A Rankine cycle with a water boiler at 3.0 MPa. The cycle has the highest and lowest temperatures of 450°C and 45°C respectively. what is the phase of water at the condenser exit? O a. super heated Ob. saturated liquid Oc. compressed liquid od saturated vapor

A Rankine cycle with a water boiler at 3.0 MPa. The cycle has the highest and lowest temperatures of 450°C and 45°C respectively. what is the phase of water at the condenser exit? O a. super heated Ob. saturated liquid Oc. compressed liquid od saturated vapor

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Consider an ideal refrigeration cycle that use R-134 a as the working fluid. The temperature of the…

A: Given:Refrigerant=R134aEvaporator temperature, Te=-10oCCondenser temperature, Tc=36oCMass flow rate…

Q: Choose the valid statement about ideal vapor compression refrigeration cycle Select one: O a. Heat…

Q: Which of the following statements is true regarding the Reheat Rankine Cycle? I. Reheat Rankine…

A: Reheating operating at very high boiler pressure increases the dryness fraction of the steam exiting…

Q: Water is the working fluid in an ideal Rankine cycle. Superheated vapor enters the turbine at 10…

Q: A gear pair is designed to provide a 3:1 reduction in speed. The design uses 12 DP gears, driving a…

Q: Design a "Reheat Rankine Ideal Cycle" with the following requirements: 1. Set your boiler's pressure…

A: Given question: We have to design a Reheat Rankine cycle with at least 40% thermal efficiency.

Q: a steam 8.0 MPa and 485 degree Celsius enters the turbine and expand at condenser pressure of 0.006…

A: Givenmass of the steam m=1kgsteam enter at turbineP1=8MPaT1=485oCcondenser endP2=0.006MPa

Q: The condition of water leaving the condenser of a Rankine cycle is Wot steam

A: Correct answer is D

Q: How to do a heat/energy balance on a anode fuel cell and a condenser given that the fuel cell is…

Q: A R-134A vapor refrigeration cycle cycle operates at an evaporator temperature of 20 Celsius and a…

A: The COP is the amount of energy provided from any engine or the the cycle when an amount of input we…

Q: 3. Operate at lower condenser of a Rankine Engine. P1=50 bar (saturated) P2=½bar=0.5 bar. Calculate…

Q: For combined cycle, the condensation losses in two-pressure system is higher than single pressure…

Q: 1. In an ideal reheat-regenerative cycle, steam enters the turbine at 6 MPaa and 400°C. After…

A: Reheat regenerative cycle: In this cycle, the exit of the high pressure turbine is connected to…

Q: In an ideal Rankine cycle, steam is generated at 4.1 MPa and 486.5°C. The condenser is at 32°C.…

Q: A refrigeration machine operating on the ideal vapor compression cycle uses refrigerant-134a as…

A: As per our guidelines we are supposed to solve only 3 sub-parts if multiple sub-parts are asked.…

Q: What is the ideal reheat Rankine cycle

Q: Question 1: A thermal power plant operates such that the steam exits boiler at 4 MPa, 400C and the…

Q: Which of the following are true for the limitations and impracticalities of the turbine of the…

A: Given: Carnot Vapour Cycle "Since you have asked multiple questions, we will silve the first…

Q: on the

A: given: 8(Explain abou the heat transfer mechanism on the ljungstrom air preheater related into…

Q: A 200 MW steam power plant operates on a simple Rankine cycle with superheated steam entering the…

Q: A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH. Condensation…

Q: QUESTION 37 Which of the following are true for the limitations and impracticalities of the…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Steam at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative…

Q: Modification of the reversed Carnot Cycle to Vapour compression cycle involves: Repacing the…

Q: 7.1 77 12 7.2 What is condenser ? What are the functions of a condenser in a thermal power plant?…

A: Condenser is a heat exchanger wherein steam is condensed either in direct contact with cooling water…

Q: Q1/ Steam enters the turbine at 30 bar, 400°C, amount of steam is extracted at 5 bar to a single…

Q: eges ard Boiler tion 4. T1 T2 P2 Qioad Thermal 3 process 8. load 6. FWH 101 7. 9. Steam supply…

Q: QUESTION 2 Condenser Diagram 2E shows an ideal cascade vapour-compression refrigeration cycle using…

A: Given: m1˙=11160 kg/hour=3.1 kg/sP1=100 kPaP2=P3=280 kPaP6=P7=900 kPa To find 1. Coefficient of…

Q: Water is the working fluid in an ideal Rankine cycle with reheat. Superheated vapor enters the…

A: Back work ratio: The Back work ratio is nothing but the ratio of the pump work to the turbine work.…

Q: A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH. Condensation…

A: Since you have more than 3 questions, thus we are providing solutions only to the first three parts.…

Q: am at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative cycle;…

A: Given:P1=10 MPaT1=550°CP2=1 MPaP3=10 KPa

Q: Ideal Rankine cycle efficiency % Answer: Actual Rankine cycle efficiency using pump and turbine work…

Q: A reheat regenerative Rankine cycle us Meam at 8.4 MPa, 560°C, and expands to 0.7 MPa. The cycle…

A: For the reheat-regenerative Rankine cycle, Inlet conditions of high pressure turbine (HPT) are 8.4…

Q: A R-134A vapor refrigeration cycle cycle operates at an evaporator temperature of 20 Celsius and a…

Q: and indicate, with arrows, the directions of working fluid flow. b. Determine the required operating…

A: To draw temperature entropy drawing R 22 fluid, to calculate operating pressures and quality at…

Question

A Rankine cycle with a water boiler at 3.0 MPa. The cycle has the highest and lowest temperatures of 450°C and 45°C respectively.
what is the phase of water at the condenser exit?
o a. super heated
ob saturated liquid
O c. compressed liquid
od saturated vapor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is not an assumption for the ideal vapor compression process? a.Isobaric heating in evaporator b.Isobaric cooling in condenser c.Isenthalpic throttling d.Isentropic expansion
Question 3. The process diagram of a binary power plant with an ORC-process, utilizing geothermal energy, is presented in figure 1 below. Generator efficiency is 94%, generator output power is 180 kW and evaporator heat power is 2590 kW. Calculate the turbine output power. Round off your answer to one an integer. Heat into process Evaporator Turbine Feed pump Figure 1. Process diagram of the binary power plant. Generator Condenser I
A R-134A vapor refrigeration cycle cycle operates at an evaporator temperature of 20 Celsius and a condensing temperature of 35 Celsius. Determine the coefficient performance for. With schematic diagram. Ideal saturation cycle. Wet compression with saturated vapor leaving the compressor . Suction to the compressor is superheated by 7 degrees Celsius. Using this table https://www.docdroid.net/VkxK8WH/refrigerant-134a-pdf
B-Draw the ideal vapour compression refrigeration cycle on T-S and P-H diagrams. State all details on the diagrams and give a short explanation of each process of the cycle.
In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg. C. Determine: a. The cycle thermal efficiency b. For the engine with the same end states, the thermal efficiency and steam rate
provide solutions using the ASHRAE tables and charts A standard ammonia vapor-compression cycle developing 20 tons of refrigeration operates with a condensing temperature of 32°C and an evaporating temperature of -14°C. Calculate the ..
Bokr Py- 6000 kP Wpampin Pump Turbine P50 kPa Condenser "punpin Figure 2 (b) Determine the thermal efficiency of the cycle in part (a) when the liquid enters the pump 1.3°C cooler than a saturated liquid at the condenser pressure.
In the Ideal regenerative Rankine cycle, the condensate from condenser is heated by a. steam extracted from turbine O b. fumace O c. boiler d. reheater
Steam at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative cycle; condenser pressure is 10kPaa and extraction of steam is at 1 MPa. Compute the following 8. Engine efficiency 9. Fraction of steam extracted from the turbine