A single-phase antenna transmission line with a length of 40 km and the load supplying with a voltage of 200 kV and a frequency of 60 Hz and a capacity of 130 megawatts with one power factor. If the resistance, inductance, and expansion of the line areHper kilometer is equal to 0.3 ohms, 3.6 millimeters of henry, and 0.02 microfarads per kilometer, respectively. Find the voltage and current at the receiving side.

A single-phase antenna transmission line with a length of 40 km and the load supplying with a voltage of 200 kV and a frequency of 60 Hz and a capacity of 130 megawatts with one power factor. If the resistance, inductance, and expansion of the line areHper kilometer is equal to 0.3 ohms, 3.6 millimeters of henry, and 0.02 microfarads per kilometer, respectively. Find the voltage and current at the receiving side.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

CORONA A Three-Phase, 100 KV, 60 Hz Transmission Line consists of 0.6 cm radius conductors spaced at 1.8 meters apart in an equilateral triangular formation. If the Temperature is 37°C and Atmospheric Pressure is 72 cm of Hg, calculate the Critical Disruptive Voltage at which Corona occurs. Take m0 = 0.88.
Question.2(b):A transmission line has a characteristic impedance of 70 ohms and a parallel capacitance of 11.2 pF/ft. Compute for the series inductance in nH/ft. of the line if the line is lossless. ..
The capacitance per unit length and the characteristic impedance of a lossless transmission line is C and Zo, respectively. Find the velocity of a travelling wave on the transmission line.
Answer all subpart I will thumbs up... Consider a three-phase single circuit transmission line 362 km long, rated voltage 200kV, 125 MW load and unity power factor. a)Calculate the incident and reflected waves on the source and load sides b)Calculate the voltage on the source side (phase-neutral and phase-phase) c)Calculate the wavelength and its propagation speed Given the following table: R = 0.1069 ohm/km L = 1.3549 mH/km C = 0.0085 microfared/km G = 0
• Draw a Lattice diagram each for transient currents and transient voltages that are propagating at the speed of 1.25 x 108 a, m/s for 10 us along a 250 m length transmission line. Note that the transmission line is with characteristic impedance of Zo=754-55° 2 and terminated with an short circuit load Also, the supply is with Vg = 15410⁰ V and Zg = 145x25⁰ 2.
Microwave
A single-phase antenna transmission line with a length of 40 km and supplying the load with a voltage of 200 kV. a frequency of 60 Hz, and a capacity of 130 MW with a single power factor. If the line resistance, inductance, and capacitance per km are 0.3 ohms, 3.6 mH, and 0.02 microfarads per km, respectively. Find the voltage and current at the receiving end.
I Need the answer fastTable Provided if needed
A lossless transmission line (TL) has a characteristic impedance of Zo= 250 N, a load impedance of ZR = 125 – j150 N and its operating frequency is fo Smith chart to evaluate the following parameters: 150 MHz. Use 1) The load admittance YR. 2) The reflection coefficient [Kr|ZOR 3) The voltage standing wave ratio (VSWR). Then calculate the maximum and minimum impedance in this TL, (Zmax and Zmin). 4) The distance from load to the nearest maximum (dmax) and minimum voltage positions (dmin) (in meter). 5) Find Zd at a distance away from a load by d= 3.3 2. Then calculate Zd using TL equation.
1. Estimate the corona loss for a three-phase, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm diameter and spaced 2-5 m apart in an equilateral triangle formation. The temperature of air is 30°C and the atmospheric pressure is 750 mm of mercury. Take irregularity factor as 0-85. Ionisation of air may be assumed to take place at a maximum voltage gradient of 30 kV/ r316.8 LWI
b) A 16km long, air-spaced twin wire line has a characteristic impedance of 2500. It connects a 2.2kV DC source (of 2502 output impedance) to a 1500 load. (i) Calculate the total inductance, total capacitance and signal transit time of the twin wire line. (ii) Calculate the voltages and currents of both the forward and reflected waves along the twin wire line, and also the load power. c) The twin wire line develops a sudden short circuit at its midpoint. Describe fully and quantitively the subsequent changes in voltages and currents at all points along it in response to this fault, noting the times at which these changes occur, until steady-state conditions are attained.
Q4] Draw the phaser diagram of sending and receiving voltages and currents across a long transmission line with a highly capacitive load.