A reinforced concrete T-beam carries a uniformly distributed super-load on a simply- supported span of 8 m. The stresses in the steel and concrete are not to exceed 125 MN/m' and 7 MN/m², respectively. The modular ratio is 15, and the density of concrete is 2400 kg/m'. Determine the permissible super-load. (Nottingham) -100cm- 15cm 15cm Three 2.25cm bars 60 cm Six 2.25 cm bars 7,5cm 25cm

Q: A material has the following properties: Sut = 400 MPa and n = 0.25. Calculate its strength…

A:

Q: have more strain, a 10ft bar being stretched 3 inches or a 3ft bar being stretched 3 inches? It…

A: Stretching a material causes it to experience strain, which is determined by the material's original…

Q: Discuss how 'stress transformation' leads to the identification of a material with suitable…

A: It has been asked in the question to determine how stress transformation leads to the identification…

Q: The stress-strain behaviour of a material is shown in the figure. Its resilience and toughness, in…

A: Given:

Q: A gold-alloy microbeam attached to a silicon wafer behaves like a cantilever beam subjected to a…

A: Determine the modulus of elasticity of gold,Eg=?

Q: A material has the stress–strain behavior shown in Figure What is the material strength at rupture?…

A: Material strength at rupture is defined as the stress undergone by the material corresponding to the…

Q: tensile stress is to be applied along the long axis of a cylindrical nickel rod that has a diameter…

A: Given:-  A tensile stress is to be applied along the long axis of a cylindrical nickel rod that has…

Q: If it is constrained between two supports A and B and is stress-free at 20 ℃, what would be the…

A: