A project engineer notices the site of a former sawmill along a river. Ruins of the original dam used as a hydropower source is still visible. The engineer decides to make some measurements to determine the maximum power that can be generated if the site were rehabilitated, the stream flow is found to be 25m3/s and the change in elevation is 4.87m. Determine the maximum power that could be produced

Q: Imagine a solar electric power plant that operates by using a gigantic mirror to concentrate light…

A:

Q: A manufacturer states that their gear pump requires 0.85 hp to pump 9 gpm of oil (sg=0.90) with a…

A: The flow rate of the oil is, Q=9 gpm. The specific gravity of the oil is, SGo=0.90. The total heat…

Q: The volume flow rate in an artery that supplies blood to the brain is 3.5*10^ -6 ^ 3 /s . If the…

A: Given data: The volume flow rate through the artery is; Q=3.5×10-6 m3s. The area of a cross-section…

Q: A 40-m wide and 5-m deep river flows at the rate of 1.5 m/s. A hydro-electric plant installed nearby…

A:

Q: The turbine of a micro-hydroelectric power plant delivers 65hp at 75% efficiency. If the effective…

A:

Q: Table Q2(b) provides specific details location and parameters of a small hydropower plant and dam to…

A:

Q: A hydroelectric power plant site where the average elevation of the headwater is 565 m, the…

A: The power produced by the impulse turbine working under a net head H, can be obtained by the…

Q: 150 mm 15° 30 m/s Incident jet Moving vane A circular jet of water (density = 998 kg/m3) impinges on…

A:

Q: ii) State two advantages of implanting hydroelectric power in Cameroon. ) Describe two problems that…

A: A hydroelectric plants uses potential energy of water and produces electric energy as output. Energy…

Q: For the Fig. shown, find the velocity of point 1 and the pressure of point 2 D2=20 cm P2=? Kpa…

A: Continuity equation is based on the conservation of mass. If a pipe having area at one section is…

Q: what horsepower would be developed under a head of 11 meters?

A: To find  Horse power developed under a head of 11 meters.

Q: Q1/ Determine the magnitude and direction of the resultant force acting on a 45° elbow deflects…

A: To find: The magnitude and direction of the resultant force. Given: The angle is θ=45°. The rate of…

Q: A typical industrial-scale wind turbine has a peak efficiency of about 0.44 for a wind speed of 9…

A:

Q: A hydroelectric generation facility has a gross head of 120 m and a consistent yearlong water flow…

A:

Q: b) A hydroelectric power station has an efficiency of 70% and the reservoir is 425 m above the…

A: Given, Efficiency, η=0.70Head , h=425mShaft Power,P=180MW (i) To calculate discharge, Q We know that…

Q: At the Manapouri hydroelectric station on the South Island of New Zealand, water from Lake Manapouri…

A:

Q: A pump is used to raise water from a reservoir through 800m of 20cm pipe (f=0.033). If the pipe is…

A:

Q: 2. There is a tank, 1 meter in diameter and 3 meters high, filled with water. Water is now drained…

A: GivenD=1mZo=3md=4cm=0.04muo=0.622gz Part afluid - water ρ=1000 kg/m3Time t=? when V=1m3 water is…

Q: Determine the power required (Watts) to drive a reciprocating pump running at 1 rps and discharges…

A: Given data: N=1 rpsρ=850 kg/m3Q=369.2 gpm=0.0233 m3/sd=250 mmL=500 mmH=28 m Need to determine the…

Q: he design of a new dam reveals that a water head of 10 meter and water flow rate of 100 cubic meter…

A: Given:   Water head, h=10 m Water flow rate, Q= 100 cubic meter per second

Q: In a hydroelectric power palnt, water flows from an elevation of 400 ft to a turbine, where electric…

A:

Q: (a). Differentiate the following as applied to hydropower generation i). High head development ii).…

A: Hydropower : The energy we produce from running water or water falling from height is called…

Q: A projectile is launched at an angle of 45 degrees from the top of a 100 m tall cliff at 50 m/s.…

A: Calculate the initial vertical component of the speed of the object. Vy = 50sin45     = 35.4 m/s…

Q: A proposed hydropower plant to be built using a reservoir with a typical head of 18m and estimated…

A:

Q: What is the actual power generated in KW bya Tidal power plant if it has 62.35 % efficiency and if…

A:

Q: A group of engineers is designing a new hydroturbine by scaling up an existing one. The existing…

A: DA = 1.50 m nA = 150 rpm VA = 162 m3 /s HA = 90.0 m bhpA = 132 MW nB = 120 rpm HB = 110 m ρ = 998…

Q: A jet engine on an airplane moving at 950 km/hr has an exit area of 0.5 m². If gas exiting the…

A:

Q: A 30 cm pipe carrying water, branches into two pipes of 20 cm and 15 cm diameter. If mean velocity…

A:

Q: Water flows over a waterfall 328 Ft in height. Take 2.204 lb of the water as the syste and assume…

A:

Q: A turbine extracts water from a 25 m high reservoir, if the flow requirement is 10000 m3/hr, what is…

A:

Q: A tank is full of water. Find the work W required to pump the water out of the spout. (Use 9.8 m/s2…

A: Consider following given figure.Acceleration due to gravity = Density of water = To find: The work W…

Q: what is the minimum water flow in (kg/sce)

A: Need to find minimum mass flow rate of water required (m).

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.