(b)Bathroom sinks and some other fixtures include an overflow opening in the basin. Thisopening is located on the wall and near the top of the basin. The overflow openingserves two important functions:If the water tap is left on while the drain stopper is closed, the opening willchannel water down into the drain opening rather than letting is spill out of thesink onto the floor.The overflow allows the sink to drain faster by introducing air into the system.A sink with a dimension given in Figure Q2(b), has water flows into it at a rate of8 L/min. If the drain stopper is closed and water level in the sink remains constant,determine the average velocity of water flows through the 3.0 cm diameter overflowhole.Front3 cm diameteroverflow holesQ-8 L/min15 3/4| 40 cm15 cmSide(a)Figure Q2: (a) Picture of the sink; (b) Sink dimension(Ь)

Answered: Image /qna-images/answer/f82a7fdc-0d76-43f4-98b2-2d28b36cbe5d.jpg

A sink with a dimension given in Figure Q2(b), has water flows into it at a rate of 8 L/min. If the drain stopper is closed and water level in the sink remains constant, determine the average velocity of water flows through the 3.0 cm diameter overflow hole.

A sink with a dimension given in Figure Q2(b), has water flows into it at a rate of 8 L/min. If the drain stopper is closed and water level in the sink remains constant, determine the average velocity of water flows through the 3.0 cm diameter overflow hole.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. Air flows at the rate of 1.5 m²/s through a horizontal pipe with a gradually reducing cross section as shown in the figure. The two cross-sections of the pipe have diameters of 400 mm and 200 mm. Take the air density as 1.2 kg/m² and assume inviscid incompressible flow. The change in pressure (P2-P1) (in kPa) between sections 1 and 2 is 200 mm Air Flow 400 mm 1.5 m/s (A) -1.28 (B) 2.56 (C) -2.13 (D) 1.28
An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per second. At the same time, receiving a fluid at a rate of 225 US Gal per minute. At a certain post the tank is considered to be quarter full. Find the (a) water level and the (b) mass change In the tank 15 minutes later. Given: tank diameter = 10 ft tank height = 20 ft
A horizontal pipe of diameter 550 mm is suddenly contracted to a diameter of 300 mm. The pressure intensity in large pipe is given as 14 N/cm2 and the flow velocity in the larger pipe is 2 m/s. Find:- (a) The rate of flow of water through a horizontal pipe. (b) Loss of head due to sudden contraction. (c) Pressure intensity in smaller pipe.
The 30cm long left coronary artery is 4.6mm in diameter. Blood pressure drops by 3.0mm of mercury over this distance. answer the following: part(A): what is the average blood speed through this artery?(express your answer with the appropriate units.) part(B): what is the volume flow rate in L/min through the artery?
Water flows at the rate of 5 ft/s through an inclined pipe. At point A, where the diameter is 12 inches, the pressure is 15 psi. At point B, the diameter is 6 inches and the center of the pipe is 2 feet lower than at point A. a. Draw a clear diagram of the pipe system that indicates the following: (a-1) water flow reflecting the quantities involved in describing fluid flow and (a-2) the object of interest and the quantities that describe Bernoulli's equation. b. Write the Bernoulli's Equation using subscripts U ad L for the upper and lower points respectively and determine the pressure at point B?
A tank with radius (1m) and a height of (4m) is initially filled with water. Then the hole at the bottom of the tank (shown in the figure) is opened and the water flows out by gravitational. Find the time required to fill an (8 m³) vessel below the tank. • Use the gravitational acceleration g = 9.807 m\sec². R= 1 m 2 m 2 m Cd = 0.9 a =2 * 10-3 m? Vessel of 8 m3
Water flows from a very large tank through a 5 cm diameter tube. The dark liquid in the manometer is mercury. Estimate the velocity in the pipe and the volumetric flow rate of discharge from the tank. Assume the flow is frictionless. 4 m 75 cm 5 ст Flow 15 cm Mercury Hint: use Bernoulli Equation.
Determine the head loss due to friction of an oil of specific gravity 0.77 and viscosity 0.85 poise is flowing through a pipe at the rate of 3.7 m/s. Assume the pipe diameter as 29 cm and the length of the pipe as 5618 cm. Oil Density (in kg/m3) Reynold's Number - Co-efficient of friction - Head loss due to friction
Water is flowing in a fire hose with a velocity of 1.0 m/s and a pressure of 200000Pa. At the nozzle the pressure decreases to atmospheric pressure (101300 Pa), there is no change in height. Use the Bernoulli equation to calculate the velocity of the water exiting the nozzle. (Hint: The density of water is 1000 kg/m3 and gravity g is 9.8 m/s2.