A pump transfers water 950ft above the ground to the top of a tank with on top of a building with a volumetric rate of 100gpm. The head pressure in the top of the tank is 5psi. If the pressure on the pump inlet is 60psi and the piping system is commercial steel( roughness = 0.00015) answer the following questions. Calculate the diameter of the pipe to produce an average fluid velocity of 11 ft/s If a pressure sensor is installed on the pump discharged at ground level, calculate the fluid pressure that will be displayed on the face of the sensor. Calculate the power transferred to the fluid by the pump in units of horsepower

Q: Which of the following statements is not true? Select one: O a. Reports can contain bulleted or…

A: As we know Equations should be written in a symmetric manner, not just in the left margin. Equation…

Q: Please check for the question, verify it is correct or not?

A: There is a half cylinder with length L and radius r.Incoming air velocity is uCoefficient of the…

Q: 2. A four-stroke reciprocating engine have a 2000 indicated horsepower. What would be the indicated…

A:

Q: how o create all parts list after the drawing ?

A: Given question: how to create all parts list after the drawing ?

Q: 2. Write 5 details found on the drawing title block?

A: The bottom right hand corner block in engineering drawing sheet is known as title block. This block…

Q: What kind of font is typical for usage in engineering diagrams?

A: To find: The type of font used in engineering diagrams.

Q: Q3: Mark the Following True or False 1. Hidden lines are used in sectioned area when they are needed…

A: 1.TRUE 2. TRUE 3.TRUE 4.FALSE 5. FALSE 6.FALSE 7.TRUE 8.FALSE 9.FALSE 10.FALSE 11.TRUE 12.TRUE…

Q: SKETCH COMPLETE FRONT, RIGHT AND TOP VIEWS. SHOW ALL HIDDEN LINES. LABEL SURFACES.

A: Orthographic views of the given isometric view are drawn on the grid paper. 1 Grid = 1 Unit

Q: 3. both wires is identical at 1.5 meters and both wires are 5 mm in diameter. The steel wire is made…

A:

Q: With reference to the drawing callout in figure 5 below, which part(s) would 'pass' or 'fail' along…

A: Data given-  Dimensions of standard size  0.25±0.01 So tolerance is equal to 0.02  And the upper…

Q: 1.00 1.38 3.38 38 2.00

A: Select the correct statement about the notation circled in green and marked as letter D. Assume all…

Q: Orthographics: Add missing lines and complete any missing views. Draw the isometric

A: The missing lines of the given views are shown below.

Q: What type of lines can be used in a drawing to show that part of an object has been removed ?

A: Solution : There are two types of line which are used to show the removed part of an object : Break…

Q: C) What is the maximum possible mass flow rate that the pump can produce?

A:

Q: la) Compare the relative load strength of the following two bolts: Bolt 1 = %" Dia x 3" Long and is…

A:

Q: 14 sketch in the missing object and ce nter lines on 14

A: Given figure  To sketch the missing lines  And hidden lines

Q: General Questions Not Directly Print Related) 1.  ____________use conventional symbols with single…

A: Fill in the blanks

Q: In creating orthographic views, each view must:

A:

Q: For the triangular element shown below, which TWO statement are correct? A Strain changes linearly…

A: Since the given element has nodes, it is a six node triangular element which has 12 unknown…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.