A rectangular beam is supported at both ends. It carries two concentrated load of 30kN, a clockwise moment of 150KN-m, and a uniformly distributed load "w". The modulus of elasticity of the beam is 130GPA. Solve the following if the reaction at point B is 256.73846153846KN, upward. BEAM DIMENSION: Width = 130mm, Height = 360mm NOTE: b = 4.8m ; Also, DON'T FORGET TO TYPE DOWN THE CORRECT UNITS (IF NEEDED) w What is the numeric value of C1 (1st Constant)? kN-m2

Q: A uniform beam weighing 500 N is held in a honzontal position by three vertical wires, one attached…

A: Stress = Load / Cross secrion  Assuming that the load is equally distributed in all the three wires.

Q: An inverted T beam (refer to the Figure 4(a)) manufactured from material with the given stress and…

A:

Q: The member shown has a rectangular cross section, determine the state of stress that loading…

A:

Q: Problem 5.9 A solid steel bar has a cross section of side b and is supported as shown. Knowing that…

A: To Determine Depth of the beam, b

Q: 4. The beam shown supports the load shown, determine max flexural stress developed and 200mm the max…

A:

Q: Bar A has diameter 'd' and bar B has diameter 2d'. Both are of the same length and are of the same…

A:

Q: For a beam with the cross-section shown and loaded as shown, find the magnitude of the maximum…

A:

Q: Iso, determine the maximum fiber stress and the stress in a fiber 100mm from the top of the eam at…

A: Shear force and bending moment at the section is important for the structure to detemine the tensile…

Q: The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Q: Bar A has diameter 'd' and bar B has diameter '2d'. Both are of the same length and are of the same…

A: Given data : Bar A The diameter of bar A=d The length of bar A=LA Modulus of elasticity=E Bar B The…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.