A reinforced concrete T-beam carries a uniformly distributed super-load on a simply- supported span of 8 m. The stresses in the steel and concrete are not to exceed 125 MN/m' and 7 MN/m², respectively. The modular ratio is 15, and the density of concrete is 2400 kg/m'. Determine the permissible super-load. (Nottingham) -100 cm 15cm 15cm Three 2.25cm bars 60cm Six 2.25cm bars a 00 7,5cm 25cm

A reinforced concrete T-beam carries a uniformly distributed super-load on a simply- supported span of 8 m. The stresses in the steel and concrete are not to exceed 125 MN/m' and 7 MN/m², respectively. The modular ratio is 15, and the density of concrete is 2400 kg/m'. Determine the permissible super-load. (Nottingham) -100 cm 15cm 15cm Three 2.25cm bars 60cm Six 2.25cm bars a 00 7,5cm 25cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

T beams
Question 5 A rectangular presressed concrete beam of span 15 m and width 500 mm is loaded with a live load of 30 kN/m. The prestressing force is KN. [Take permissible stresses in concrete and steel as 15 MPa and 1200 MPa respectively]
Use f'c = 30 MPa and fy = 415 MPa. The unit weight of concrete is 24 kN/m³ . The floor of a cantilever floor system is made up of a 150mm thick concrete slab (cast monolithically with beam) and the beams have widths of 300 mm, a total depth of 560 mm, and are to be reinforced with 5-Ø28 mm bars. The center-to-center spacing of beams is 4 m. The cantilever floor system is also built using 4m cantilever reinforced beams as supports. a) Find the maximum service live load (kPa) that the current floor design can support. b) Suppose that the floor will need to carry a superimposed service dead load of 2 kPa and service live load of 7.2 kPa, will the existing floor design be adequate? If not, redesign the beams (find the appropriate number of Ø28-mm rebars and provide a final sketch). Use cc = 40 mm, stirrup diameter of 10 mm, and nominal maximum aggregate size of 20 mm.
A rectangular cantilever beam has a width of 250mm and an effective depth of 480mm. It is reinforced with 7-25mm bars. The beam is carrying a uniformly distributed dead load of 15kN/m. The compressive strength of the concrete is 21MPa and the yield strength of the steel is 415MPa. The depth of the concrete stress block is?
Please answer as soon as possible
Asiacell lln. H.W. No.1 For the simply supported solid one way reinforced concrete slab shown in the figure below having a span of (L= 4m), check the following requirements using strength method: a- Slab thickness b- The spacing between reinforcement for main and shrinkage reinforcement c- The actual reinforcement with minimum reinforcement d- Calculate ultimate resisted moment that can be withstand by the slab e- Determine the ultimate uniformly distributed load carried by slab. f = 25 N/mm2 fy=420 N/mm² + 10mm@s00mm shrinkage h=200mm -L=4m- $12mm@200mm main
I need to solve this question in concrete
13