a rectangular plastic container has a width of 5.82m, a length of 10.67m and a height of 1.78m if the container is placed in freshwater, it floats in such a way that 0.3 m of its height does not submerge in fresh water ( mass density 1000kg/m^3) use archimedes principle to calculate the weight of the plastic container

Q: Calculate the pressure at the bottom of a ball-shaped tank, 4.6 m in diameter, filled with peanut…

A: Given, pressure at surface,  p0 = 89.5 kPa depth of the liquid, h =4.6 m acceleration due to…

Q: Consider the density of a liquid substance is 40 lb/ft³. Calculate the specific gravity of the…

A: Density of a liquid substance = 40 lb/ft3

Q: The speed of sound in a fluid can be calculated using the following equation: where v = speed of…

A: Given data: The equation of the speed of the sound is given as

Q: In the figure below, a tank partially filled with liquid (SG =1.2) is connected to a closed end…

A:

Q: The human brain is surrounded by the cerebrospinal fluid (CSF) in the skull and is not, the bottom…

A:

Q: "A cylindrical tank contains 2 liquids with different density. Assuming the container is full and is…

A: let's take a cylindrical tank contains 2 liquids A & B volume of the tank (V) = 25.3 m3…

Q: A liquid flows through a horizontal straight commercial steel pipe 30.48m long and a pipe roughness…

A: Given density=ρ=1200kg/m3 viscosity=μ=0.01kg/m.s Pipe roughnes=e =0.045 mm = 0.045 × 10-3 m Length…

Q: A small spherical marble, 1 cm in diameter and weighing 1.5 g, is sinking slowly in a calm lake, 2.5…

A: Given data: D=1 cm=0.01 mW=1.5 g=1.5×10-3 KgDistance; d=2.5 km=2500 mρwater=998.21 kg/m3μ=1 cp=10-3…

Q: A prevailing pressure of one standard atmosphere will support a column of mercury 760 mm in height.…

A:

Q: When the fluid flows only in the z direction in the cylinder, (constant density and viscosity and…

A: uz is only function of r.ur and uθ is zero.gz=0. we have a steady state condition. ∂uz∂t=0 ∂uz∂r is…

Q: The specific gravity of a liquid is 0.75. What height (in m) of that liquid is needed to provide a…

A: Given that, The specific gravity of a liquid SG = 0.75 Pressure difference ∆P = 2500 mm Hg It is…

Q: Equation 1 is for finding the force on an object outside atmosphere. F= 144.2 y+ 3.14 ;(1) Where F…

A: Buckingham's Pi theorem is used for dimensional analysis. This analysis reduces the complexity of…

Q: An oil film drains steadily down the side of a vertical wall, as shown on figure below. After an…

A: Oil film is steadily sliding down on a vertical wall and as it reaches down its thickness increases…

Q: A rectangular block of wood has a dimension of 20cm x 20 cm x 50cm and float in fresh water. If the…

A: Given Data The dimensions of the block  = 0.2 m x 0.2 m x 0.5 m The depth upto which the wood is…

Q: The amount of property per unit mass of the substance is known as O a Ob. O d. Specific volume All…

A: Correct option is to be identified.

Q: At a biorefinery which is producing ethanol, an open storage tank is being used to store the…

A:

Q: 2) m long, and 3 m deep, as shown in the picture. The container is initially filled with 30,000 kg…

A: Note: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: The drag force of a particle falling through a fluid at relative velocity u is directly proportional…

A: As We know   FD     =     ( C× d ×A×u2)/2 Where  FD is drag force  C is drag coefficient  A is area…

Q: For a solid, spherical particle of 0.8 mm in diameter and a density of 2,600 kg/m3 that is immersed…

A:

Q: A fluid is placed between two large parallel plates. The distance between the plates is 5 mm. The…

A: a) The momentum flux (or force per unit area) is τfyz=FA=0.5+22.5=1 Pa b) Let V2 be the velocity of…

Q: -3 3. Water (p= 1000 kg m-³ and µ = 0.0011 kg m¹ s ¹) is flowing past a flat plate at 0.9 m s¹. The…

A:

Q: Calculate for the specific gravity of the Fluid 3 if the specific weight of Fluid = is 62.4 Ib/ft3…

A:

Q: A liquid film of constant thickness L flows down an inclined wall that makes an angle with the…

A: Given, The liquid film has thickness= L Make necessary assumptions and then do the shell momentum…

Q: Calculate the steric parameter for polystyrene if the volume occupied by one molecule of polystyrene…

A: Given data: Molecular weight of one molecule of polystyrene = 10 × 10-16 cm3 Carbon-carbon bond…

Q: What will be the pressure reading of a gauge located 30 cm from the bottom of the tank?

A:

Q: a)What is the density of the block in lbm/ft^3. b)What is the density of the unknown solution in…

A: given that  block floats with 0.5 inches above the surface block floats with 1.5 inch below the…

Q: An experiment designed to measure the size of air bubbles released in water is diagrammed below. Air…

A: Diameter of syringe = d Critical diameter = D D = 10dTerminal velocity = UUpward force on bubble = F…

Q: A sedimentation centrifuge that has a diameter of 12.4 cm and a height of 100 cm rotates at such a…

A: Given : Sedimentation Centrifuge Parameters:Diameter of the centrifuge:  (which corresponds to a…

Q: QI/ Consider the brass alloy for which the stress-strain behavior is shown in the figure below. A…

A: GivenForce acting on the specimen, F=10000 Ndiameter, d = 10 mmlength,l=101.6 mmyield strength,E=…

Q: Glycerine at 25 °C flows through a straight copper tube (D = 73.6 mm), at a flow rate of 175 L/min.…

A: Given: Temperature, T = 25°C = 298 K Diameter of the copper tube, D = 73.6 mm = 0.0736 m Flow rate…

Q: 1. The velocity profile for a film of liquid flowing down a vertical wall driven by gravity is given…

A:

Q: A rectangular parallelepiped with a square base  d = 0.260 m  on a side and a height  h = 0.120 m…

A: Given, Length of the square base, d = 0.260 m Height, h = 0.120 m mass of the object, m =6.60 kg…

Q: The experimental observations for the determination of contact angle is presented below. Calculate…

A: (a)

Q: determine the mass tradisfer coefficient (cm/s) for a flow flow along a 8.7-cm flat plate. Assume a…

A: Given that :L =8.7 cm =8.7 x 10-2 mRe=1069sc =3876DAB =0.000026 cm2s =0.000026  x 10-4 m2s

Q: The trash can distributed by the city of Mobile are approximately 4 feet tall and have a square…

A: Given dataHeight of the rectangle (h) = 4 ftSide (l)=30 inchConversion factors are as given below

Q: rock is thrown downward from the top of a 40.0 - m - tall tower with an initial speed of 12 m / s.…

A: Given data: Initial speed = 12 m/s We need to calculate the speed of the rock before hitting the…

Units and Dimensions

Dimensions are the basic concepts of the measurement of quantities. Units are the means of expressing the dimensions. For instance, an area has a dimension of L2 and a unit of m2.