An 6.0cm x 6.0 cm square loop is halfway into a magnetic field that is perpendicular to the plane of the loop. The loop's mass is10 g and its resistance is 0.050 $2. A switch is closed at t=0 s. causing the magnetic field to increase from 0 to 1.0 T in 0.010 sPart AWhat is the induced current in the square loop?Express your answer with the appropriate units.Submit1= 7.2AYou have already submitted this answer. Enter a new answerNo credit lost Try again.Part BμÁPrevious Answers Request AnswerSubmitWith what speed is the loop "kicked away from the magnetic field?Hint: What is the impulse on the loop?Express your answer with the appropriate units.0.06HA?→ 0 63 ?mSPrevious Answers Request AnswerX Incorrect: Try Again; 2 attempts remaining

Answered: Image /qna-images/answer/53f8e2de-5c5e-42fa-8f90-0ec74cd65dc6.jpg

Answered: An 6.0cm x 6.0 cm square loop is…

Similar questions

The back emf in a motor is 31 V when operating at 1300 rpm . Part A What would be the back emf at 2400 rpm if the magnetic field is unchanged?
In the diagram below, a bar magnet moves toward a solenoid. Use Lenz's а. Law to find the direction of the induced current in the solenoid and then determine the direction of current flow through the resistor connected to the solenoid. Motion N The direction of the current through the resistor is: A. upward B. downwards In the diagram below, a solenoid moves toward a bar magnet. Use Lenz's Law to find the direction of b. the induced current in the solenoid and then determine the direction of current flow through the resistor connected to the solenoid. Motion The direction of the current through the resistor is: O A. upwards B. downwards
I decreasing In the figure above, a loop is located near a long wire with current flowing as indicated. 8The original B field penetrating the loop points the page. O If the current in the wire decreases, then the magnetic flux o in the loop 0Therefore, the loop generates an induced B field that points the page. e This induced B field is due to an induced current that flows in the loop.
The magnetic field perpendicular to a single 17.2- cm -diameter circular loop of copper wire decreases uniformly from 0.750 T to zero. Part A If the wire is 2.75 mm in diameter, how much charge moves past a point in the coil during this operation? The resistivity of copper is 1.68 ×10−8Ω⋅m .
A fixed 19.6-cm-diameter wire coil is perpendicular to a magnetic field 0.58 T pointing up. In 0.23 s, the field is changed to 0.24 T pointing down. Part A What is the average induced emf in the coil? Express your answer to two significant figures and include the appropriate units. HÅ ? E = Value Units
You pull a bar magnet out of coil of wire. What are the directions of the induced current and magnetic field? Draw a sketch of the situation, noting whether your answer would change if the magnet’s south pole left the wire instead of the north pole.
both parts plz
A circular loop of wire lies in a plane perpendicular to a magnetic field. The magnetic field has a magnitude of 1.3 T and points out of the page as shown in the figure. The radius of the loop is 18 cm and it has a resistance of 3.2 Ω. Find the induced emf in the loop of wire if the magnetic field doubles in magnitude in 1 seconds. What is the induced current in the loop? In which direction is the induced current?
A single loop of wire with an area of 0.0680 m² is in a uniform magnetic field that has an initial value of 3.80 T, is perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.210 T/s. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Emf and current induced in a loop. Part A What emf is induced in this loop? Express your answer in volts. —| ΑΣΦ lɛl = Submit Part B Request Answer I = ? If the loop has a resistance of 0.450 , find the current induced in the loop. Express your answer in amperes. —| ΑΣΦ V ? A
What is the induced voltage between the ends of the sliding wire in the figure below if the wires speed is 42 cm/s, its length 22 cm, the magnitude of the magnetic field 3.2 × 10^−3 T, and the resistance of the resistor 1.6kΩ? What is the current through the resistor? The wires velocity is perpendicular to the magnetic field.
Part A A 14 cm-diameter circular loop of wire is placed in a 1.28 T magnetic field. When the planc of the loop is perpendicular to the field lines, what is the magnetic flux through the loop? Express your answer to two significant figures and include the appropriate units HA Value Units Submit Request Answer Part B The plane of the loop is rotated until it makes a 45 ° angle with the field lines. What is the angle in the equation Pg = BA cos e for this situation? Express your answer using two significant figures. 0 = Submit Request Answer Deersen
Pls help ASAP.

SEE MORE QUESTIONS