A rectangular gate (length 3m, wide 1m) inclined at 50 with the horizontal level and hinged at point to the bottom of the tank. The weight of the gate is 9000N; calculate the minimum height of the water (h) in the left side of the gate, which cause to open the gate automatically? WATER Izr WATER

Q: Fluid A Fluid B hz Impact tube at center Question C1 Two liquids A & B are flow throw two pipes to a…

A: fluid A d1=38.1mm=0.0381m d2=18.9mm=0.0189m cd=0.965 R=148cm d=32.9mm note-all data we will take…

Q: Q2 // The diameter of a pipe at section 1 and 2 are 10 cm and 15 cm respectively. Given velocity of…

A: Given that, The diameter of the pipe at section 1 D1 = 10 cm = 0.1 m The diameter of the pipe at…

Q: 1-Water with kinetic viscosity v-0.494 mm2/s flow through a pipe with diameter 18mm with velocity…

A: Kinetic viscosity = 0.494 mm2 /sdiameter = 18 mm V= 0.1 m/sf  = 0.03 mm

Q: A solid cylinder of weight 9 kg slides in a vertical lubricated pipe. The clearance between the…

A:

Q: Nitrogen flows through a 4 in. x 6 in. rectangular duct at a rate of 2280 ft/s. What is the Reynolds…

A: Firstly hydraulic diameter was calculated for the rectangular duct and the Reynolds number is…

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: Q: An open cylindrical vessel of (20 cm) diameter and (100 cm) long contains water up to a height of…

A: Given diameter of open cylindrical vessel of =20 cm length of open cylindrical vessel of =100 cm…

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: What is fluid power requirement of a cyclone seperator and how is it calculated?

A: A cyclone separator is used to separate the solid dust particles and the particulate matter from the…

Q: a cubic reservoir has side of 10 meters. if it is initially half full with water by height,…

A: Given, Side=10 m Height of water, h=5 m

Q: There is a drop in the bubble with the diameter of 10mm and pressure of 250 KN/m?. If the surface…

A: In fluid mechanics, surface tension is defined as the property of the surface of a liquid allows it…

Q: Brine (SG = 1.1) is flowing through a 100-mm ID smooth pipe at a Reynolds number of 48000. The…

A:

Q: This factor is usually neglected on calculation for pressure drop. A Acceleration B Elevation…

A: Pressure Drop: Difference of total pressure between two point in a fluid flow network is called…

Q: A smooth pipe has an inside diameter of 28 mm, is 16 m long, and carries 10C water at a rate of 8…

A: Given,The diameter of the pipe is, the length of the pipe is, the temperature of the water is, The…

Q: Determine the pressure drop across the orifice meter as shown in Example Figure

A: Given,  ρ1 = 1000 kg/m3 d=0.022 m ρf=1100 kg/m3

Q: 2. 6 The diameter of a cylindrical core sample is 2. 5 cm, its length is 6. 0 cm. Under a pressure…

A: Given data: Diameter of cylindrical core = 2.5 cm Length of core = 6 cm Pressure difference = 0.3…

Q: 1. A flow rate of 16 m/(m² h) is maintained through a 0.6-m-deep bed of filter sand. The sand is…

A: Given: Velocity in bed V = 16 (m3/m2.h) = 16 m/h = 163600m/s = 0.0044 m/s diameter d = 0.4 mm =…

Q: / Air ine room with dimensions are 4 mx 6 m x 3.5 m have density of air is 1080 g/m². Calculate the…

A: We know  that, Density = Mass/ Volume Where,  Density = 1080 g/m3

Q: In the figure below, a tube with a modulus of elasticity of 1 MPa is anchored between two stationary…

A:

Q: Q2: Determine the pressure drop across a pipeline carries 2.5 kg/s of crude oil to a storage tank…

A: Given: mass flow rate of crude oil m = 2.5 kg/s Tank diameter d = 80 mm = 0.08 m L = 100 m mean…

Q: The energy distribution in the boundary layer over the free of a spillway was observed to be :…

A: Free stream velocity = 25 m/s Boundary layer thickness  δ = 40 mm = 0.04 m u/U = (y/ δ)0.12

Q: The U tube shown is rotated about the left vertical leg at 30 rpm. The pressure at point A is…

A:

Q: A hydrometer is calibrated such that in pure water it reads exactly 1.0 at the air- water interface.…

A:

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: 0.015 m³/s of acetic acid is pumped through a 75 mm diameter horizontal pipe 70 m long. What is the…

A:

Q: 17.17. The fins on the radiator of your car are about 2 in long. When your car is going 60 mi/h, the…

A: length of fin x=2 inchvelocity approaching the fins  v=40 mi/hr = 17.88 m/s

Q: Exz: water at 1SC Hows between tow large plate at avelocityof 15 ms the plates are seperated by…

A:

Q: Which of the cross-sections below would experience the lowest engineering stress when the same load…

A: Engineering stress is defined as, Engineering stress = Force appliedcross-sectional area let us…

Q: If the floating ball radius = 0.5 m, the cable tension = 4078 N, its ? weigh is Water Buoy Cable…

A: Given: Radius of ball = 0.5 m Cable tension = 4078 N Find weight of ball.

Q: The trash can distributed by the city of Mobile are approximately 4 feet tall and have a square…

A: Given dataHeight of the rectangle (h) = 4 ftSide (l)=30 inchConversion factors are as given below

Q: mine the change in length in metre due to work by surrounding on the system of 15 kJ with

A: Work done = 15KJ = 15*10³J = 15*10³kgm²/s² Force = 300N = 300kgm/s²

Q: At 30c glycerin (viscosity = 0.5 N.sec/m2 ,density =1260 gm/cm, flows at a rats of 180 ml/min…

A: Laminar flow or streamline flow in pipes occurs when a fluid flows in parallel layers, with no…

Q: AU-tube manometer contains oil (50 Ibft3), mercury (849 847 Ibf/ft) and water (62.4 lbf/ft). For the…

A:

Q: Q4/ A projectile is launched with an initial vx of 75 m/s at an angle of 60° with respect to the…

A:

Q: Water is flowing through a 30-m-long and 5-cm-diameter horizontal pipe at a rate of 9 L/s. Using…

A: We are given that  Length= L = 30 m diameter=d = 5 cm =0.05 m flow rate = Q = 9 L/s = 0.009 m3/s…