A rectangular bar having width w = 7.00 in. and thickness t = 1.00 in. is subjected to a tension load P, as shown in the figure. The magnitudes of the normal and shear stresses on plane AB must not exceed 18 ksi and 9 ksi, respectively. Determine the maximum load P that can be applied without exceeding either stress limit. Assume a = 1 and b = 3. P b. B Answer: P = i kips

Q: Q1) (A) Two solid circular cross-section bar as shown in the Figure. If the stress in left portion…

A: Given figure  A)given data  left portion =  150 MN/m² total elongation of the bar =  0.2mm. Young's…

Q: A compression load of P = 55 kips is applied to a 3 in. by 3 in. square post, as shown. Determine…

A:

Q: A horizontal load Pis applied to an assembly consisting of two inclined bars, as shown in the…

A: According to Bartleby guidelines, we are allowed to solve only the first 3 sub-part of a single…

Q: The rectangular bar is connected to the support bracket with a circular pin, as shown in the figure.…

A: Bar width, w= 2.25 in Bar thickness, t= 0.375 in Pin diameter, d= 0.775 in Applied load, P= 4800 lb…

Q: 100 kN Stiff loading plate 10 cm 10 cm 10 cm 25 cm E= 200 GPa E = 200 GPa E= 70 GPa

A:

Q: A rectangular bar having width w = 6.50 in. and thickness t = 1.25 in. is subjected to a tension…

A: Given:- width of bar=6.50 in,thickness of bar=1.25 in,area of cross section=(6.5×1.25)=8.125…

Q: (1) In the figure below, the cross section areas of rods AB and BC are A1, A2, and the Young's…

A:

Q: An angled strut b = 6.2 in. thick is subjected to a force F = 55 kip and a uniformly distributed…

A: The values are F=55 kipq=23.5 kip/ft The thickness is b=6.2 in     To find out:- The principal…

Q: 14. A prismatic bar having cross-sectional area A=1200 mm² is compressed by an axial load P = 90kN…

A: Step 1: Explanation for question

Q: Current Attempt in Progress A rectangular bar having width w = 6.25 in. and thickness t= 1.25 in. is…

A:

Q: the principal stresses at a point H on the surface of the vessel and the absolute maximur shear…

A:

Q: Rigid bar ABC is supported by a pin at bracket A and by tie rod (1). Tie rod (1) has a diameter of 8…

A:

Q: A horizontal load P is applied to an assembly consisting of two inclined bars, as shown in the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.