A semi modular pipe outlet of diameter 15 cm is to be installed on a distributary with its bed level and full supply level at 101.15 m and 101.5 m respectively. The maximum water level in the watercourse is at 101.15 m. Set the outlet for maximum discharge and determine the same. The discharge coefficient may be taken as 0.62. Is the setting proportional, sub-proportional or hyper-proportional?

A semi modular pipe outlet of diameter 15 cm is to be installed on a distributary with its bed level and full supply level at 101.15 m and 101.5 m respectively. The maximum water level in the watercourse is at 101.15 m. Set the outlet for maximum discharge and determine the same. The discharge coefficient may be taken as 0.62. Is the setting proportional, sub-proportional or hyper-proportional?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Water at 20°C is siphoned from a reservoir as shown in following figure. For d = 8 cm and D = 16 cm,…

A: Given,d=8cmD=16cTemperature of water =20°C

Q: 2. Three reservoirs are connected in a common junction. Following are the pertinent information:…

Q: Water flows under a sluice gate in a horizontal rectangular channel of 2 m wide. If the depths of…

A: In this problem, we are asked to calculate the discharge of water flowing under a sluice gate in a…

Q: Determine the discharge rate in a 1.37-m diameter corrugated metal pipe (CMP) (n = 0.024) on a slope…

A: First part Diameter Of pipe (d) = 1.37 m Manning's coefficient (n)=0.024 Slope (S) = 0.007 When…

Q: A 1m diameter commercial steel pipe that is 2km in length carries water (20°C) fromreservoir A to…

A: The objective of this question is to calculate the discharge of water through a commercial steel…

Q: For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under…

A: From the flow net, the number of flow channels is 3 and the number drops is 10. Given, x = 4; y = 8

Q: Two rectangular clarifiers which are connected in series, each 50 m long and 15 m wide with water…

A: For Two rectangular clarifiers which are connected in series,Length,L 50 mWidth,B= 15 m wide Depth…

Q: 8.63 Two reservoir maintain a constant difference of water levels of 11.25 m and are connected by a…

A: Given data, Here the value of V ( flow velocity through pipe ) is unknown. To find the value of V…

Q: A saddle siphon spillway has the following data: Full reservoir level = 485.9 m Level of centre of…

A: Given:Full reservoir level = 485.9 mLevel of centre of siphon outlet = 479.6 mHFL=High flood level =…

Q: Determine the Headloss at Pipe 1 in METERS b.) Determine the Headloss at Pipe 3 in METERS c.)…

A: Solution: Given : Length of pipes=500m Friction factor (f)=0.02 The flow rate in Pipe 1…

Q: 15. A circular pipe has a diameter of 1 m, bed slope of 1 in 1000, and Manning's roughness…

A: Diameter of the circular pipe D = 1 m, Bed slope S = 1in 1000, Manning's constant n = 0.01, When…

Q: 2. It is known that an irrigation channel has a rectangle with width (b) = 4.5 m, height (h) = 5 m,…

Q: Determine the discharge 1.5 2 1.5 Slope = 3m per 5000 m n = 0.013 where B=d Q=AV V- / RS42 R = A P 5…

A: The section of the channel is given as Slope=3 m per 5000 m=35000Manning's constant, n=0.013B=d To…

Q: Problem 6: Water at 20 ̊C is siphoned from a reservoir as shown in the Figure. For d = 7.5 cm and…

A: The diameter of the pipe before point (2) = d = 7.5 cm = 0.075 m The diameter of the pipe from 2-4 =…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

A semi modular pipe outlet of diameter 15 cm is to be installed on a distributary
with its bed level and full supply level at 101.15 m and 101.5 m respectively. The
maximum water level in the watercourse is at 101.15 m.
Set the outlet for maximum discharge and determine the same. The discharge
coefficient may be taken as 0.62.
Is the setting proportional, sub-proportional or hyper-proportional?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. Find the flow rate out of reservoir A. 2. Find the flow rate towards reservoir C. 3. What is the elevation of reservoir C.
Three reservoirs A, B, and C are connected by a pipe system with a common junction at D. The elevation of A and č are 200 m and 178 m respectively. Reservoir B is higher than that of C with an inflow of 0.6 m³/s. The properties of pipes are as follows; from A to D, L = 1200 m, đia. = 800 mm, f = 0.0158; from D to B; L = 450 m, dia. = 600 mm, f = 0.0168; from D to C; L = 1000 m, dia. = 400 mm, f = 0.0168.4. Determine the discharge in the pipe connected to reservoir A. a. 0.45 m/secb. 1.014 m/sec c. 0.96 m/sec d. 0.31 m/sec
Please list any assumptions
PROBLEM 1 The total discharge in the system below is 15.5 cfs and the head loss from B to Cis 24 ft. Using n = 0.011 for all pipes, determine the following: (a) flow rate Q2 (cfs) through pipe 2, (b) flow rate Qs (cfs) through pipe 3, (c) flow rate Qa (cfs) through pipe 4, 2000 ft 12 in (d) head loss hu (ft) in pipe 1, and (e) head loss his (ft) in pipe 5. 3000 ft 1500 ft 4000 ft 30 in 10 in 24 in A D 2500 ft 15 in
The outflow rate (O) and storage (S) for the emergency spillway are linearly related as O = S/10,000. Where, O andS are respectively in m3/s and m3. Based on the assumption that at the beginning (i.e., time = 0.0 hour), the storage,the inflow rate, and the outflow rate are all equal to zero; determine the outflow rate from the reservoir at the endof 2 hours period if the inflow rate is 500 m3/s.
please answer with complete solution and explanation
Reservoirs A, B and C are connected by pipelines 1, 2 and 3 respectively which meets at the junction D. The elevation of reservoir A s 300 m, while that of C Is 277 m. Reservoir B is higher than reservoir A. The rate of flow out of reservoir B is 560 liters/sec. Compute the elevation of Reservoir B in m Pipe 1 (D=900 mm; L=1500 m; f=0.0208) Pipe 2 (D=600 mm; L=450 m; f=0.0168) Pipe 3 (D=450 mm; L=1200 m; f=0.0175) Round your answer to 3 decimal places.
ANSWEWR URGENTLY
Situation 7: From reservoir A whose water surface elevation is 225 m. Water is pumped through a 350 mm pipe across a valley at a second reservoir B at a elevation of 240 m. During pump, the pressure is 570 kPa at a point C and at elevation of 195 m. Assume that the headloss in the pipe from reservoir A to point C is 30 times its velocity head and from point C to reservoir B is 50 times its velocity head 23. Compute the discharge in the pipeline in L/s 24. Compute the head added by the pump 25. Compute the horsepower exerted by the pump IVA E1225 m El 240 m El 195 m
The three reservoirs, A, B and C are connected by pipelines A, B and C respectively which meets at the junction X. The elevation of reservoir A is equal to 300 m while that of B is 285 m. The discharge flowing out of reservoir A is 1.4 cu.m/sec. (Pipes, Diameter, Length, Friction factor "f")A, 800 mm, 1500 m, 0.0157B, 600 mm, 450 m, 0.0162C, 450 mm, 1200 m, 0.0177 (a) Compute the rate of flow in reservoir B in cu.m/sec. (b) Compute the rate of flow in reservoir C in cu.m/sec. (c) Compute the elevation of Reservoir C in meters.
A 7350 m long, 1050 mm concrete pipeline connects an upstream reservoir (watersurface elevation 433.3 m) to a downstream reservoir (water surface elevation 423.1 m). Adischarge valve at the downstream end is used to control flow; when this valve is fully open,the measured discharge in the pipeline is 920 L/s under the naturally available head difference.(a) Assuming fully developed turbulent flow and that all other local losses are negligible,estimate the loss coefficient k for the fully open valve (assume f = 0.015).(b) Because of increasing urban development, the flow under the natural head difference isconsidered to be inadequate and it is proposed to increase this flow with pumping. The head-capacity curve for the pump can be approximated by the equation H = 8 – 3.5Q2 in which H isthe total dynamic head on the pump (in m) and Q is the discharge (in m3/s). What is thedischarge that can now be obtained from the system where the pump is installed at a cross-section of the pipeline?
Question 2 For the water distribution system shown below, find: (a) The discharges in the loops (b) Pressure heads at point B, C, and D if the pressure head at point A is 80 m and A, B, C and E have the same elevations All pipes are 1 km long and 300 mm in diameter with roughness f-0.03, 90 L/s A E 1 km 300 mm B D C 60 L/s D