A pump draws water from a 200mm diameter suction pipe and discharges through a 150mm pipe in which the discharge is 80 L/s. The pressure at point A is -40KP.. The 150mm pipe discharges into air at point Bas shown. If the head loss from point A to point B is 5m, determine the power needed to be given by the pump in horsepower.

Q: The 50 cm diameter pipe shown below transfers water from reservoir A to a pressure turbine and…

A: Given Data Determine the power (in HP) from the turbine (P).

Q: Situation # 4: The pump shown draws water from the reservoir A at elevation 10m and lifts it to…

A:

Q: water pump at elevation 46 m. is used to bring up 250 gpm of water from a river (elev. 45 m.) to…

A: Discharge is 250 gpm Elevation of reservoir is 100 m

Q: Q2)For the system shown in the figure, the water flow rate is (40)L/s. Find the 30m power…

A: Given  Discharge, Q = 40 l/s = 0.04 m3/sec Kinematic viscosity = 1 x 10-6 m2/s  Total head = 30 m To…

Q: Calculate the pressure in the pipe (Point A). The area of the reservoir is 100 times the area of the…

A: Manometer is used to measure pressure at any point which is exerted by a gas or liquid under the…

Q: Water (25°C) is being supplied from a pump station to a reservoir tank through a horizontally-placed…

A:

Q: Water flows from a lake through a 300-m-long pipe having a diameter of 300 mm and a friction factor…

A:

Q: The flow ratio of a Francis turbine, if it is working under a head of 62 m and velocity at inlet 7…

A:

Q: Fig. 2. Assume constar factors, with f = 0.018. The head-discharge relation for the pump is Hp =…

A:

Q: In the figure the water (P = 1000 kg/m3) enters the pump to be raised at (1), with a pressure P1 =…

A:

Q: If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and…

A: The expression for velocity in pipe is given as V=QA Substitute the value in above expression V=0.15…

Q: shows a pump employed for lifting water from a sump. If its required to pump 60 liters/sec of water…

A: