A reinforced concrete beam has a width of 300 mm and an overall depth of 510 mm.The beam is simply supported over a span of 5.3 m.Steel strength fy=415 MPa and concrete strength fc=28 MPa. Concrete cover is 70 mm from the centroid of the steel area.Unit weight of concrete is 23.5 kN/m^3.Other than the weight of the beam,the beam carries a superimposed dead load 19 kN/m and a live load of 15 kN/m.Use U=1.2D+1.6L at ultimate condition. a. Determine the maximum factored moment on the beam b.Determine the required number of 20 mm tension bars c.If the beam will carry an additional factored load of 20 kN at midspan, determine the required number of 25 mm tension bars hello please answer this thanks

Q: column measuring

A: Given data-  Young's modulus Es = 200Gpa  Ec = 15 Gpa Cross section area of column (A) = 25 cm * 25…

Q: A cantilever timber beam with a span of L = 3.6 m supports a uniformly distributed load w. The beam…

A: Using bending stress equation

Q: 1. The web has a width of 350 mm and the slab thickness and spaced at 6.5 feet center to center of…

A:

Q: A simply supported rectangular beam has a width of 300mm and the distance to the centroid of…

A:

Q: A simply supported concrete beam 6m long is reinforced with four-28mm diam. tension barss. The beam…

A: L= 6 mTension bars = 4-28 mm diaCompression bars= 2-28 mm diaSteel covering = 70 mmf'c= 30 Mpafy=…

Q: A round vertical steel column 500 mm in outside diameter and a wall thickness of 10mm is reinforced…

A:

Q: ind the maximum flexural stress in the bottom material.

A: GIven Data :-  M = 6.5 kN-m b=175 mm t bottom = 200 mm Flexural stress = M * y / I I = 175 *200 ^3 /…

Q: Design Problem 3 The pretensioned circular beam shown below has straight cables with initial stress…

A: Step 1Step 2:

Design criteria for structural loading

The different loads such as loads due to self-weight (dead load) and external loads such as live load, wind loads, seismic load, snow load, and other loads and load combinations that influence the design of a building are called structural loading. The nature of the applied load differs from changes in the location, design, and type of materials used. The design criteria require that structures must be designed and constructed to be able to withstand all load types that are expected to act upon the structure and render its usage for the designated purpose. The structural members such as beams, slabs, columns, and foundations help the structure to withstand the applied load. There are different institutes such as ASCE and ACI that provide building design codes to assure minimum safety requirements and quality of the structures.