A single loop of copper wire, lying flat in a plane, has an area of 8.40 cm² and a resistance of 1.80 . A uniform magnetic field points perpendicular to the plane of the loop. The field initially has a magnitude of 0.500 T, and the magnitude increases linearly to 2.00 T in a time of 1.08 s. What is the induced current (in mA) in the loop of wire over this time? mA

A single loop of copper wire, lying flat in a plane, has an area of 8.40 cm² and a resistance of 1.80 . A uniform magnetic field points perpendicular to the plane of the loop. The field initially has a magnitude of 0.500 T, and the magnitude increases linearly to 2.00 T in a time of 1.08 s. What is the induced current (in mA) in the loop of wire over this time? mA

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 26P: A square loop whose sides are 6.0-cm long is made with copper wire of radius 1.0 mm. If a magnetic...

See similar textbooks

Similar questions

A 0.50-kg copper sheet drops through a uniform horizontal magnetic field of 1.5 T, and it reaches a terminal velocity of 2.0 m's. (a) What is the net map,-, eh: force on the sheet after it reaches terminal velocity? (b) Describe the mechanism responsible for this force, (c) How much power is dissipated as Joule heating while the sheet moves at terminal velocity?
The current density in the long, cylindrical wire shown in the accompanying figure varies with distance r from the center of the wire according to J = cr. where c is a constant (a) What is the current through the wire? (b) What is the magnetic field produced by this current for r < R? For rR ?
A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
Unreasonable results Frustrated by the small Hall voltage obtained in blood flow measurements, a medical physicist decides to increase the applied magnetic field strength to get a 0.500-V output for blood moving at 30.0 cm/s in a 1.50-cm-diameter vessel. (a) What magnetic field strength is needed? (b) What is unreasonable about this result? (C) Which premise is responsible?
A circular coil with 200 turns Las a radius of 2.0 cm. (a) What current through tire coil results in a magnetic dipole moment of 3.0 Am2? (b) What is the maximum torque that the coil will experience in a uniform field of strength 5.0102 ? (c) If tire angle between and B is 45°, what is the magnitude of tire torque on the coil? (d) What is the magnetic potential energy of coil for this orientation?
A 500-turn coil with a 0.250m2 area is spun in Earth’s 5.00105T magnetic field, producing a 12.0-kV maximum emf. (a) As what angular velocity must the coil be spun? (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
The flip coil of the preceding problem has a radius of 3.0 cm and is wound with 40 turns of copper wire. The total resistance of tire coil and ballistic galvanometer is 0.20 When the coil is flipped through 180° in a magnetic fielda change of 0.090 C flows through the ballistic galvanometer. (a) Assuming that and the face of the coil are initially perpendicular, what is tire magnetic field? (b) If the coil is flipped through 90°, what is tire reading of the galvanometer?
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
A steady current I flows through a wire of radius a. The current density in a wire varies with r as J = kr2, where k is a constant and r is the distance from the axis of the wire. Find expressions for the magnitudes of the magnetic field inside and outside the wire as a function of r. (Hint: Find the current through an Amprian loop of radius r using Ithru=JdA.)
What is the magnetic field at P due to the current I in the wire shown?
A circular loop of wire of radius 10 cm. is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2104T perpendicular to the arcs of rotation, (a) Find an Expression for the time-dependent flux through the ring (b) Determine die time-dependent current through the ring if it has a resistance of 10.
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?