solid mechanics 2 Tut 3 (2)Qv Search in DocumentHomeInsertDrawDesignLayoutReferencesMailingsReviewViewTable DesignLayout+ ShareCambria8A- A- ÁaAaBb(AaBbCcDdEe AaBbCcDc AaBbCcDdEAaBbCcDdIAaBbCcDdEEv abe X2 x² AStylesPanePasteIUEmphasisHeading 1Heading 4NormalStrongSubtitleTitleSensitivityA ships capstan is used to raise the anchor shown in the figure. The anchor rope passes around thecapstan as shown and then over a frictionless pulley. What is the tension necessary to prevent theanchor from falling. The coefficient of friction is 0.15.Q3.4(58N)TMg100kgPage 1 of 2587 words* English (United Kingdom)Focus+235%lili

Concept used:Force of friction acts in direction opposite to the direction of motion.

Answered: A ships capstan is used to raise the…

Similar questions

A crate that has a mass of m = 3.5 kg rests on a horizontal plane. The coefficient of static friction, μs, is 0.25. A horizontal force, F, is applied to the crate, and it is just enough to get the crate to begin moving.a. write an expression for the sum of the forces in the x-direction using that Ff is the static friction force, FN is the normal force and Fg is the weight.b. write an expression for the sum of forces in the y-direction using the same coordinate systemc. calculate the magnitude of F, in newtons, Ff is at its maximum
Two masses of weight 30.0 NN are suspended at opposite ends of a rope that passes over a light, frictionless pulley. The pulley is attached to a chain that goes to the ceiling. What is the tension in the rope? What is the tension in the chain?
The figure shows three blocks attached by cords that loop over frictionless pulleys. Block B lies on a frictionless table; the masses are mA blocks are released, what is the tension in the cord at the right? 6.70 kg, mB 6.20 kg, and mc = 12.0 kg. When the B C Number Units
1. You are tasked with designing the runway on an aircraft carrier. The minimum speed for the F/A18 Hornet is 200 mph. The Hornet weighs 40,000 lbf and its twin engines provide a thrust of ~40,000 lbf combined, providing a max acceleration of 1g.a. How long must the deck be to takeoff unassisted? Give the answer in ft. b. This is most likely longer than your typical ~450 ft carrier. What acceleration must you achieve with both the engines and with a catapult system together to reach the required minimum speed by the end of the deck? c. What net force (combined engines and catapult) must be applied to the plane to get the acceleration in b? d. Do you think the plane will be able to use disk brakes on its tires to stop when landing?Use your knowledge of friction to make your argument. Also know that their coefficient of friction is ~1.
A box of mass ?=24.5 kg is pulled up a ramp that is inclined at an angle ?=19.0∘ angle with respect to the horizontal. The coefficient of kinetic friction between the box and the ramp is ?k=0.345 , and the rope pulling the box is parallel to the ramp. If the box accelerates up the ramp at a rate of ?=2.09 m/s2, calculate the tension ?T in the rope. Use ?=9.81 m/s2 for the acceleration due to gravity.
An antelope is being pulled by two forces whose vector-component expressions are: F1 = 3.6Ni + -8.9Nj + -3.7Nk F2 = 8.2Ni + -1.7Nj + 2.4Nk What is the angle (in degrees) between these two vectors?

A ships capstan is used to raise the anchor shown in the figure. The anchor rope passes around the capstan as shown and then over a frictionless pulley. What is the tension necessary to prevent the anchor from falling. The coefficient of friction is 0.15. Q3.4 (58N) Mg 100kg