A science project requires a 400.-mH [L] Inductor. A paper tube with cross-section area 1.59 X 10-3 m² [A] and length 9.50 cm [] will be used. Calculate the turns [N] of coil required to make this Inductor. Treat this. as an Air-Core Inductor. a) 137,723 b) 18,967,754 c) 45,844 d) 13,772 e) 4,355

Q: In the figure below, the switches S, and S, are closed simultaneously at t = 0 and a current starts…

A:

Q: Use the data of this table to find the point between Neptune and the Sun at which an object can be…

A: We have mass Sun M1=1.991*1030kg, mass of Neptune M2=1.03*1026kg and distance between the Sun and…

Q: A string on the violin has a length of 19.80 cm and a mass of 0.0752 g. The fundamental frequency of…

A:

Q: 1. A spring mass system is placed on smooth horizontal table. From equilibrium position the mass is…

A: Given tAB=2secM=200g=0.2 KgU=total energy=0.9 J

Q: A student examining a flashlight observes that it uses a traditional incandescent light bulb. The…

A: We know, P=VII=PV

Q: 9) How many electrons are moving through a current of 2A for 2 s? a) 3.2 x 10-19 b) 6.28 x 10 18 c)…

A: Given:          Current, I=2 A            Time, t=2 s Find: The number of electrons, n=?

Q: A 9.00 pF capacitor is connected in series with a 6.00 pF capacitor and a 850 V potential difference…

A: Given:-  The two capacitance are as  C1= 9 pF C2= 6 pF   The capacitance is in the series and the…

Q: 18. The necessary conditions for the equilibrium of an object is a) ΣF=0 and Στ0 b) ΣΤ= 0 and Σ Ιω-0…

A:

Q: What is the focal length (in cm) of a magnifying glass that produces a magnification of 3.85 when…

A: Given: Magnification, m = 3.85Object distance, u = 4.75 cm Need to find focal length, f

Q: Two large rectangular aluminum plates of area 140 cm² face each other with a separation of 3 mm…

A:

Q: Find the total capacitance (in µF) of this combination of series and parallel capacitors shown…

A: Given Here capacitance of the three capacitors are given as C1=15 μF, C2=8.5 μF and C3=0.80 μF   We…

Q: Consider a sound wave moving through the air modeled with the equation s(x, t) = 3.00 nm cos(55.00…

A: Given:      Sx,t=3nmcos55m-1x-14×103s-1tHere wave number k=55 m-1       And…

Q: find the inertia tensor about the origin, and find the principal moments of inertia and the…

A: The tetrahedron bounded by x + y + z = 1 and the coordinate ­planes. To compute the moment of…

Q: The magnitude of the magnetic field 47 cm from a long, thin, straight wire is 6.8 µT. What is the…

A:

Q: asticity & Waves 19. What is the time required for one complete vibration of an ultrasonic…

A:

Q: You notice two birds, sitting in an elm tree very close to each other and at exactly the same…

A: Sound travels through any medium in the form of compression waves. These sound waves are thus…

Q: A high-jumper jumps, and as she leaves the ground her velocity has both a non-zero horizontal…

A: Let mass of jumper = m  Let initial horizontal velocity = u  Let initial vertical velocity = v

Q: 1st Law of Thermodynamics - Cyclic Process 1 Pressure A D In the figure, pressure PA PB = 4.60 X 106…

A: Given that, For a cyclic process The pressure at point A is PA=4.6×106Pa Volume at point A is…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.