Part A If the current in the solenoid is increased by 1.4 A in 50 ms, what is the induced current in the loop?

A solenoid passes through the center of a wire loop, as shown in (Figure 1). The solenoid has 1200 turns, a diameter of 2.0 cm. and is 7.5 cm long. The resistance of the loop is 0.072 . Part A If the current in the solenoid is increased by 1.4 A in 50 ms, what is the induced current in the loop?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: In the figure, a 96-turn coil of radius 2.7 cm and resistance 5.00 is coaxial with a solenoid of 270…

A: Given: The number of turns of the coil is 96. The radius of the coil is 2.7 cm. The resistance of…

Q: The long straight answers, state the or no current) in th

A: Answer (a) Clockwise (b)Counter clockwise

Q: Part A A toroid has a 49.4 cm inner diameter and a 54.8 cm outer diameter. It carries a 24.3 A…

Q: A single coil metal detector works by moving a coil over the sand at a beach. Suppose a penny (which…

A: Metal detector works on principal of eletromagnetic field. They work by transmitting electromagnetic…

Q: Part A What is the induced current in the inner loop? Express your answer with the appropriate um >…

A: Here,d = 110 mm r = 110/2 = 55 mmR = 1.30×10-2 Ωt = 0.100 sInner diameter = 1.70 mmInner Radius =…

Q: A solenoid is given with 300 turns (N1), Radius of 2 cm and 50 cm (e) length as shown in the…

Q: An 8.0cm x 8.0 cm square loop is halfway into a magnetic field that is perpendicular to the plane of…

A: Consider,Given data,Resistance,R=0.030Ωl=8cm=8×10−2mmass=m=10g=10×10−3 kg(a) As the magnetic field…

Q: A single loop of wire with an area of 9.07x10-2 m² is in al uniform magnetic field that has an…

Q: 3. A wire is moving on frictionless rails in a uniform magnetic field, as shown to the right. The…

A: We have a wire of length L=5 cm=0.05 m which is moving along a rail experiencing a magnetic field of…

Q: At t = 0, the current through a 80.0 mH inductor is 54.0 mA and is increasing at the rate of 68.5…

Q: p-13 F, what is the value c jures and include approp

Q: The figure shows a 15 cm -long metal rod pulled along two frictionless, conducting rails at a…

A: The induced current (i) can be given as, i = eR = BlvR, where e is the emf induced (that is = Blv),…

Q: A loop conductor of area 1.0 m2 is positioned perpendicular to a uniform 1.5 T magnetic field.…

Q: The diagram shows a rectangular loop of wire moving away (in the direction of the blue arrow) from a…

A: The given diagram shown that a rectangular loop having some resistance, are moving away from the…

Q: Part A A potential difference of 45 mV develops between the ends of a 18-cm-long wire as it moves…

A: the potential difference b/w the ends of rod of length l moving with speed v perpendicular magnetic…

Q: The loop in the figure is being pushed into the 0.60 T magnetic field at 25 m/s. The resistance of…

A: magnetic field = B = 0.6 TSpeed = V = 25 m/slength = L = 5 Cm = 0.05 mresistance= R = 0.5 Ohms

Q: The two springs in the figure each have a spring constant of 13 N/m. They are compressed by 0.70 cm…

A: spring constant of each wire = k = 13 N/m compressed length = x = 0.7 cm = 0.007 m length = L =20 cm…

Q: For each of the cases in which you predicted that there will be an induced current, draw a diagram…

A: NOTE: since you have posted a question with multiple sub parts we will provide the solution only…

Q: A single turn coil of radius 4.50 cm is held in a vertical plane and a magnet is rapidly moved…

A: Given Data: Radius (r) = 4.50 cm = 0.045 m.Time (t) = 0.120 s.Initial magnetic field (Bi) = 0.305…

Q: Please help me with this. Don't use Chatgpt, I need real help.

A: Step 1: For question 1, the propagating electric field applies a force on the electron. The electric…

Q: Part A A transformer has 360 turns in the primary coil and 200 in the secondary coil. Part B Part C…

Q: An 6.0cm x 6.0 cm square loop is halfway into a magnetic field that is perpendicular to the plane of…

Q: Part A The generator of a car idling at 1500 rpm produces 17.4 V. What will the output be at a…

Q: Part A A fixed 17.1-cm-diameter wire coil is perpendicular to a magnetic field 0 49 T pointing up In…

A: Given Aware coil of diameter 17.1 CM has a magnetic field 0.49 T pointing up in 0.28 s the field is…

Q: The figure shows a 28-cm-diameter loop in three different magnetic fields. The loop's resistance is…

Q: Part C A circular conducting loop is placed in a magnetic field that is changing at a constant rate…

A: As per Faraday's law of electromagnetic induction, the magnitude of induced emf is equal to the rate…

Q: of yours was making ing mea irements large solenoid that is connected to an ac voltage source.…

Q: Two coils are wound around the same cylindrical form. When the current in the first coil is…

A: Given Data:Number of turns of the second coil (N2) = 23.Currentt through the first coil (I1) = 1.25…

Q: This loop is in the x-y plane and B = z Bosin wt with BO positive. What is the amplitude of the…

A: We will first write an expression for voltage induced in the circuit when magnetic flux associated…

Q: A transformer consists of 600 primary windings and 800 secondary windings. The Voltage across the…

Q: (Eigure 1) shows a 100-tur coil of wire of radius 18 cm in a 0.35 T magnetic field. The coil is…

Q: Part A A 450-turn solenoid, 28 cm long, has a diameter of 4.0 cm .A 18-turn coil is wound tightly…

Q: A 14.2 cm diameter wire coil is initially oriented so that its plane is perpendicular to a magnetic…

Q: Please answer part B!! the answer is NOT 0.213 m/s

Q: Part A A solenoidal coil with 30 turns of wire is wound tightly around another coil with 340 turns.…

A: A solenoid is a coil of wire which is capable of creating a magnetic field like a bar magnet. it…

Q: A 100-turn, 4.0-cm-diameter coil is at rest with its axis vertical. A uniform magnetic field 60°…

A: Diameter of coil(d) =4cm Radius of coil(r) =2Cm Area of coil(A) of one term=πr2 =3.14*(0.02)…

Q: A small, 2.00-mm-diameter circular loop with 1.30×10-2 is at the center of a large 110-mm-diameter…

A: Given data, The radius of the smaller loop, r1=2×10-32 m=1×10-3 m The radius of the large loop,…

Q: In the circuit shown in, S₁ has been closed for a long enough time so that the current reads a…

Q: The rectangular loop in the figure has 2.3×10-2 N resistance. (Figure 1) Part A What is the induced…

Q: A wire carries a current I whose magnitude is quadratically increasing with time. The wire and the…

Q: An inductor with inductance L = 0.400 H and negligible resistance is connected to a battery, a…

A: The instant switch S is closed, the inductor L will act as a short circuit. Hence, resistances R1…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Item 7
7 of 8
>
I Review | Constants | Periodic Table
A solenoid passes through the center of a wire loop, as shown
in (Figure 1). The solenoid has 1200 turns, a diameter of
2.0 cm. and is 7.5 cm long. The resistance of the loop is
0.072 N.
Part A
If the current in the solenoid is increased by 1.4 A in 50 ms. what is the induced current in the loop?
Express your answer with the appropriate units.
圈]
Iinduced =
Value
Units
Submit
Request Answer
Provide Feedback
Next >
Figure
1 of 1
>
Induced current
B is increasing.
Solenoid

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An inductor with inductance L = 0.400 H and negligible resistance is connected to a battery, a switch S, and two resistors, R1 = 11.0n and R2 = 15.0 2 (Eigure 1). The battery has emf 96.0 V and negligible intemal resistance. S is closed at t = 0. Part A What is the current i just after S is closed? Express your answer with the appropriate units. ? HA i = 0 Figure R2 R L ww
A single loop of wire with an area of 0.0680 m² is in a uniform magnetic field that has an initial value of 3.80 T, is perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.210 T/s. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Emf and current induced in a loop. Part A What emf is induced in this loop? Express your answer in volts. —| ΑΣΦ lɛl = Submit Part B Request Answer I = ? If the loop has a resistance of 0.450 , find the current induced in the loop. Express your answer in amperes. —| ΑΣΦ V ? A
Help.
What is the induced voltage between the ends of the sliding wire in the figure below if the wires speed is 42 cm/s, its length 22 cm, the magnitude of the magnetic field 3.2 × 10^−3 T, and the resistance of the resistor 1.6kΩ? What is the current through the resistor? The wires velocity is perpendicular to the magnetic field.
A single turn coil of radius 4.50 cm is held in a vertical plane and a magnet is rapidly moved relative to the coil as shown in the diagram below. N coil The field inside the coil changes from 0.370 T to 0.550 T in 0.120 s. If the resistance of the coil is 3.70 N, what are the magnitude and direction of the induced current in the coil as viewed from the side of the magnet? magnitude mA direction ---Select---
Part A A charged capacitor with C = 640 µF is connected in parallel to an inductor that has L = 0.450 H and negligible resistance. At an instant when the current in the inductor is i = 1.80 A , the current is increasing at a rate of di/dt = 89.0 A/s. During the current oscillations, what is the maximum voltage across the capacitor? Express your answer to three significant figures and include the appropriate units. ? HA Vmax = Value Units Submit Request Answer
Is this correct? Please explain
Part A A circular wire loop of radius r = 18 cm is immersed in a uniform magnetic field B = 0.425 T with its plane normal to the direction of the field. If the field magnitude then decreases at a constant rate of -1.1x10-2 T/s, at what rate should r increase so that the induced emf within the loop is zero? Express your answer using two significant figures. ? = 0.472 mm/s dt
A bar magnet moves away from a coil, as shown in the figure. What is the direction of the induced current in resistor ?? (from ? to ?, from ? to ? or zero)? Briefly explain.
An electric doorbell uses an electromagnet to pull on a steel hammer that rings the bell. The electromagnet has inductance 65.0 mH and resistance 6.36 N (meaning you can treat it as an LR circuit with the inductance in series with the resistance). It operates from a 6.00-V source. Part A How long does it take for the current in the electromagnet to reach 0.650 A? Express your answer with the appropriate units. HA t = Value Units Submit Request Answer