A reading of 120 is obtained when astandard inductor was connected in thecircuit of a Q-meter and the variablecapacitor is adjusted to a value of 300pF. A lossless capacitor of unknownvalue C is then connected in parallelXwith the variable capacitor and the samereading was obtained when the variablecapacitor is readjusted to a value of 200pF. The value of C, in pF is

Given- Capacitance C=300 pF, Adjusted capacitance C'=200 pF, To find- The value of lossless…

A reading of 120 is obtained when a standard inductor was connected in the circuit of a Q-meter and the variable capacitor is adjusted to a value of 300 pF. A lossless capacitor of unknown value C₁ is then connected in parallel X with the variable capacitor and the same reading was obtained when the variable capacitor is readjusted to a value of 200 pF. The value of C, in pF is X

A reading of 120 is obtained when a standard inductor was connected in the circuit of a Q-meter and the variable capacitor is adjusted to a value of 300 pF. A lossless capacitor of unknown value C₁ is then connected in parallel X with the variable capacitor and the same reading was obtained when the variable capacitor is readjusted to a value of 200 pF. The value of C, in pF is X

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

solve this please
Q4: For Figure below for sinusoidal input waveform Display and sketch the input and the output waveforms: CH1 1kO CH2 D. Vout 20V p 1N4007 f=1 kHz GND
assume that the circuit shown in figure 17-2 is connected to a 480 v 60 hz line. the inductor has an inductance of 0.053 H and the resistor has a resistance of 12 ohmas
do fast... explanation needed with correct ans.
Find the current that flow through capacitor Ic IR Ic Vs = 20V425° f = 30KHZ R = 1000 C = 100nF (1)125. 65mAZ135° (2)251. 32mAZ120° (3)376. 9mAZ115° (4)628.31MA2110°
where to put the oscilloscope probes in this circuit to see the output waveform? (main hook and ground hook)
R 1. Measure the internal resistance of the 1mH inductor. Set up the given circuit with R = 270n and L = 1mH. Apply a sinusoidal voltage as input. Adjust V, = 4Vpp and set the frequency as 20kHz. Observe the input voltage and the V, L voltage across the inductor simultaneously using an ocilloscope and plot both signals. Find the phase difference between these signals and comment on the results.
If the value of a capacitor is increased, then its impedance will O a. Increase O b. None of the answers O c. Unchanged O d. Decrease
which of the following are true? In forward bias, the transition capacitance dominates In forward bias, the diffusion capacitance dominates In reverse bias, the transition capacitance dominates In reverse bias, the diffusion capacitance dominates
A double beam oscilloscope displays 2 square waveform G and H. The time/cm switch is on 45 ms/cm and the volt/cm switch on 5V/cm. The width of each complete cycle is 6.8 cm for both the waveform. The Peak to Peak height of waveform G and H are 4.6 cm and 4.9 cm respectively. The difference between the two waveforms is 0.9. Determine a) frequency, b) phase difference, c) peak value of H waveform. d) RMS value of G waveform a) frequency b) phase difference C) Peak value of H waveform d) RMS value of G waveform
A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor, what must be the capacitance of the capacitor to produce resonance to 250 volt, 60Hz main? QUICKLY I NEED IT IN5 MINS
Please answer only typing solution please..