Pr1. The figure shows the cross-section of a long, straight, cylindricalcoil (solenoid) of radius r = 10 cm. The number of turns per unit length isn = 500 m-1. A direct current I = 1,0 A flows clockwise in the solenoid.A charged particle accelerated by a voltage 1000 V enters into the solenoidthrough a gap between the coils at point A. The velocity of the particleat point A is pointing along the radius. The particle is traveling insidethe solenoid in a plane perpendicular to its axis and exits at point C atan angle a = 60° to its initial direction.60Ava) Determine the sign of the charge of the particle.b) What is the radius of the particle's trajectory?c) Find the charge-to-mass (Q/m) ratio of the particle.(The magnetic permeability of vacuum is µo = 47 - 10-7 Vs/Am.)

The magnetic field in solenoid's core is along the axis of solenoid and is given by,…

Answered: Pr1. The figure shows the cross-section…

Similar questions

A resistor R is connected between two parallel conducting rails separated by 30 cm, as shown in the diagram. A conducting bar maintains electric contact with the rails as it moves relative to them with constant velocity from x = 20 cm to x = 48 cm in 0.6 seconds. A uniform 0.8 T field points into the page. Calculate the induced electric potential difference between the two ends of the bar.
As a diligent physics student, you carry out physics experiments at every opportunity. At this opportunity, you carry a 1.15 m long rod as you jog at 3.17 m/s, holding the rod perpendicular to your direction of motion. What is the magnitude B of the magnetic field that is perpendicular to both the rod and your direction of motion and that induces an EMF of 0.287 mV across the rod? Express the answer in milliteslas. B = mT
A conducting bar of length L = 0.40 m rotates in a counterclockwise direction with a constant angular speed of +2.0 rad/s about a pivot P at one end, as shown. A uniform magnetic field (magnitude = 7.5 T) is directed out of the paper. What is the potential difference, Vp- VA? AL B P. -L/2 -L/2- O a. 0.30 V O b. -0.30 V О с. - 1.20 V O d. 0.90 V О е. -0.90 V
In the figure, an electron with an initial kinetic energy of 3.80 keV enters region 1 at time t = 0. That region contains a uniform magnetic field directed into the page, with magnitude 0.0100 T. The electron goes through a half-circle and then exits region 1, headed toward region 2 across a gap of 30.0 cm. There is an electric potential difference AV = 2000 V across the gap, with a polarity such that the electron's speed increases uniformly as it traverses the gap. Region 2 contains a uniform magnetic field directed out of the page, with magnitude 0.0168 T. The electron goes through a half-circle and then leaves region 2. At what time t does it leave? Number i Units × B₁ Region 1 Region 2 OB₂
AY R R/2|; d A single current-carrying circular loop of radius R = 8.8 cm is placed next to a long straight wire as shown in Figure. A current i1 = 7.2 A is passing through the wire towards right. At a certain moment an electron is moving at a velocity v = 700.0 jm/s toward the centre of the circular wire. At the instant shown in figure, the electron's distance from the wire is d — 2.1ст. The z axis points out of the page in the coordinate system shown in the figure which is represented by the circle with a dot inside. a) Compute the magnitude of the magnetic field at the centre c due to the current passing through the straight wire.
Two wires AC and BC are attached to a 7 Kg sphere that It rotates at constant speed v in the horizontal circle shown in the figure. Yes θ1 = 55° and θ2= 30 ° and d 1.4 m, determine the range of values of v for which both wires are held taut.
An electrically conductive rod is moving through a uniform magnetic flux at a constant velocity at right angles, as shown by its cross-section in the diagram. The velocity is in the x-direction, the rod is of length 150 mm along z, and the magnetic flux density is 0.2 T in the positive y-direction. Speed If the potential difference (voltage) across the ends of the rod is 5.8 Volts, what is the magnitude of the velocity? m/s Not perpendicular If the rod is passing through the flux with its axis not at right angles what can you be sure of? The speed to generate 5.8 V would have to be smaller. • The speed to generate 5.8 V would have to be bigger. The speed to generate 5.8 V would be the same.
In the figure, an electron with an initial kinetic energy of 3.80 keV enters region 1 at time t = 0. That region contains a uniform magnetic field directed into the page, with magnitude 0.00620 T. The electron goes through a half-circle and then exits region 1, headed toward region 2 across a gap of 22.0 cm. There is an electric potential difference AV = 2000 V across the gap, with a polarity such that the electron's speed increases uniformly as it traverses the gap. Region 2 contains a uniform magnetic field directed out of the page, with magnitude 0.0157 T. The electron goes through a half-circle and then leaves region 2. At what time t does it leave? B₁ Region 1 Number i Units Region 2 OB₂
A current loop of 2-m radius creates 5 T magnetic field at the center of the loop. A student makes a solenoid out of the same loop wire. He measures the length of the solenoid that is 37 cm and counts the number of turns (that is 76). Calculate the magnetic field at the center of the solenoid.