A single plate friction clutch with both sides of plate being effective is used to transmit power at an engine speed of 2000 rpm. It has outer and inner radii 10 cm and 8 cm respectively. Find maximum power transmitted and the corresponding axial thrust, if the maximum intensity of pressure is not to exceed 0.08 N/mm. Assume coefficient of friction as 0.25.

A single plate friction clutch with both sides of plate being effective is used to transmit power at an engine speed of 2000 rpm. It has outer and inner radii 10 cm and 8 cm respectively. Find maximum power transmitted and the corresponding axial thrust, if the maximum intensity of pressure is not to exceed 0.08 N/mm. Assume coefficient of friction as 0.25.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Do it fast
A thin rod 5 mm diameter is held between two chucks 0.8 m apart and deflects 0.5mm under its static weight. The rod weighs 1.508 N/m and the flexural stiffness is 6.136 N m². Calculate the lowest critical speed in rpm taking into account the distributed mass
a. Briefly explain the different between statics friction and kinetics friction.
Hello, Could you please help with the question attached or give guidance please, thnk you
A 2hp motor is to drive a food shredder. The motor is projected to run at 1450 rpm and the required speed at the food shredder is 60 rpm. Design a double reduction drive consisting of belt and chain for this application. Please give solution and show drawing if needed
Torque transmitting capacity in a friction clutch can be increased by O a. All of these O b. Using friction material with a higher coefficient of friction O c. Increasing in the plate pressure O d. Increasing the mean radius of the friction disk
Q.1 Explain why torsional coil springs are fitted inside a clutch friction disc. Q.2 Study examples of competition sintered or 'paddle' type clutches. Most of them do not have torsional springs fitted to the friction disc/plate. Suggest why springs are not fitted to these types of clutches.
If C, is the coefficient of speed fluctuation of a flywheel, then ratio of wma/@min will be
By using a flat friction clutch, at 730 rpm with 30kW power a rotating electric motor will drive a work machine. Electric motor and work machine mass moments of inertia are 2.5 kgm2 and 10 kgm2, respectively. Work machine with a resistance of 380 Nm It has (load) moment. While the engine is rotating at 730 rpm, the work machine is loaded in 10 seconds Is this electric motor sufficient since it is requested to be activated? If not enough, become enough how do you get it?
Which clutch would you use to connect two spindles with a 250 angle between them? Why you chose this clutch, in terms of uniform moment transmission? Explain that it must meet the requirements.
Note: If you don't know the solution please leave it but don't give me wrong solution. A flat open belt drive is used to transmit a power of 25kW from a motor shaft rotating at 950 rpm. The radius of the pulley of the motor shaft is 125mm while the radius of the puller of the driven shaft is 450mm. The center distance between the shafts is 2,250mm. the coefficient of friction is 0.25 and the density of the belt material is 950 kg/m^3. The belt width is 126 mm. The allowable stress is 2.6MPa. Determine the thickness of the belt.
Asap