A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to the atmosphere. The water level is 3 m above the outlet. The tank air pressure above the water level is 300 kPa (absolute) while the atmospheric pressure is 100 kPa. Neglecting frictional effects, determine the initial discharge rate of water from the tank

Q: well water is pumped into a thank that is 25 meters high through a pipe with an inner diameter of…

A: Given data:

Q: A pump takes water at 60°F from a large reservoir and delivers it to the bottom of an open elevated…

A: (i) To find: The datum ZZ2-Z1. Calculation: The image shown below: Here, point a is at the datum…

Q: Water is flowing into a factory in a horizontal pipe with a radius of 0.0223 m at ground level. This…

A:

Q: A pressurized tank of water has a 10-cm diameter orifice at the side bottom corner of the tank,…

A: Let us consider that the free surface of water as point 1 and the exit of the orifice to the…

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: A 4 m in diameter tank open to the atmosphere is filled with water to a height of 400 cm from the…

A:

Q: A fluid flows at 455 m3 per min inside a rectangular duct, whose cross-section has a length of 150…

A: Given data: Q=455 m3/min=7.5833 m3/secL=150 mw=85 cm Need to determine the average velocity of the…

Q: Water enters a hydraulic turbine through a 30-cm-diameter pipe at a rate of 0.7 m3/s and exits…

A: The given data is shown in the following attached image:

Q: A water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for…

A:

Q: A compressor draws in 0.25 m/s of air whose density is 1.26 kg/m³ and discharges it with a density…

A:

Q: Air is flowing through a horizontal variable area pipe at a constant rate of 0.03 m^3/s.…

A: The pressure drop between two sections is  746.86 Pa or 0.74686 kPa.

Q: The water level in a tank is 12 m above the ground. A hose is connected to the bottom of the tank,…

A:

Q: Through a duct air enters a fan at 6.3 m/s and an inlet static pressure 2.5 cm of water less than…

A: Solution is attached below:

Q: There is a storage tank with a height of 5 m. Initially the tank is empty. The cross- sectional area…

A: Write the given data. Qin=1 m3/sQout=0.2 m3/sq=h

Q: Water enters a hydraulic turbine through a 35-cm-diameter pipe at a rate of 0.8 m3/s and exits…

A: Bernoulli's equation relates the pressure energy, kinetic energy and potential energy of a fluid…

Q: Water flows through a circular tube with a constant diameter at a constant flow rate. The outlet is…

A:

Q: Include a free body diagram  A water initially contains 140 L of water. Now equal rates of cold and…

A:

Q: A venturi meter is placed in a pipe to measure the flow of oil with a specific gravity (SG) of 0.9…

A:

Q: Here, air (105 kPa) at 37 degrees celcius is flowing upward in a 6cm diamater inclined duct, at a…

A:

Q: A fan delivers 400 m3 /min of air at 1 atm and 21 C when rotating at 600 rpm, with a head of 8 cm…

A: The volumetric flow rate of the air, V = 400 m3/min The pressure of the air, P = 1 atm The…

Q: Water vapor, whose pressure is 650 kPa and temperature 573 K, enters a well-insulated device at a…

A: Initial pressure of vapor(P1) = 650 KPaFinal pressure of vapor(P2 ) =  130 KPaInitial temperature of…

Q: A boy has a tank with a rectangular bottom base 40 cm by 50 cm and a height of 100 cm. The tank is…

A: Given: V=40 cm × 50 cm×100 cma = 3 mm=0.3 cmQin=0.05 L/s = 50 cm3/s To find: Depth of water in the…

Q: A fluid flows at 455 cubic meters per minute inside a rectangular duct, whose cross-section has a…

A:

Q: hat are the main factors affecting on the impact test? And, How?

A: given:

Q: Air flows through a pipe at a flow rate of 100L/s. At the entrance, the diameter of the pipe is 10cm…

A: The velocity of the air at the inlet pipe is

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: Consider incompressible, frictionless flow of water in a vertical piping. The pressure is 260 kPa at…

A: Solution: Given Data: P1=260 kPah1=2 mh2=17 mv1=v2   To Find: The pressure at 17 m from the ground…

Q: diameter tube at a rate of 0.6 m3/s and leaves through a 25 cm diameter tube. cm in diameter With a…

A:

Q: A frictionless circular piston of area 10-<m² and mass 100 kg sinks into a cylindrical container of…

A:

Q: A fan is used to extract 140m3 air per minute from a large room. A circular duct of diameter 0.53 m…

A: Given Q=140 m3/min; D1=D2=0.53; D3=0.8m h=6mm To Find: static and stagnation pressure upstream and…

Q: Water is flowing through a venturi meter whose diameter is 7 cm at the entrance part and 4 cm at the…

A:

Q: In a certain application, a siphon must go over a high wall. Can water or oil with a specific…

A: If the pressure at the topmost point falls below the vapor pressure the corresponding fluid then…

Q: maximum height t«

A: kindly refer attached file

Q: 1- Is there an acceleration for fluid particles in a steady flow? Explain your answer by sketch if…

A: According to our guidelines we are supposed to answer the first question as they are not linked.…

Q: A 6cm diameter horizontal water pipe expands to a 10cm diameter pipe. The average velocity and…

A: Given Data D1=6 cm D2=10 cm V1=7 m/s P1=150 kPa

Q: 1. The water in an 8-m-diameter, 3-m-high above-ground swimming pool is to be emptied by unplugging…

A:

Q: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to…

A: In order to proceed with the given problem, the following assumptions need to be taken into…

Q: 6. Water enters a hydraulic turbine through a 25-cm diameter pipe at a rate of 0.6 m³/s and exits…

A: Given:Pipe diameter upstream to the turbine, D1=25 cm=0.25 mWater flow rate, Q=0.6 m3/sPipe diameter…

Q: I am studying for an exam this week, and I want to check my steps and answers for this one problem.…

A: given:ρ1=2.21kg/m3ρ2=90kg/m3v1=40m/sv2=180m/sinlet area A1=90cm2

Q: not an assingment or assesed question its a tutorial

A: Step 1: To solve this problem, we can use the principle of conservation of momentum for steady,…