A pump with an inner pipe diameter of 50 mm on the suction side and 32 mm on the discharge side is used to increase the pressure of 6 m3 / h of water from 1 atm to 3.2 atm. What is the speed of the water in the inlet and outlet pipes connected to the pump?

Q: Water at 20 ºC is to be pumped through shown in the picture.  The inlet pipe to the pump is 0.06 m…

A: Length of the discharge line, L­DL = 60 m Length of the commercial steel pipe, LP = 8.5 m   The…

Q: Q2: It is required to pump cooling water from storage pond to a condenser in a process plant…

A:

Q: If the velocity of water is 8.5 m/s and the pressure is 135KPA on the discharge side of a pump. a.…

A: Given that At discharge side P2 = 135 KPaV1 =8.5 m/s

Q: Pressure in the inner tube of a bike tire is 118 psi. Change this pressure to atm. O A. 8.03 atm B.…

A: Answer: A. 8.03 atm

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: 2 cfs of water is pumped through the 45° vertical pipe bend in the 6 inch diameter pipeline shown…

A: we'll use reynolds transport theorem

Q: A boiler feed booster pump supplies 0.0373 m³/s of water at 1500 rpm. Its suction speed is 3.5 and…

A: Consider a boiler feed pump The flow rate of water supplied Suction speed Pump speed is Also the…

Q: 1. Water is flowing from the inlet to the exit. At the inlet the speed is 20m/s. Calculate (a) the…

A: Given,

Q: Tovo geometrically similar Pumps are running at same speed of 1000 rpm Pump has an impeller diameter…

A:

Q: mooth inner surface for

A:

Q: A Venturi meter shown in fig. What is t city of the water in the first and second pip

A:

Q: A pump is 3m above the water level in the sump and has a pressure of -25cm of mercury at the suction…

A: Given: z1 = 0 m, z2 = 3 m, z4 = 4.5 m, Guage pressure at suction side P2= -25 cm of mercury or…

Q: An oil (S = 0.85, v = 1.8×105 m²/s) flows through 0.1m diameter pipe at 2m³/sec, 150m long. Find the…

A:

Q: Water flow at between 3000-4000 cm3/s through a 75 mm diameter pipe and is metered by means of an…

A: Given data: Flow rate of water = 3000-4000 cm3/s Diameter of pipe = 75 mm Coefficient of discharge =…

Q: Tavo geometrically similar Pumps are.. running at same speed of 1000 PM Pump has an impeller…

A: The initial rate is obtained from the given flow rate. As the pumps are similar then the ratio of…

Q: An oll (SG = 0.9) issues from the pipe shown in the figure below at Q= 35 ft/h. The length of the…

A: Write the energy balance equation for the given process as follows: P1ρg + v122g + z1 = P2ρg + v222g…

Q: A hydraulic oil with 0.9 specific gravity and 0.001 ft²/sec kinematic viscosity is flowing through 1…

A: The equivalent length is measure of pressure drop for pipeline.

Q: A centrifugal pump is tested at 1750 rpm using flow system with a layout. The water level in the…

A:

Q: The below figure shows a pump that transfers a steady stream of 35 API crude oil from an oil tanker…

A: Given data: The effective length of the pipe = 6,000 ft The properties of the crude oil are, Density…

Q: Tavo geometrically similar Pumps are.. running at same speed of 1000 ✓PM Pump has an impeller…

A:

Q: Arection turbine operating under 30m head develops yoooKw while running at 300r.pom the overall…

A:

Q: Water at 30°C is being pumped through a 30 m section of 19.49 cm. diameter steel pipe at a mass flow…

A: Given data: Length of the pipe = 30 m Diameter of pipe = 19.49 cm Mass flow rate = 0.07 kg/s Density…

Q: Consider a horizontal 4-ft diameter galvanized iron pipe simulating the Alaskan pipeline. The oil…

A: Given Info  GI pipe diameter, d=4ft  volumetric flow rate of oil,Q=70 mgal/daydensity of oil,ρ=910…

Q: a. The entering temperature of a unit was measured at 200 F and the flow rate of the unit was 500…

A: Baseboard unit is the heating arrenegement used in heating homes at cold countries during winters.…

Q: The Power (P) required to drive the pump depends upon the diameter (D), the angular velocity (@),…

A: Given, Power is a function of diameter, angular velocity, discharge, and fluid velocity. P = fD, ω,…

Q: In the Figure.Q3, The energy decline of the connections and the pipe before the pump is 3m.…

A:

Q: P.15.8 Water is pumped through a heat exchanger and control valve. At maximum conditions, the…

A: Given, maximum flow rate isFractional opening flow area at normal condition is Relation between flow…

Q: In a turbo machine handling an incompressible fluid with a density of 1000kg/m3 the conditions of…

A: Given,the inlet pressure is, The exit pressure is, The inlet velocity is, The exit velocity is, The…

Q: A reaction turbine has guide vanes at an angle of 30° and the runner blades make an angle of 80°…

A:

Q: A dilute aqueous slurry containing solids with a diameter of 20 micrometer and SG= 1.5 is fed to a…

A: The flow rate of the centrifuge is obtained from angular velocity, distance to liquid, distance to…

Q: For the system shown in Figure 7, water flows through the pump at a rate of 50 Liter/s. The…

A: Given,

Q: EXERCISE PROBLEM Pipe Dia=0.25m P=112 KPA Pipe Dia=0.320m P=68% of P@discharge side Flow Rate =…

A: Let's assume fluid is water  Density = 1000 kg/m³ Volumetric Flow rate = 15800 L/min = 0.263 m³/sec…

Q: the pump shown in the figure delivers water at 59 F at a rate of 550 gal/min. The inlet pipe has an…

A: We are given following data for the pump that delivers water: