A rectangular tank 10m long by 2m deep by 5m wide contains Im of water. If the linear acceleration horizontally in the direction of the tank's length is 3 m/sec', (a) compute the total force due to the water acting on each end of the tank and (b) show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid mass. A а 2m 1m B 10m

A rectangular tank 10m long by 2m deep by 5m wide contains Im of water. If the linear acceleration horizontally in the direction of the tank's length is 3 m/sec', (a) compute the total force due to the water acting on each end of the tank and (b) show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid mass. A а 2m 1m B 10m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A closed oil tanker 2.5m deep * 2m wide * 4m long has been filled with an oil of sp. gr 0.85 up to a depth of 1.5m. Calculate the acceleration which may be imparted to the tank in the direction of its length so that the depth at front end of the tank is decreased by 0.5m.
A rectangular raft, 3 m wide, 6 m long and 2 m high floats in water. It has a draught of 1.5 m. Two loads of 900 kg each are then placed on the transverse centre line with their centres of gravity 2 m from each other. Determine: a. The mass of the float. b. The immersion (draught) of the float after it is loaded. c. The metacentric height of the float with a load (assume the gravity of the raft and load coincides with the geometrical centre). d. The angle by which the float will tilt if one mass is placed on the longitudinal centre line.
Q20) For the steady flow of gas in the conduit shown, what is the mean velocity at section 2? Answer D 1.2-m diameter 60-cm diameter VIDI² PI - 1p₁=2.0 kg/m³ V/₁ = 15 m/s Select one: Ca. 20 m/s b. 40 m/s Cc. 60 m/s ✓d. 80 m/s 1p₂=1.5 kg/m³ For Steady Flow density AVI-density A2*V2 sity A2*V2 2.3.14.22 15/4-1.5 3.14*.6*2*V2 33.912-0.424*V2 V2-80
2. A rectangular tank 2m long, 1.5m wide and 1.5m deep is filled with oil of specific gravity 0.8. Find the force acting on the bottom of the tank when (a) the vertical acceleration 5m/s? acts upwards (b) the vertical acceleration 5m/s? acts downwards. E F D 1.5m 2m
A rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is accelerated horizontally at 2.5 m/s2 in the direction of its length. Determine the net force due to water acting on each end of tank. Unit of the Correct Answer: kN
The 8m diameter cylinder rests on the bottom of the tank 3m long. Water and oil (sp gr=0.78)are poured into the left and right side portions of the tank. If the depth of oil is 4m, find the depth of water (z) and the minimum weight of the cylinder to keep the tank touching at B.
Please reply ASAP. Will rate immediately. Which of the following gives the horizontal reaction at point C?
An oil tanker 3 m wide, 2 m deep and 10 m long contains oil of density 800 kg/m3 to a depth of 2 m. If the tanker is closed and completely filled with the oil and accelerated horizontally at 3 m/s2, determine the total liquid thrust (hydrostatic force) on the rear end. Unit of the Correct Answer: kN Group of answer choices 119.088 109.088 181.089 911.088
An open cylindrical tank with a diameter of 37cm and 90cm high is partially filled with water. At what speed would it be rotated so that the pressure at the center of the bottom tank is zero? Ans, in rpm
b3
. The water pressure acting on the masonry dam varies as shown. If the dam is 20 ft wide, determine theresultant force of the water pressure acting on the dam.
A rectangular tank 7m long by 2.4m deep and 2.65m wide, contains 1.2m of water.If the linear acceleration horizontal in the direction of the tank's length is 2.75m/s²a) Compute the total force due to the water acting on each end of the tankb) Show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid massc) If the tank is filled with water and accelerate in the direction of its length at the rate 1.72m s³, how many litres of water are spilledd) What is the maximum acceleration should be to keep no water will spill out