A river flowing steadily at a rate of 175 m^3 /s is considered for hydroelectric power generation. It is determined that a dam can be built to collect water and release it from an elevation difference of 80 m to generate power. Determine how much power can be generated from this river water after the dam is filled (MW)

Q: For ox=-50 MPa, oy=-30 MPa, and o₂ = 30 MPa, calculate the normal strains if E=50,000 MPa and v=…

A: Introduction The amount that an item expands or contracts as a result of an applied load is measured…

Q: Imagine a solar electric power plant that operates by using a gigantic mirror to concentrate light…

A:

Q: well water is pumped into a thank that is 25 meters high through a pipe with an inner diameter of…

A: Given data:

Q: A motor uses 25kW of electricity when powering a pump that moves oil (SG 0.86) at 0.1 m3/s. The…

A: Step 1: Calculate the power input to the motorThe power input to the motor can be calculated using…

Q: Q6) An oil pump is drawing (25 kW) of electric power while pumping oil with (= 860 kg/m3) at a rate…

A:

Q: can you just give me the answer to this question; "Give expressions for the total kinetic and…

A:

Q: Consider a pumped hydro system that is used for energy storage. During off-peak hours, excess…

A: Given: The height of reservoir, H = 100 m The flow rate, Q = 650 ltr/s The power, P = 1000 MWh The…

Q: Give examples of pump efficiency and turbine efficiency?

A: The range of the efficiency of a smaller centrifugal pump varies from 50 to 70 percent whereas for…

Q: A leaky 15-kg bucket is lifted from the ground to a height of 18m at a constant speed with a rope…

A:

Q: A river flowing steadily at a rate of 180 m3/s is considered for hydroelectric power generation. It…

A: Data given-  Flow rate Q• = 180 m3/s  H = 60 m

Q: Water flowing through a pipe at a rate of 70 liter/sec having diameters 600 mm and 400 mm at the…

A:

Q: (a) Find the useful power output of an e load a height of 450 cm in 12.0 s, if it al 5.00 m/s. Note…

A: Write the work-energy theorem as follows.

Q: A water pump delivers 6 hp of shaft power when operating. If the pressure differential between the…

A: The given information in the problem is listed down in the following attached image:

Q: When water is pumped into a water tank 20 m above a lake with a flow rate of 70 l/s, 20.4kW of…

A: Given data:- Head(H) = 20 m Discharge(Q) = 70 L/sec Electric power = 20.4 k

Q: C) Identify the types of water turbines and the limitations that exist within these different types?…

A: Different types of water turbine are listed below Pelton Wheel: The hydro turbine (especially an…

Q: A leaky 15-kg bucket is lifted from the ground to a height of 18m at a constant speed with a rope…

A:

Q: when operating. If the pressure differential between the outlet and the inlet of the pump is…

A: Given:  Power developed by the pump, P=6 hp Pressure difference, p=1.2 psi Flow rate, Q=15 ft^3/s

Q: turbine receives steam at a rate of 1.26 kg/s and its shaft power is 500 kW. The casing is…

A: This question is based on the concept of the First Law of Thermodynamics.

Q: The electrical powerplant draws water in an elevation about 100 m and discharge water below. The…

A:

Q: A pump continuously supplies water to an open tank for 12 hours daily. If the theoretical horsepower…

A: The given values are - Ptheoretical=4 hp, Electricity consumption=4.5Php/kWhη=0.65 The actual power…

Q: Consider a river flowing toward a lake at an average speed of 3 m/s at a rate of 500 m3/s at a…

A: Given: The average speed of the river is v=3 m/s. The rate of the flow of the river is V=500 m3/s.…

Q: In a hydroelectric power palnt, water flows from an elevation of 400 ft to a turbine, where electric…

A:

Q: A pump at 65% efficiency is used to transport water from a large open reservoir to a point 10m above…

A:

Q: Q4: Determine the maximum height increase provided by a 7.46 KW pump with a 6-cm-diameter inlet and…

A: Given data:- Power rating of pump, P=7.46 kW Diameter at inlet, d1=6 cm Velocity at inlet, V1=10…

Q: A stream flowing at 141 ft3/s and have a vertical drop of 16 ft will be used to generate electricity…

A: Given data as per question stream flow rate =141 ft3/s =3.88 m3/s vertical drop =16 ft =4.87 m The…

Q: Water flow through a pipe at 18 li/sec. The inlet diameter of pipe is 15 cm and its exit diameter is…

A: Answer: Power input to the pump = 4.7 kW Have a good day.

Q: Consider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 500 m³ls at a…

A:

Q: A fluíd enters a machine at 167.4 m/s, 881.6 kPa, and with a specific vólume of 0.398 m/kg. The…

A:

Q: Calculate the power generation potential of a 55 m blade diameter wind turbine in a region where the…

A: The power generation of the wind turbine can be given by - P=12ρAV3, where -ρ is density of air =…

Q: A0.2-kg rocket is launched from rest and rises 29 m above its starting point. In the process, 425 J…

A: Given     Mass, m = 0.2 kg   Height , h = 29 m

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: Following is not the assumption of Bernoulli Energy Equation

A: option B is the correct answer

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.