A single-phase load is supplied by a single-phase voltage source. If the current flowing from the load to the source is 102– 150°A and if the voltage at the load terminal is 100Z 60°V, then the (A) load absorbs real power and delivers reactive power (B) load absorbs real power and absorbs reactive power (C) load delivers real power and delivers reactive power

A single-phase load is supplied by a single-phase voltage source. If the current flowing from the load to the source is 102– 150°A and if the voltage at the load terminal is 100Z 60°V, then the (A) load absorbs real power and delivers reactive power (B) load absorbs real power and absorbs reactive power (C) load delivers real power and delivers reactive power

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The data of the power system shown in the figure: X= 1.2 p.u. X= 0.15 p.u. 20MVA G1, G2, G3: T, Т, Тз: L1, L2, L3, L4: Ls: Draw the reactance diagram marked on it all the reactance's in per-unit. 11 KV 30MVA 11/66 KV 66KV X= 400 66KV X= 202 T1 L (G1 T3 Ls L4 美 T2 G3 G2
A. Find the real and reactive power absorbed by each element in the circuit. B. What is the apparent power supplied and power factor? C. What is the complex power supplied by each of the voltage source? 2 2 j3 (2 -j5 2 125/0° V rms +) 95/-10° V rms
IN THE CIRCUIT OF THE FIGURE THE LOADS ARE THE FOLLOWING: LOAD A: 4 KVA WITH F.P = 0.8 IN DELAY LOAD B: 2.4 KVA WITH F.P = 0.6 IN DELAY LOAD C: 1 KW AND 500 VA INDUCTIVE DETERMINE: a) Current I b) The power factor of the combination.
1. A 440 V, 60 Hz generator supplies two parallel-connected loads A and B,. Load A draws an apparent power of 100 KVA at 0.8 pf lagging and load B draws an apparent power of 70 KVA at unity pf. Determine the KVA supplied by the generator.
Three loads are connected in parallel to a 240-V, 60 Hz supply. Load 1 is composed of three 600-W heaters, Load 2 is a 3 HP, inductive motor with an efficiency of 90% and a p.f. of 0.88, while Load 3 has an impedance of 12-j16 ohms. Determine the following: a) The apparent power of each load b) The Total Power, Total Reactive Power, Total Apparent Power, Power Factor c) The source current
A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of resistance 25 ohms and inducrance 0.5 henry in paeallel with a purw resistance of 28 ohms and a pure capaciror of 60microfarads capacitance ,in each branch. Calculate a. The line currents The answer has to be 9.3A
Find the apparent, reactive and active power in each element of the following circuit Circuit for power analysis
5. A generating station has the following daily load cycle: Time in 0 to 6 6 to 10 10 to 12 to 16 to 20 to Hours 12 16 20 24 Load 50 60 70 60 80 50 (MW) Draw the load curve and Estimate: i. Maximum Load ii. Units generated per day iii. Average Load iv. Load Factor
2
Please answer all subpart either dislike is ready.. please all subpart