A single-phase half wave uncontrolled rectifier circuit is operating with a purely inductive load and a source voltage of 100sin (277) V. An ideal PMMC ammeter is connected in series with the inductive load reads 20 A. Calculate the distortion factor of the rectifier. Answer Choices: a. 0.866 b. 0.707 C. 0.577 d. 0.816

Q: NSTRUCTIONS: - Answer in this format: Given, Illustration, Required Conversion, Solution, Final…

A: Given Data: Illumination  E=150 meter-candle Area of the hall A=45 × 15 m2 The depreciation factor…

Q: 1. Are the theoretical calculations and measured values are equal? Explain?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: What is external setup?

A: EXTERNAL SETUP: Setup is the method involved with setting up a machine to run an item. A portion of…

Q: do you have any other method to solve this problem??

A: In the given circuit,we need to find above mentioned parameters.

Q: Describe the job of the Board of Electrical Engineering in one sentence. Note: The Board of…

A: It is asked to describe the job of the Board of Electrical Engineering in one senctsen.

Q: B. (a) Find Peak time CTP), Percent overs hoot (00os), setting time CtS), Rise Time CTR) of 3.1416…

A:

Q: Explain briefly, the Professional Code of Ethics of an Electrical Engineer.

A:

Q: The figure below shows a four-bit binary ripple counter that is initially in the 0000 state before…

A:

Q: How many nodes are there? image d.png ... 1.5 0 20 50 2 A( )5 A Answer _nodes

A:

Q: A transformer secondary provides 35 Vrms to a full wave voltage-doubler circuit. The dc output…

A:

Q: The curent in a 0.05-H inductor is I= 42 – 30° A. If the frequency of the current is 60 Hz, what is…

A: The equation of the current in time domain is: I(t)=4cos(ωt-300)A The inductor value is L = 0.05H…

Q: Which sub-atomic part of an atom is used as a fundamental unit of electricity par'icularly when it…

A: 1.answer: C electron  Electron is the fundamental particle which causes current. While remaining…

Q: T9. Classify each of the following as being either a p type or an n type semiconductor i. Ge doped…

A: In this question,  Check the following material is p type or n type semiconductor?  We know  Ge is…

Q: An electric train system (ETS) in Japan with a span of 10 miles long is connected to a two…

A:

Q: Explain Base peak? Please answer at your own easy words. Answer should be to the point.

A: Base peak is definitely as the most intense (tallest) peak in the mass spectrum, due to the ion with…

Q: hat is the approximate voltage amplitude and frequency of the waveform below?

A: Disclaimer: "Since you have asked multiple questions, we will solve the first question for you. If…

Q: where is it most convenient to find a PKES system

A: We need to tell about PKES .

Q: TOPIC: Power Systems, Power Plants & Illumination INSTRUCTIONS: - Answer in this format: Given,…

A: Given information is written below. A coal-fired Power Plant with a 3000 kW rated capacity costs…

Q: What is receptacle load ? Explain under 100 words...

A: The amount of load produced by a device inserted into a receptacle is referred to as a receptacle…

Q: 1) What are the things that must be clarified (angles) and others) when drawing a circuit diagram of…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: What does Methodolody , and conclusion entails on the research project?

A: In a research project, the Methodology section is where you describe the procedures and methods you…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load coil that is…

A:

Q: In the circuit below I = 3245° mA. What is the KCL expression at node a following the %3D…

A:

Q: How equation is obtained ? is that equation given in the textbook ?

A: That equation is the direct formula of pulse spread. And no need of derivation of the equation.…

Q: What are the answers for a) & b)?...

A: (a) Power is given, Voltage is given, Current is given, For three phase circuit power is given by,

Q: What NEC article contains a list of the electrical installations that are covered by the NEC?…

A: The NEC (National Electrical Code) is a globally recognized standard for the safe installation of…

Q: Why is the grounding from the ground and not from the neutral?

A: In the given questions we need to tell about the why grounding is done with ground, not from…

Q: Describe the job of the Board of Electrical Engineering in one sentence.

A: The solution is given

Q: Q6) Explain by drawing a block diagram of a power supply?

A: Draw the block diagram of the Regulated power supply.

Q: What is the nodal analysis/ node - voltage method? Also, please give me some circuit problems…

A: Nodal analysis is a method that provides the node voltage value and it can be used to analyze the…

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: Which of the following is?are an application of electrimagnets. A) relays, B) generations, C)…

A: An electromagnet is a type of magnet in which the magnetic field is produced by an electric current.

Q: if i use Voltage division instead of nodal analysis. where do you suggest i start, and How do I…

A:

Q: If the L[ eat cos5t] = (s-a)/( s² - bs + 48), determine the value of a.

A: It is given that: Leatcos5t=s-as2-bs+48

Q: mention at least three practical application where,ASK,FSK and PSK techniques are used. Subject is…

A: ASK, FSK and PSK are types of digital modulation techniques, digital modulation techniques have…

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.